Haier HWM75TL Support and Manuals
Get Help and Manuals for this Haier item
This item is in your list!
View All Support Options Below
Free Haier HWM75TL manuals!
Problems with Haier HWM75TL?
Ask a Question
Free Haier HWM75TL manuals!
Problems with Haier HWM75TL?
Ask a Question
Popular Haier HWM75TL Manual Pages
User Manual - Page 2
... INSTRUCTIONS 2,3 OPERATING INSTRUCTIONS 4
Parts and Features 4 Operating instructions 5
CARE AND CLEANING GUIDE 7 Cleaning and Maintenance 7 Moving & Vacationing 8
TROUBLE SHOOTING 8 INSTALLATION INSTRUCTIONS 10 Tools and Materials Required 10 Unpacking Your Washer 11 Levelling Your Washer 11 Steps for Installation 12
ELECTRICAL REQUIREMENTS 14 Power Interruptions 14 SPECIFICATIONS...
User Manual - Page 3
... not use WARM wash only.
2 Replace worn power cords, loose plugs and power outlets immediately.
8. Repairs should be properly installed in the presence of fire, electric shock, or injury when using the appliance.
2.This appliance is used.
6. If temperature cannot be done by pulling on the power cord. Read all instructions before using your appliance, follow basic precautions...
User Manual - Page 4
... with 240V power source.
21. The appliance is not to the wash.
15. Do not operate this appliance is supplied from a cord extension set or electrical
portable outlet device, the cord extension set or electrical portable outlet device must be connected to remove clothes while the washer is in the base, the installation instructions shall state that the openings must...
User Manual - Page 5
OPERATING INSTRUCTIONS
Parts and Features
1 2
4
5
13
12
11
10
6
7
8
3
9
1 Top lid
7 Balance ring
13 Hot Water Inlet Valve
2 Control panel
8 Inner tub
3 Levelling feet
9 Pulsator
4 Door switch
10 Drain hose joint
5 Bleach injection inlet 11 Power Cord(220Volt/50Hz) 6 Ou ter tub cove r 12 Cold Water Inlet Value
4
User Manual - Page 6
...of the wash or in the dryer, this cycle for the water to manually replenish
water.
Cycles (3)
• Normal - Use this
cycle could be set at the beginning of the wash load.
... During Soak,Wash or Rinse, press this cycle for white and light colored clothing. • Colors - Use this button to stop. Operating Instructions
Soa k
Extra Rinse
1
2
3
4
5
Temperature Wash / Rinse ...
User Manual - Page 7
... in the water. * Close the lid after loading the laundry.
Loading the Washer:
When loading the clothes into your washing machine, there are a few points to remember: * Separate the white from the ... to avoid damages to the interior parts. * Pre-treat all stains and heavily soiled areas for better result. * Load each item loosely. With the lid open, the washer will automatically be added to the ...
User Manual - Page 8
CARE AND CLEANING GUIDE
Warning: Always unplug your washer. * Leave lid open after washing to allow inside of washer to dry and assist in preventing unwelcomed bad odours...in dispenser.
Before using cleaning products, always read and follow manufacturer warnings to cabinet finish, wipe washer cabinet as needed.
If you spill liquid/powdered softener bleach or detergent on the cabinet, wipe...
User Manual - Page 9
... washer disconnect drain hose. * Turn the leveling legs clockwise all hoses. * Disconnect electrical plug. * Dry inner wash tub. Problems with...TROUBLE SHOOTING
If washer does not operate:
* Check the unit is plugged in upright position only. * To prevent mold or mildew, leave lid open .You may be reset or if the fuse needs replacing. * Check if the washer is open so moisture inside machine...
User Manual - Page 10
...sound: Due to overloaded wash tub. * Vibration Noise: may be caused by not leveling washer properly on and off will...* Washer may need to be reinstalled (Check washer installation section). * Washer load may need to not installing your water heater temperature. Washer is... are continuously being lossed around.
* Air rushing noise:This happens when the washer tub spins at least 120°F140...
User Manual - Page 11
..., zippers, metal snaps etc.
Call service. Reduce detergent dosage or pre-dissolve detergent before adding to sharp objects left in water.
* Check water temperature, add detergent as wash tub is being filled with the installation of your washer:
Pliers, Wrench, Tape Measure, Gloves, Level
10 LED Display Notes:
Trouble Codes
Reasons
Rinse and spin indicators flash...
User Manual - Page 13
... water inlet hoses to be used and that old hose-sets should be placed at room temperature.You must not be reused.
Do not over tighten because you may have to the valve. Installing Your Washer
Read installation instructions carefully before installation. 1. Flat water inlet hose washers are to the hot and cold water faucet.
12
Cold...
User Manual - Page 14
... completing these steps, you are unsure that it be installed by a certified installer.
13 Goose Neck Water Supply Hose
Water Inlet Hose Bend
Drain Hose
4.Plug the wash er into a drain pipe or sink at a minimum height of 1000mm and a maximum height of the washer using the drain hose clamp provided.The drain hose...
User Manual - Page 15
... Instructions
This appliance must be positioned so that it is not subject to splashing or ingress of electric shock by the manufacturer, its service agent or similarly qualified persons in a risk of the consumer to have it replaced with a grounded plug.The plug must be replaced by providing an escape wire for a prolonged period, clean washer...
Haier HWM75TL Reviews
Do you have an experience with the Haier HWM75TL that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Haier yet.
Earn 750 points for your review!