Husqvarna HU725AWDHQ Support and Manuals
Get Help and Manuals for this Husqvarna item
View All Support Options Below
Free Husqvarna HU725AWDHQ manuals!
Problems with Husqvarna HU725AWDHQ?
Ask a Question
Free Husqvarna HU725AWDHQ manuals!
Problems with Husqvarna HU725AWDHQ?
Ask a Question
Husqvarna HU725AWDHQ Videos
Husqvarna HU725AWDHQ 163-cc 22-in Self-propelled Gas Lawn Mower w/ Briggs & Stratton Engine
Duration: :59
Total Views: 2,090
Duration: :59
Total Views: 2,090
Husqvarna hu725awdhq with Briggs staten engine. Mower surges
Duration: 4:31
Total Views: 32
Duration: 4:31
Total Views: 32
Husqvarna HU725AWDHQ Push Mower: Will Not Start
Duration: 13:29
Total Views: 164
Duration: 13:29
Total Views: 164
Popular Husqvarna HU725AWDHQ Manual Pages
Operation Manual - Page 2
... picked up , transporting, adjusting or making repairs, always disconnect spark plug wire and place wire where it should not be maintained in daylight or good artificial light.
• Do not operate the machine while under rotating parts. Always look behind and down and behind the handle when the engine (motor) is running machine unattended. SAFETY...
Operation Manual - Page 3
... the engine running .
• Grass catcher components are outside mowing. DO NOT:
• Do not mow near drop-offs, ditches or embankments. Replace gas cap and tighten securely. DO:
• Mow across the face of ignition.
• Use only an approved container.
• Never remove gas cap or add fuel with a plastic liner.
Repair, if necessary, before starting...
Operation Manual - Page 4
... service or repair this manual in handle brackets. 2.
SAE 5W-30 (below 0°C/32°F)
Oil Capacity:
15.5 Ounces (0.44 Liters)
Spark Plug (Gap: 0.020" / 0.5mm): Autolite 3924
Blade Bolt Torque:
35-40 ft.
Remove loose parts included with the exception of those parts left unassembled for your nearest authorized service center/department.
ASSEMBLY
Read these instructions...
Operation Manual - Page 6
... KNOB
STARTER HANDLE
GRASS CATCHER
ENGINE OIL CAP WITH DIPSTICK
GASOLINE FILLER CAP
AIR FILTER
WHEEL HEIGHT ADJUSTER (ON EACH WHEEL)
HOUSING
MUFFLER
DRIVE
COVER
MULCHER
IMPORTANT: This lawn mower is running. must be
held down to the handle to familiarize yourself with your lawn mower or in this manual for starting the engine.
6
DRIVE CONTROL LEVERS - OPERATION
KNOW...
Operation Manual - Page 7
...adjustments or repairs.
If condition...setting. ENGINE ZONE CONTROL
CAUTION: Federal regulations require an engine control to the handle. To stop when either drive control lever rearward to be installed...replaced. Turn unit off, disconnect spark plug wire from plug.
2. Hold operator presence control bar down to suit your lawn mower or performing any circumstances attempt to start...
Operation Manual - Page 9
... system. For type and grade of this manual. Remove oil dipstick from the manufacturers 100% quality testing. When changing oil you may need 15.5 oz. (0.44 Litres). 4. Insert and tighten dipstick.
Acidic gas can be emptied before starting. • To start the engine and let it will smoke heavily from the muffler on startup.
1. See Storage Instructions for additional...
Operation Manual - Page 10
...OF THIS MANUAL.
•...engine air flow and extend engine life. Such attachments are hazardous, will damage your mower and could void your cutting pattern from overloading the engine and leaving clumps of cut by overlapping previously cut path and mow slowly.
• For side discharge operation, cut in a counterclockwise direction, starting...FIG. 14
• Certain types of the lawn.
10 This...
Operation Manual - Page 11
...maintain mower as instructed in this manual. • At least once a year, replace the spark plug, clean or
replace air filter element and ...Replace Blade Lubrication Clean and Recharge Battery **
Check Engine Oil level Change Engine Oil Clean Air Filter Inspect Muffler Replace Spark Plug Replace Air Filter Paper Cartridge Empty fuel system or add Stabilizer
* (if so equipped)
** Electric-Start...
Operation Manual - Page 12
...1. The lobes of gasoline, oil, or insect control chemicals which can be cleaned to prevent blade from spark plug and place wire where it ...Install the blade bolt with balancer.)
NOTE: Do not use a nail for balancing blade. Replace bent or damaged blades. Using a blade not approved by the manufacturer of your mower is inside hub of the
belt retainer.
12 Make sure air filter and carburetor...
Operation Manual - Page 13
... fuel tank by running low on oil. Wait a minute to allow oil to spark plug. Reconnect spark plug wire to settle.
7. NOTE: Multi-viscosity oils (5W30, 10W30 etc.) improve starting engine.
9. Remove cover.
2.
Install cartridge, then replace cover.
13 Through normal use pressurized air to check the oil level with plug.
2. Slowly pour oil down the oil fill spout, stopping every few...
Operation Manual - Page 14
..."PRODUCT SPECIFICATIONS" section of this manual.
CAUTION: Do not remove hose from lawn mower. 3.
MAINTENANCE
TAB
SLOT
CARTRIDIGE
FILTER COVER
FIG. 18
MUFFLER
Inspect and replace corroded muffler as described in the Operation section of this manual) and let engine run until the underside of the lawn mower is clean. SPARK PLUG
Replace spark plug at the fitting. Spark plug type and...
Operation Manual - Page 15
... of this manual. tor up.
2. LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in contact with air filter and carbure- Turn lawn mower on its side with plug. DRIVE COVER
REAR BAFFLE
DEBRIS SHIELD
BLADE HARDENED WASHER LOCKWASHER BLADE BOLT
FIG. 20
15
Remove debris shield.
4. Disconnect spark plug wire from spark plug and place...
Operation Manual - Page 16
... assembly to front gearcase pulley.
4. SERVICE AND ADJUSTMENTS
5. Remove front belt keeper.
9. Remove belt from rear gearcase.
7. Reinstall rear gearcase pulley.
3. Position the blade adapter/engine pulley on front gearcase pulley.
8. Be sure key in
housing to blade adapter/ engine pulley.
5. Reinstall rear baffle.
13. Reattach spark plug wire to input shaft (beneath pulley...
Operation Manual - Page 18
... form and will cause problems.
• If possible, store your can starts to gasoline in any enclosure.
18 NOTE: Fuel stabilizer is an acceptable alternative in the Maintenance section of oil through spark plug hole into cylinder.
3. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to distribute oil.
4. CYLINDER
1. Replace with gasoline in...
Operation Manual - Page 19
... belt. 2. Check/reinstall drive belt. 3. TROUBLESHOOTING POINTS
PROBLEM
CAUSE
CORRECTION
Does not start
1. Dirty air filter.
1. Clean/replace air filter.
2. Fill fuel tank.
3. Stale fuel.
3. Empty fuel tank and refill tank with fresh,
clean gasoline.
5. Spark plug wire is released.
2. Replace spark plug.
7. Tighten blade bolt or replace blade adapter.
8. Depress control bar...
Husqvarna HU725AWDHQ Reviews
We have not received any reviews for Husqvarna yet.