Hoover U8161 Support and Manuals
Get Help and Manuals for this Hoover item
View All Support Options Below
Free Hoover U8161 manuals!
Problems with Hoover U8161?
Ask a Question
Free Hoover U8161 manuals!
Problems with Hoover U8161?
Ask a Question
Most Recent Hoover U8161 Questions
Hoover Wind Tunnel M-8161-900 Does Not Turn On. Dead.
(Posted by Yangtzeinc 10 years ago)
Vacuum In Good Condition. But It Does Not Turn On. Dead.
(Posted by Yangtzeinc 10 years ago)
Popular Hoover U8161 Manual Pages
Manual - Page 1
TM
Upright Vacuum Cleaner
by HOOVER
Owner's Manual
ENGLISH § pp.1-12 ESPAÑOL § pág. 14-21 FRANÇAIS § p. 23-30
Thank you for easy assembly (see page 3)
www.hoover.com
®
This product was designed for your purchase!
Manual - Page 2
...™ Switch 5 If You Have a Problem 11 Clearing Blockages 12 Important Safeguards 2 Lubrication 11 Maintenance Authorized Service 12 Cleaning filter 8 Emptying Dirt Cup 7 Replacing Powered Hand Tool
Agitator Brush Roll 10 Replacing Power Hand Tool Belt ..10 Replacing Edge Groomers 9 Replacing Headlight 9 Thermal Protector 11 Warranty 12
© 2004 The Hoover Company www.hoover.com...
Manual - Page 3
... an automated referral of service outlet locations (U.S. Click on the "Service" button to find the service outlet nearest you need any assistance:
Visit our website at www.hoover.com. only) OR
...from handle section. Hose E.
Slide handle section onto back of packing materials.
Find the parts shown above before disposing of handle. Please do not return this product to speak with a...
Manual - Page 4
... rugs. (Brush rolls will automatically turn off during assembly, make sure switch is raised to correct setting for easy cord release.
21. Unplug the cleaner. If label has come off . Extension wand
13. lever to lower handle to install the proper outlet. CARPET setting -
HEPA cartridge filter 21 11.
If it still does not...
Manual - Page 5
... carrying handle to remove dirt in carpet near baseboards and furniture. Settings
For maximum cleaning performance, the following carpet height settings are provided on one end of your cleaner has three positions;
...of cleaner) and will prevent rug from clinging to edge of nozzle parallel to cleaner. Guide either side of carpet or furniture. This will lift up nozzle so that when you...
Manual - Page 6
... nozzle may be used for extra reach with a "breakaway" feature which allows it to snap free if it at additional cost)
Push Custom Control™ switch to top. Powered hand tool may be used for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, baseboards, shutters, and registers. I
2-13
2-11...
Manual - Page 7
...assembly consists of the dirt cup. This larger debris will ensure continued cleaning effectiveness. Replace cup - CAUTION: Very fine materials, such as face powder or cornstarch, may... dirt cup.
Empty cup - Tap side of cup until cup locks in the left side of the following parts: Lid (A) Dirt Cup (B) Pre-filter (C) HEPA Cartridge Filter (D) Dirt Opening (E) Handle (F)
While the cleaner...
Manual - Page 8
...and hand wash it .
Tapping the side of dirt cup. The filter assembly can be removed for HOOVER part No. 40110009. Grasp pre-filter frame and pull up on pre-filter frame with mild detergent. Remove... to empty dirt cup" should sufficiently remove dust and fine particles from assembly.
Replace lid and return cup to empty dirt cup."
Snap closed.
Do not operate cleaner without the filter ...
Manual - Page 9
...
Remove lens -
Lift lens off both sides of cleaner. Headlight replacement
What to buy
When purchasing edge groomers, ask for HOOVER part No. 39511009.
Disconnect cleaner from electrical outlet. Place one tab (L) on bottom of the nozzle, should be installed at your nearest Hoover Factory Service Center.
3-19
The edge groomers
When to lowest position.
Insert...
Manual - Page 10
... the belt
The powered hand tool belt is designed to make sure it is not normally replaced. Turn agitator, to last a long time and is in guard. Replace belt
When replacing belt, ask for HOOVER part No. 48414088.
3-21
A
3-22
B
2. Remove bottom plate, belt guard and brush roll as described in Figs. 3-21 through 3-23...
Manual - Page 11
... turbine channel • Remove blockage. • Broken or worn belt • Replace belt • Low cleaner suction • Check items under "Cleaner won 't turn on BARE FLOOR position.
• Set switch to carpet position
• Agitators are obstructed. • Clear obstruction
Problem: Cleaner won 't turn
Possible cause Possible solution • Too much pressure being...
Manual - Page 12
...
1. Remove bottom plate, belt guard and turbine as described in duct (A). 3. Service
To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot) by the complete model number when requesting information or ordering parts. (The model number appears on the back of purchase will only result in...
Hoover U8161 Reviews
We have not received any reviews for Hoover yet.