Hitachi WH14DMR - Cordless Impact Driver 14.4 Volt Support and Manuals
Get Help and Manuals for this Hitachi item
View All Support Options Below
Free Hitachi WH14DMR manuals!
Problems with Hitachi WH14DMR?
Ask a Question
Free Hitachi WH14DMR manuals!
Problems with Hitachi WH14DMR?
Ask a Question
Popular Hitachi WH14DMR Manual Pages
Instruction Manual - Page 2
M
N
O
N
.,
ML
Q R
S
English
IMPORTANT SAFETY INFORMATION Read and understand all of the safety precautions, warnings and operating instructions in the Instruction Manual before operating or maintaining this power tool. 3 1
R
3 24
1 5
C
D
24 5 L D
6
9 8 7
5 4
E 3
2
(B)
(A)
1
0 AB
3
H
F
J E I P
3mm 11.5mm
G
E
K
,.
Instruction Manual - Page 3
...support the workpiece to prevent bodily injury or machine damage are identified by WARNINGS on . Electrical Safety (1) A battery operated tool with your work by HITACHI... must be repaired. (4) Disconnect battery pack from moving parts. (3) Avoid...INSTRUCTIONS
1. Dust mask, non-skid safety shoes, hard hat, or hearing protection must be recharged only with specifically designed battery...
Instruction Manual - Page 4
... or other reproductive harm.
Never use a tool which have the tool serviced before resuming operation of the tool.
4.
Should a power tool be deformed, cracked, or damaged.
13. Do not wipe plastic parts with such solvents. IMPORTANT SAFETY INSTRUCTIONS FOR USE OF THE CORDLESS IMPACT DRIVER / WRENCH
WARNING: Death or serious bodily injury could result in a well...
Instruction Manual - Page 5
... when service or repair is to or greater than
but less than those of damage to electric plug and cord, pull by the voltage rating-for any maintenance or cleaning. That extension cord is properly wired and in this impact driver in a risk of injury, charge HITACHI rechargeable battery type EB7, EB9, EB12, EB14, EB18 series.
replace...
Instruction Manual - Page 6
... specific charger. x x
0.7 lbs. (0.3 kg)
All charge times are approximate. OTHER TYPES OF BATTERIES MAY BURST AND CAUSE INJURY! NEVER 3. NEVER 4. ALWAYS 14. charge when the temperature is completely worn out. wait at least 15 minutes between charges to charge. NEVER operate, or attempt any maintenance on your own power tool. Cordless Impact Driver
Model
WH9DMR
WH12DMR
WH14DMR...
Instruction Manual - Page 7
... tool handle and slip it may
also cause problems in the charger such as shown in the table below, and batteries that have become hot
Rechargeable batteries
Temperatures at which the battery can be cooled for 0.1 seconds)
Malfunction in the battery or the charger. Make sure it repaired immediately. 2.
Does not light for 0.5 seconds. (off for...
Instruction Manual - Page 8
... can be installed on the right or left side and the angle can be used , the battery charger will be damaged and its battery. Connect the...battery into the charger Insert the battery into the battery charger. About 60 minutes is warm due to battery use . (2) Switching the hook position
When you in case of the failures. Remove the battery from the battery charger Supporting the battery...
Instruction Manual - Page 9
... the indentation in eye injury.
1.3 Replacing the batteries (1) Loosen the hook screw J with each other side and securely fasten with normal trash and do the opposite point on the anvil B. Removing the bit (Impact driver) Please do not throw batteries into the hexagonal hole in the anvil 8. (3) Release the guide sleeve 7 and it returns to turn...
Instruction Manual - Page 10
... not be transmitted to be switched while the impact driver is started again immediately after continuous work After use for a long time.
(3) Diameter of the nuts or bolts. Use a tightening time suitable for the screw The appropriate torque for 15 minutes or so when replacing the battery. Use the correct operating time for a small...
Instruction Manual - Page 11
... be checked regularly. Exercise due care to the bolt will eventually require servicing or replacement of parts because of wear from normal use a driver bit of the socket (Impact wrench) A worn or deformed hex. Then push it with soapy water. Disposal of the exhausted battery
WARNING: Do not dispose of children. 10. The product that the...
Parts List - Page 1
Hitachi Power Tools
LIST NO. G829
ELECTRIC TOOL PARTS LIST
CORDLESS IMPACT DRIVER Model WH 14DMR
2005 • 7 • 8 (E1)
1 2 3 4 5 6
21 22 23 24 25
501
501
502
7 8 9 10 11
26
12 13 14 15
27 28 29 30 31 32
16 17
18 19 20
33 34
37
35
39 38
37
36
44
46 45 33
47 41 40
43 42
Parts List - Page 2
... SCREW (W/FLANGE) D4X20 (BLACK) 8
34
NAME PLATE
1
35 324-237 HOUSING (A).(B) SET
1
36 324-513 HITACHI PLATE
1
37 994-532 MACHINE SCREW (W/SP. PARTS
ITEM NO. CODE NO.
1 315-984
DESCRIPTION RETAINING RING
NO. USED
1
REMARKS
2 315-983 WASHER (D)
1
3 321-657 GUIDE SPRING (A)
1
4 322-717 GUIDE SLEEVE (D)
1
5 324-238 FRONT CAP (C)
1
6 324-239 PROTECTOR (D)
1
7 307-851...
Parts List - Page 3
... CHUCK AND ADAPTER SET
1 INCLUD. 616, 618
602 309-922 GREASE FOR IMPACT DRIVER (500G)
1
603 992-671 + DRIVER BIT (B) NO. 2 50L
1
604 992-672 + DRIVER BIT (B) NO. 3 50L
1
605 996-177 NON-MAGNETIC HEX. SOCKET 19MM 65L 1
614 996-197 HEX. SOCKET 15MM 65L 1
611 996-181 NON-MAGNETIC HEX. USED
1
1 1
REMARKS
WH 14DMR
OPTIONAL ACCESSORIES...
Parts List - Page 4
Printed in Japan 7 -- 05 (050708N) DESCRIPTION
NO. USED
REMARKS
WH 14DMR
--- 4 --- ITEM NO. CODE NO.
Hitachi WH14DMR Reviews
We have not received any reviews for Hitachi yet.