IBM 656234U - PC 300 PL Support and Manuals
Get Help and Manuals for this IBM item
Popular IBM 656234U Manual Pages
Technical Reference - Page 5
...
© Copyright IBM Corp. 1997
iii Contents
Preface v Manual Style v Related Publications vi
Chapter 1. System Overview 1 Hardware Features 1 Software Features 3
System Software 3 BIOS 3 Plug and Play 3 POST 4 Configuration/Setup Utility Program 4 Advanced Power Management 4 Flash Update Utility Program 4 Diagnostic Programs 5
Device Drivers 5 Operating System Support 5
Chapter...
Technical Reference - Page 10
... 000). Depending on the IBM PC 300PL (Types 6562 and 6592).
No sign in cases where differences between the two computer types must be changed . The manual, which is intended for ...of reserved areas can cause compatibility problems, loss of the letter "h" indicates a hexadecimal number. Also, when numerical modifiers such as PC 300PL computers throughout this manual, the use of data, or...
Technical Reference - Page 11
..., contact an IBM reseller or IBM marketing representative. Installing Options in Your PC 300PL (Type 6562) Installing Options in Your PC 300PL (Type 6592) These publications contain instructions for operation. About Your Software This publication (provided only with computer models that have an IBM-installed SCSI adapter, includes information on how to the "Getting Help, Service, and...
Technical Reference - Page 13
...-watt power supply. Upgrade connectors for additional 2 MB of system memory Busmaster IDE controller EIDE or Ultra Wide SCSI hard disk drive CD-ROM drive (some PC 300PL computers models).
© Copyright IBM Corp. 1997
1 DMI (Desktop Management Interface) BIOS and DMI software - Refer to "Riser Card" on startup sequence - Support for VESA interface and...
Technical Reference - Page 14
... PC 300PL computers. PC 300PL (Type 6562): Four drive bays, four expansion slots (one ISA, two PCI, and one shared ISA/PCI) - PC 300PL (Type 6592): Six drive bays, six expansion slots (three ISA and three PCI)
Several model variations are available with or without a CD-ROM drive preinstalled.
2 Technical Information Manual Chapter 1. System...
Technical Reference - Page 15
... (Version 1.2) ISA Plug and Play BIOS Specification, Errata and Clarifications (Version 1.0), as released by Microsoft
Chapter 1. Support is provided for Japanese systems only) Wake on self-test (POST) Configuration/Setup Utility program Advanced Power Management (APM) Flash update utility program Diagnostic programs
BIOS
PC 300PL computers have an IBM BIOS. Chapter 1. System Software
System...
Technical Reference - Page 16
... error occurs while POST is available on the Configuration/Setup Utility program. For more information on self-test (POST) software with initialization code added for DOS and Windows
POST
PC 300PL computers use IBM power-on APM, refer to Using Your PC 300PL (Type 6562) or Using Your PC 300PL (Type 6592). PC 300PL computers also support BIOS updating...
Technical Reference - Page 17
... device driver support for a detailed description of software preinstalled. Also, a Ready-to-Configure (RTC) CD-ROM is included with PC 300PL computers, refer to About Your Software for the preinstalled operating system (if applicable), and several operating systems. The device drivers are preinstalled in models that come with device drivers to Using Your PC 300PL (Type 6562...
Technical Reference - Page 18
... V) voltages. The microprocessor plugs into 16 KB write-through code cache and 16 KB write-back data cache) Fractional bus speed (selectable at http://www.intel.com. For information on replacing a microprocessor or installing an upgrade, refer to -ISA Bridge" on page 24. Chip Set Control
PC 300PL computers use the second-generation Intel 82430HX chip...
Technical Reference - Page 24
...
3 ECP/EPP mode only.
12 Technical Information Manual Support for serial port 1 is set to change during POST. Table 4. System Resource ...setting for extended capabilities port (ECP), enhanced parallel port (EPP), and standard parallel port (SPP) modes is determined at boot time via the Configuration/Setup Utility program and can be altered by changing setup and rebooting the computer...
Technical Reference - Page 26
... typical system resource assignments for specific functions and are subject to 16 general-purpose input/output (GPIO) pins which are maintained by the user. The clock settings are supported by 2 GPIO ports. System Board Features
General-Purpose I /O Address (Hex)
0070, bits 6:0 (address) 0071 (data)
IRQ
8
DMA
None
When the computer is started, the resource...
Technical Reference - Page 28
... I2C support Local peripheral bus (LPB)
In PC 300PL computers, the video subsystem connects to the computer, the monitor will automatically be set to (MGABASE3+7FFFFF) (8 MB pseudo-DMA window) MGABASE1 is started, the resource assignments are subject to change during POST and the refresh rates will be detected during POST.
16 Technical Information Manual...
Technical Reference - Page 29
... requesting specification of Mystique or Millennium, specify Mystique.) Note: Video device drivers have already been installed in several types of SGRAM memory can be changed when an upgrade video adapter is detected by the upgrade daughtercard.
System Board Features 17 Note: The Matrox MGA-1164SG 3D video subsystem supports a maximum of the upgrades follow. The upgrade provides...
Technical Reference - Page 30
...
18 Technical Information Manual
For information on ...installed. (The power supply does not provide enough AUX5 current to power both the system board Ethernet and a Wake on the system board, which is started, the resource assignments are subject to PC 300PL computers must be disabled in the Configuration/Setup Utility program. The following :
IEEE 802.3 compliance, 10 and 100 Mbps Support...
Technical Reference - Page 68
...
178
Riser card or system board error
183
Administrator password has been set and must be entered
184
Password removed due to checksum error
185
Corrupted boot sequence
186
System board or hardware security error
189
More than three password attempts were made to access system
56 Technical Information Manual POST Error Codes
Code
Description
101
Interrupt failure
102
Timer...
IBM 656234U Reviews
We have not received any reviews for IBM yet.