GE PCT916SMSS Support and Manuals
Get Help and Manuals for this General Electric item
View All Support Options Below
Free GE PCT916SMSS manuals!
Problems with GE PCT916SMSS?
Ask a Question
Free GE PCT916SMSS manuals!
Problems with GE PCT916SMSS?
Ask a Question
Popular GE PCT916SMSS Manual Pages
Installation Instructions - Page 1
... sure to leave these instructions with the consumer.
• Note to improper installation is NOT permitted on some models or can be hard wired (direct wired) into an approved junction box.
A plug and receptacle is NOT covered under warranty.
• NOTE-This appliance must be properly grounded.
• ATTENTION INSTALLER
All electric wall ovens must be purchased separately...
Installation Instructions - Page 2
... used.
2 Installation Instructions
IMPORTANT SAFETY INSTRUCTIONS
For Your Safety
• Be sure your area. Never allow anyone to climb, sit, stand or hang on the oven frame to an individual, properly grounded branch circuit, protected by the oven. Use the chart below to do so could result in serious injury or death.
Electrical Requirements
This appliance must...
Installation Instructions - Page 3
... as far as it will be installed at the end of the installation process.
Remove Installation Instructions from the top of the way closed. Hinge Clears Slot
NOTE: The oven door is most of the oven. Remove labels on a table or platform even with the cutout opening. (Platform must support 68 Kg [150 lbs.].)
Remove the bottom...
Installation Instructions - Page 4
... to adjacent corners, drawers, walls, etc.
Allow 2.5 cm (1") minimum for 27″ (68.6 cm) Single Built-In Ovens only
For JCKP30, JCKP70, JCKS10, PCK916, PCK920 models only.
12.7 cm
(5") Max. Recommended cutout location from adjacent cabinet may be necessary to support the weight of the oven.
Installation Instructions
A Cutout for overlap of oven top and bottom of...
Installation Instructions - Page 5
...installed oven, it may be at least 72.4 cm (28 1/2") wide
Allow 2.5 cm (1") for 30″ (76.2 cm) Single Built-In
Ovens only For JCTP30, JCTP70, PCT916, PCT920 models...shim both sides equally to
support the weight of the oven. CL
25" xcm4" ... (22") to adjacent corners, drawers, walls, etc. Installation Instructions
A Cutout for overlap of oven top and 3.2 cm (11⁄4") bottom of cutout
Cabinet ...
Installation Instructions - Page 6
Installation Instructions
A Cutout for 27″ (68.6 cm) Single Built-In Ovens only Under Counter For JCKP30, JCKP70, JCKS10, PCK916, PCK920 models only.
63.5 cm (25")
240V / 208V Junction Box Location (junction box may be necessary if unit is not approved to be in the cabinet.
63.5 ...
Installation Instructions - Page 7
... may be in adjacent cabinet)
19.7 cm (7 3/4") Max. See cooktop installation instructions for 30″ (76.2 cm) Single Built-In Ovens only Under Counter For JCTP30, JCTP70, PCT916, PCT920 models only. Gas and electrical connections for approved cooktop models.
63.5 cm (25")
240V / 208V Junction Box Location (junction box may be made to the left.
Allow...
Installation Instructions - Page 8
... between cutouts may be installed. Refer to installation instructions packed with specific models listed on the label located on top of the oven.
1" (2.5 cm) Min. Per Warming Drawer Requirement
NOTE: Install the oven only with the Warming Drawer for 30″ (76.2 cm) Single Built-In Ovens only - Above Toekick or Adjust to be sure the oven supports above the Warming...
Installation Instructions - Page 9
... that it will lie on these 3 leads is governed by the wire gauge and the temperature rating of the cabinet opening,
connect the flexible conduit to the electrical
junction box as shown by wiring diagram. Installation Instructions
B Electrical Connections
ATTENTION INSTALLER
All electric wall ovens must be securely attached to the clamp. The insulation of these products. CONDUIT FROM...
Installation Instructions - Page 10
.... WARNING: Mounting
screws must be a minimum of the way, slide the oven 3/4 way back into cabinet cutout using the oven opening . This will go and is slid into the opening as a grip. Installation Instructions
C Securing the Oven in the Opening
C1 Sliding the Oven Into the Opening
a. Pull out on one end of the side trim...
Installation Instructions - Page 11
Installation Instructions
C3 Preparing for service, the trim must be drilled. Drill pilot holes into the center of the trim down to maintain the alignment. Tape the edges of each slot (two total) where the mounting holes will occur.
11
b.
For 27″ (68.6 cm) models with Lower Trim in Position, Mark (2) Mounting Hole Locations...
Installation Instructions - Page 12
... the door at the same angle as it into the hinge slots. Do not lift the door by the handle. You may need help . Installation Instructions
D Replacing the Oven Door
NOTE: The oven door is most of
the way closed, seat the notch of the
hinge arm into the bottom edge of the
hinge slot.
Installation Instructions - Page 13
... designed and CSA approved for connections to your Owner's Manual for troubleshooting list.
13
NOTE TO ELECTRICIAN: The power leads supplied with this appliance are installed and flush with moving parts. The insulation of these leads is governed by the wire gauge and also the temperature rating of the insulation around the wire. Turn on the...
GE PCT916SMSS Reviews
We have not received any reviews for GE yet.