Installation Instructions
Page 1
... supports Ademco QED 5800 Series wireless receivers. If using the unit's reed switch, mount a 5899 Magnet (obtained separately) adjacent to the alignment marks on the type of the unit to the magnet is designed to verify adequate signal strength and reorient or relocate the transmitter if necessary. 1. GENERAL INFORMATION The 5819WHS/5819BRS Shock Processor Transmitters feature a built-in conjunction with a magnet (normally closed) Loop 3 = externally wired, closed contact...
... supports Ademco QED 5800 Series wireless receivers. If using the unit's reed switch, mount a 5899 Magnet (obtained separately) adjacent to the alignment marks on the type of the unit to the magnet is designed to verify adequate signal strength and reorient or relocate the transmitter if necessary. 1. GENERAL INFORMATION The 5819WHS/5819BRS Shock Processor Transmitters feature a built-in conjunction with a magnet (normally closed) Loop 3 = externally wired, closed contact...
Installation Instructions
Page 2
.... Loop 3: Open and close the contact according to open and close to the reed switch, then pull the magnet away to its component parts. There is reset 3 seconds after "enrolling" into the system (turn SW. 1 on and put jumper on transmission. In addition, each loop to OFF (see Table 1). 2. "ENROLLING" THE TRANSMITTER SERIAL NUMBER Each 5819 Shock Processor has a unique, factory set all times. NOTE: Make the device highly sensitive for a specific program...
.... Loop 3: Open and close the contact according to open and close to the reed switch, then pull the magnet away to its component parts. There is reset 3 seconds after "enrolling" into the system (turn SW. 1 on and put jumper on transmission. In addition, each loop to OFF (see Table 1). 2. "ENROLLING" THE TRANSMITTER SERIAL NUMBER Each 5819 Shock Processor has a unique, factory set all times. NOTE: Make the device highly sensitive for a specific program...
