Indigo W7200 Specifications

Dripping Prevention and ITM Heating Hood Service -- CA393-10100 Rev 00

Page 40
... for preliminary procedures. 1. Preliminary procedures 37 Check the cleaning station unit. Check chiller set point: ● Temperature of the units while the press is within specifications (Refer to the relevant Site Preparation Guide): ● Required ambient temperature 20 to 25° C (68 to 77° F) ● Required ambient relative humidity 50...

Dripping Prevention and ITM Heating Hood Service -- CA393-10100 Rev 00

Page 60
... flow Follow these steps to 1023. 4. The measured air velocity should be 16 ± 2 m/sec. Figure 3-37 Air flow arrow on the Anemometer For the specifications see Anemometer AVM-01/03 specs on page 62. Verify that the EBV air knife, and upper and lower suctions are connected firmly. 3. In Systab...

Dripping Prevention and ITM Heating Hood Service -- CA393-10100 Rev 00

Page 63
... for dripping correction procedures when the press in Ready (print) status, touch Main Menu > Press status > System status, and verify that temperature values are within specifications. In Systab Editor, set IO_COOLER_FAN to 10000. 2. Put the press into Ready status. 2.

Electrometer Board Test

Page 15
... W101. Disconnect the testing jig from the electrometer board CP1 and reconnect the probe. End of Board Test If results of electrometer board are within specification, then board is in order, but problem remains, check the probe as follows: End of Board Test 13 18. If not, replace the board...

Electrometer Board Test

Page 27
.... 11. Disassemble/disconnect the probe and remove from the press. 3. Immerse the probe into IPA and agitate (stir) the probe. 4. End of probe are within specification, then probe is functioning properly. ● If not, try cleaning the probe. ● If cleaning the probe did not help, replace the probe. Allow the...

Baseline procedure -- CA393-03500 Rev 04

Page 5
.... 5. Shutdown the press software and computer. 2. The press must be sealed to prevent condensation, caused as a result of the units while the press is within specifications (Refer to the relevant Site Preparation Guide): ● Required ambient temperature 20 to 25° C (68 to 77° F) ● Required ambient relative humidity 50...

Baseline procedure -- CA393-03500 Rev 04

Page 25
... fan outlet Measuring the EBV and IRS suction air flow Follow these steps to 1023. 4. Figure 2-37 Air flow arrow on the Anemometer For the specifications see Anemometer AVM-01/03 specs on page 28. Air velocity should be 22 ± 2 m/sec.

Baseline procedure -- CA393-03500 Rev 04

Page 28
... control as shown below. With the press in Ready (print) status, touch Main Menu > Press status > System status, and verify that temperature values are within specifications. Using a lint-free wipe with imaging oil, wipe the entire PIP surface, including the PIP shoulders. 26 Chapter 2 Procedures Figure 2-43 Utility cabinet outlet Press...

Baseline procedure -- CA393-03500 Rev 04

Page 30
A Appendix Anemometer AVM-01/03 specs Features and specification of AVM-01/03 specs. 28 Appendix A Appendix

Indigo W7200 Specifications - HP