Haier HLTD500AGW Support and Manuals
Get Help and Manuals for this Haier item
View All Support Options Below
Free Haier HLTD500AGW manuals!
Problems with Haier HLTD500AGW?
Ask a Question
Free Haier HLTD500AGW manuals!
Problems with Haier HLTD500AGW?
Ask a Question
Popular Haier HLTD500AGW Manual Pages
User Manual - Page 3
...- Connect to this Haier product. This user manual will help you for purchasing this manual to aid in obtaining warranty service if needed. TABLE OF CONTENTS
IMPORTANT SAFETY INSTRUCTIONS 2 Gas Dryer Precautions 3 General Safety Precautions 4
PARTS AND FEATURES 5
INSTALLATION INSTRUCTIONS 6 Tools Needed ...6 Additional Parts Required 7 Location Requirements 7 Electrical & Gas Supply...
User Manual - Page 4
Follow the gas supplier's instructions.
●
department. installer, service agency, or the gas supplier.
2 IMPORTANT SAFETY INSTRUCTIONS
WARNING
WARNING: For your safety, the information in your gas supplier from a neighbor's
phone. do not use any
phone in this or any electrical switch; ...
User Manual - Page 5
...in compliance with the National Fuel Gas Code, ANSI Z223.1/ NFPA 54, or the Natural Gas and Propane Installation Code, CSA B149.1.
r Installation must be performed by a qualinj...being installed.
IMPORTANT: The gas installation must not be properly installed and located in accordance with
the installation instructions before using your safety, the information in this manual must...
User Manual - Page 6
... screen before attempting any part of electric shock, unplug...service, repair or replace any maintenance or cleaning. r Do not tamper with the Power button does NOT disconnect the appliance from the accumulation of the fabric softener or product. r Do not use fabric softeners or products to cooking oils in , or spotted with , or inside this user manual or in published repair instructions...
User Manual - Page 7
PARTS AND FEATURES
Electric Dryer
Gas Dryer
C
B
A
D E
G
N H
M
D E
F
I J
L
K
Power Cord (120 volt/60 Hz)
Strain Relief Mounting Bracket (Canadian electric model has a 240 volt/ 60 Hz power cord attached.)
Terminal Block Access Cover
Exhaust Outlet
Louvered Ventilation Panel
Gas Inlet Pipe
Control Panel
Door Safety Switch ...
User Manual - Page 12
...supply available in the installed position.
A kit that meets local electrical
codes must conform with local codes and ordinances and the latest edition of the CSA C22.1 Canadian Electrical Code Part 1. The dryer can...location does not meet the
above requirements, contact a licensed electrician. NOTE: The electrical service to hold the power cord. Do not operate a washer and dryer on a 240 ...
User Manual - Page 14
...connect your dryer to the rigid gas supply line. GAS SUPPLY REQUIREMENTS
NOTE: The gas service to the dryer must be connected to the gas supply line with a listed Ǎ...and Propane Installation Code, B149.1.
r The shutoNj valve should be ½" (1.3 cm) pipe and must have an individual
manual shutoNj valve installed within 6 ft (183 cm) of the National Fuel Gas Code, ANSI Z223...
User Manual - Page 15
... 10,000 ft. (3,048 m):
r When installed above sea level at pressures greater than 90°... model/serial number plate is constructed of a njre hazard. rating shown on the model...of plastic or metal foil Ǎexible
ducting, replace it with rigid metal ducting. Failure to the ...performance, damage to follow these instructions can reduce the accumulation of duct pipe for a safe ...
User Manual - Page 25
...cycle in your fabric. The No Heat setting is not available with timed dry cycles only...For best results, follow your
garment label instructions and use the warmest temperature that is...r If the dryer senses a malfunction, an error code will periodically tumble for low-temperature heat and... ADJUST BUTTONS
r Use these buttons to the "Troubleshooting" section for your garments. Quick Dry - Use...
User Manual - Page 26
... you intend to untangle and redistribute large bulky items before the cycle is complete. CYCLE GUIDE
NOTE: To protect your clothes are not available for each cycle. The shaded boxes indicate the default settings for all options and settings are approximately 80% dry.
This is turned o , the damp signal will alert you the...
User Manual - Page 28
...avoid entanglement and ensure easy removal, small articles should be turned inside out for manufacturers' drying instructions. Slide the lint screen back into the dryer. PREPARE AND SORT LAUNDRY
r Check garment labels...Do not rinse or wash the lint screen to avoid snagging.
r To avoid permanently setting stains or soils, check that give oNj lint. r Separate fabrics that attract lint...
User Manual - Page 29
...
that garments are drying large bulky items, only 2-3 pieces should be loaded at a
time along with a few small and medium-sized garments. Modify the default settings and options if desired. 4.
User Manual - Page 32
... to make sure the gas shutoNj valve is of proper voltage. If the error persists, call for service.
TROUBLESHOOTING
ERROR CODES
When the dryer senses an error all machine operations will stop, a series of 4 beeps will sound and an error code will be replaced. Check to be shown in the dryer are normal during the operation of the...
User Manual - Page 33
...r Check the exhaust ducting and exhaust hood. r Check that the dryer is not set on the
Ǎoor and that the dryer is level. r Dryer may not be...See the "Normal Operating Sounds" section. Loads are resting njrmly on the Air FluNj (no heat) temperature setting.
Drying will be free of the drum
volume.
The dryer drum should be at the end of the cycle. Heavyweight ...
User Manual - Page 34
..., which vary,
from the date of purchase.
Hoses, knobs, lint trays and all replacement parts if defective in the owner's manual. Any transportation and shipping charges.
FOR WARRANTY SERVICE
Contact your appliance. Before calling please have other remedies. A proof of the problem. A product whose original serial number has been removed or altered.
Damage from any...
Haier HLTD500AGW Reviews
We have not received any reviews for Haier yet.