HP rp4410 Support and Manuals
Get Help and Manuals for this Hewlett-Packard item
Popular HP rp4410 Manual Pages
HP DLPI Programmer's Guide - Page 11
... receive the updated or new editions, you should subscribe to correct errors or document product changes. Table 1 shows the releases available for details. Table 1
HP-UX 11i Releases
Release Identifier
Release Name
Supported Processor Architecture
B.11.11 B.11.20
HP-UX 11i v1 HP-UX 11i v1.5
HP 9000 HP Integrity
11 The document printing date and part number indicate...
HP DLPI Programmer's Guide - Page 131
... not supported by the callee, DL_CONNECT_CON is unchanged. DL_SYSERR
A system error has occurred and the UNIX system error is no immediate response to the connect request. However, if the connect request is accepted by the DLS provider. DL_BADQOSPARAM
The quality of service structure type was in state DL_DATAXFER. The UNIX error returned may be set to...
HP DLPI Programmer's Guide - Page 11
.... Document updates may be found online at reprint without changing the printing date. See your HP sales representative for HP-UX 11i. Table 1
HP-UX 11i Releases
Release Identifier
Release Name
Supported System
B.11.11 B.11.20 B.11.22
HP-UX 11i v1 HP-UX 11i v1.5 HP-UX 11i v1.6
HP 9000 HP Integrity HP Integrity
11 The document part number will...
Site Preparation Guide, Third Edition - HP 9000 rp4410/rp4440 - Page 16
... RMS
rp4410: 100A (peak), 55A (average) 0 msec - 1 msec 55A (peak), 33A (average) 1 msec - 2 msec 5A (peak), 22A (average) 2 msec - 10 sec 25A (peak), 15A (average) 10 msec - 150 msec rp4440: 100A... of AC power needed for the server. The following tables provide information to help determine the amount of supply rating
Table 1-4
System Power Specifications
Specification Nominal input ...
Installation Guide, Sixth Edition - HP 9000 rp4410/rp4440 - Page 4
... 91 Server Does Not Power On 92 BCH Menu is Not Available 93 Operating System Does Not Boot 93 Operating System Boots with Problems 93 Intermittent Server Problems 93 DVD Problems 94 Hard Drive Problems 94 Console Problems 94 Downloading and Installing the Latest Version of the Firmware 94 Troubleshooting Using LED Indicators 95 Information to the iLO MP 82 Additional Setup 83...
Installation Guide, Sixth Edition - HP 9000 rp4410/rp4440 - Page 18
... Integrated Light-Out Management Processor (iLO MP) through the HP 9000 processor family standards and extensions, and has no operating system-specific functionality included.
Reviewing these events helps you diagnose and troubleshoot problems with the same interface to system firmware, and all features are available to chassis codes for booting. Installing the System Safety Information
The...
User Service Guide, Fifth Edition - HP 9000 rp4410/4440 - Page 25
... LEDs
This section describes the controls, ports, and LEDs found on the server front. Dimensions and Values
Table 1-1 lists the dimensions and their values of the HP 9000 rp4410 and rp4440 servers.
Event IDs for Errors and Events
The server firmware generates event IDs similar to chassis codes for errors, events, and forward progress to the operating system. The operating system...
User Service Guide, Fifth Edition - HP 9000 rp4410/4440 - Page 54
... to provide a means of many individually linked binary images that support PA-RISC systems) operating system through common shared memory. The firmware supports the HP-UX 11i version 1 (and higher HP-UX versions that are available to the operating system.
Mass Storage
The following is supported on the HP 9000 rp4410 and rp4440 servers:
• Up to two SCSI hot-pluggable hard disk...
User Service Guide, Fifth Edition - HP 9000 rp4410/4440 - Page 124
... Determine the following information:
• The model number of your server (for example, HP 9000 rp4440) • The product number of your system configuration: • Are you should: 1. This is in use ?
124 Installing the System Check information on troubleshooting and attempt to solve the problem.
• Note failure symptoms and error indications (LEDs and messages) by checking...
User Service Guide, Fifth Edition - HP 9000 rp4410/4440 - Page 125
... the HP 9000 rp4410 and rp4440 servers. • To boot HP-UX, follow these procedures:
- You can only run one operating system on the server.
Typically this results in booting HP-UX in multi-user mode.
- If autoboot is on the HP website at one time. To set the boot path if HP-UX is supported on the server at http://docs.hp.com...
User Service Guide, Fifth Edition - HP 9000 rp4410/4440 - Page 134
... Itanium or PA-RISC code. 4. For the rp4440 server, you do not assist in position 0 and retest.
If POST does not start after five to help solve your operating system is functional, the system initiates POST.
Insert the processor extender board. If you add the processor extender board and processors. NOTE: For this problem are in...
User Service Guide, Fifth Edition - HP 9000 rp4410/4440 - Page 195
... the memory extender board. Back up your local HP Authorized Service Provider. Ensure that the power LED goes off and all users are present at various locations within the server whenever an AC power source is not in erratic system behavior or system failure. Back up all ESD safety precautions before upgrading the server. Verify the upgrade installation
Back Up...
User Service Guide, Fifth Edition - HP 9000 rp4410/4440 - Page 239
... set Product Number Display or change scrolling ability Enable/disable self test execution
BOot [PRI|ALT|] DIsplay HElp [] RESET MAin ---Service Menu: Enter command >
Boot from specified path Redisplay the current menu Display help for HP PA-RISC and Integrity is an autonomous management subsystem embedded directly on the iLO MP, see the HP Integrity and HP 9000 iLO MP Operations Guide...
User Service Guide, Fifth Edition - HP 9000 rp4410/4440 - Page 243
... and replace, 65, 154 CSR (customer self repair), 231 customer self repair (CSR), 231
D
damaged equipment, returning, 57 deallocated memory rank, 156 default password, modifying, 111 DHCP
security risk, 112 DHCP and DNS
access to iLO MP, 107 configure iLO MP LAN, 107 dimensions and values, 43, 54 DIMM memory, installing, 157 dipswitch, 134, 166, 177 location, 162 S5 setting...
User Service Guide, Fifth Edition - HP 9000 rp4410/4440 - Page 245
... PR command, 40, 115 problems, 119 reset command (see PR) standby state, 115 states, 40, 115 power supply hot-swappable, 218
load order, 218 remove, 218 replace, 219 installing, 74 status LED, 29 powering off the server, 116 iLO MP PC command, 41, 116 manually, 41, 116 powering on the server, 115-116 iLO MP PC command, 40, 115 manually, 41, 116 PR...
HP rp4410 Reviews
We have not received any reviews for HP yet.