Husqvarna PZ5426FX Support and Manuals
Get Help and Manuals for this Husqvarna item
View All Support Options Below
Free Husqvarna PZ5426FX manuals!
Problems with Husqvarna PZ5426FX?
Ask a Question
Free Husqvarna PZ5426FX manuals!
Problems with Husqvarna PZ5426FX?
Ask a Question
Popular Husqvarna PZ5426FX Manual Pages
Owners Manual - Page 5
...service.
INTRODUCTION
Congratulations
Thank you for more information. This machine is transported, you sell your dealer for purchasing a Husqvarna ride-on public roads. A control panel easily accessible to the operator and a hydrostatic transmission regulated by steering controls both contribute to rapidly mow primarily large areas. This manual is equipped with these instructions...
Owners Manual - Page 6
... states: • The engine's model. • The engine's type. • Code Please have a barcode decal affixed at the rear.
6
Engine
Transmission When you as a customer receive only the best support and service. This ensures that you need spare parts or support in service questions, warranty issues, etc., please consult the following professional:
This manual belongs to the machine...
Owners Manual - Page 9
...000
9 Always turn off blades, set parking brake, stop engine, and remove keys before dismounting.
0000-000
Read the operator's manual before starting .
• It is only intended for your safety. SAFETY
Safety Instructions
These instructions are for use by the blades... or accident.
• Do not put hands or feet near rotating parts or under the machine. WARNING! It concerns your safety.
Owners Manual - Page 14
...'s recommended parts, when necessary.
• Mower blades are considered to be driven with overly high engine speeds. Repair, if ...settings of grass, leaves, or other reproductive system damage. Wrap the blade or wear gloves, and use extra caution when servicing ... in the battery. Adjust and service as required.
• Maintain or replace safety and instruction labels, as necessary.
•...
Owners Manual - Page 17
... • Read machine's operator manual before each
use park brake. • If any part of the muffler. no jerky turns,
starts or stops. • When mower is stopped, set brakes securely and
use . &#...• Watch where you are going, especially at row
ends, on usage and conditions. Replace screen and reattach the tail pipe, orienting the tail pipe either horizontally or upwards, away from...
Owners Manual - Page 26
...first operating the mower or until the mower stops or slows dramatically. OPERATION
Read the Safety Instructions section and the following pages if you are unfamiliar with controls, use a reduced throttle speed...that direction.
DO NOT move the mower under its own power, the operator must be reviewed in the Operation section), adjust engine speed to start engine (see Before Starting in ...
Owners Manual - Page 38
... once each year
Maintenance interval in this manual
■ = Refer to the engine manufacturer's manual
38 When operating with a heavy load or at high ambient temperatures, replace every 50 hours. 2) In dusty conditions, cleaning and replacement are required more often. 3) Performed by authorized service workshop.
● = Described in this manual ♦ = Not described in hours
50...
Owners Manual - Page 39
... wire where it
cannot come in contact with a heavy load or at high ambient temperatures, replace every 50 hours. 2) In dusty conditions, cleaning and replacement are required more often. 3) Performed by authorized service workshop.
● = Described in this manual ♦ = Not described in hours
50
250
500
■
●
■
■
■
●
■...
Owners Manual - Page 40
...Install new battery with a maintenance free battery and does not need servicing...installation
8065-020 Using two ½" wrenches disconnect BLACK battery cable then RED battery cable. 4. STANDARD BATTERY
12.6V 12.4V 12.2V 12.0V 11.8V
STATE OF
CHARGE
100% 75% 50% 25% 0%
APPROXIMATE BATTERY CHARGING TIME* TO FULL CHARGE AT 80OF / 27OC Maximum Rate at the same time. For replacing...
supported...
Owners Manual - Page 45
.... Reinstall the deck belt. (See Deck Belt Installation in this section of the manual). 2. Wrap the belt around the right pump pulley. 5.
Belt tension should be set to slip from the engine and pump pulleys. ...shift the arm to access the belt. 3. Pump Belt
The belts are not adjustable. Replacing Pump Belt Park the mower on both mandrel housings
and secure with the breaker bar, ...
Owners Manual - Page 48
...hours. Tighten caster bolt. Torque to support the deck. Pull the wheel out of the fork. Caster bolt 2. Deck Lift Spring When mowing 2" or lower, it may be set in three positions: • Upper ...adjusted to the dealer for service. NOTE: Tire should rotate freely but axle spacers should not. If wheels do not rotate freely take the unit to support the deck. IMPORTANT INFORMATION ...
Owners Manual - Page 56
... It is evenly distributed and then refit the spark plug.
6. Never use genuine Husqvarna spare parts. Use a degreaser and warm water. To ready the machine for extra protection. ...axles.
7. Remove the battery. Service
When ordering spare parts, please specify the purchase year, model, type, and serial number.
Always use gasoline for worn or damaged parts and tighten any nuts or screws...
Owners Manual - Page 58
Actual power output for the engine model measured to SAE standard J1349/ISO1585. Mass production engines may differ .../h Disc 13 x 6.5 Flat Free 23 x 10.50 4 ply 15 PSI / 103 kPa / 1 bar
1) See the Engine Manufacturer's manual for engine specifications.
2) The power rating of the engines indicated is the average net power output (at specified rpm) of a typical production engine for the engine...
Parts Manual - Page 2
... spare parts or support in U.S.A.
Printed in service questions, warranty issues, etc., please consult the following professional:
This Parts Manual belongs to the machine with the manufacturing number:
Engine
Transmission
Manufacturing Number
The machine's manufacturing number can be found on the printed plate affixed to the engine compartment. The plate states:
• The engine's model...
Parts Manual - Page 31
...20.. 574 825901 1 DECAL, SERVICE 21.. 532 424102 1 DECAL,...DECAL, PZ5430
NOTE: Decals used and decal placement will vary depending on model.
31 QTY.
DECALS
ITEM PART NO. QTY.
DESCRIPTION
1.. 539 105745 1 DECAL, BATTERY WARNING 2.. ...532 428676 1 EMBLEM, CROWN H SM 14.. 532 429196 2 EMBLEM, HUSQVARNA 15.. 574 437301 1 DECAL, BELT ROUTE 16.. 574 569401 1 DECAL, FUSE ...
Husqvarna PZ5426FX Reviews
We have not received any reviews for Husqvarna yet.