Installation Instructions (All Languages)
Page 3
... (one screw) and remove cover. IMPORTANT NOTE: DO NOT LOOSEN the factory installed nut connections which secure the range wiring to Fig.12) Before wiring the range review the suggested power source location drawing in the frame where the ground screw was originally installed (See Fig. 12...power supply cord kit rated at 125/250 volts minimum, and marked for existing installations 3 Wire Wall receptacle (10-50R) Fig. 8 NOTE: Range is shipped from the frame of a power supply cord. Wire electrical wall Receptacle types & recommended mounting orientation on end of the appliance with ...
... (one screw) and remove cover. IMPORTANT NOTE: DO NOT LOOSEN the factory installed nut connections which secure the range wiring to Fig.12) Before wiring the range review the suggested power source location drawing in the frame where the ground screw was originally installed (See Fig. 12...power supply cord kit rated at 125/250 volts minimum, and marked for existing installations 3 Wire Wall receptacle (10-50R) Fig. 8 NOTE: Range is shipped from the frame of a power supply cord. Wire electrical wall Receptacle types & recommended mounting orientation on end of the appliance with ...
Installation Instructions (All Languages)
Page 4
...Fig. 15. The ground strap is removed for Line 1, Line 2 and Neutral and tighten securely to the terminal block. Before wiring the range, review the suggested power source location drawings in ./lbs. KEEP the ground screw, ground plate and go to Step 4. 4. (4-Wire Permanent Connection... Connection ONLY) Disconnect the ground strap. IMPORTANT NOTE: DO NOT LOOSEN the factory installed nut connections which connects the center terminal of the range. 4 Fig. 13 Fig. 14 Note: Non-terminated field wire compression connections must be set at approximately 22in./ lbs. Cut and discard...
...Fig. 15. The ground strap is removed for Line 1, Line 2 and Neutral and tighten securely to the terminal block. Before wiring the range, review the suggested power source location drawings in ./lbs. KEEP the ground screw, ground plate and go to Step 4. 4. (4-Wire Permanent Connection... Connection ONLY) Disconnect the ground strap. IMPORTANT NOTE: DO NOT LOOSEN the factory installed nut connections which connects the center terminal of the range. 4 Fig. 13 Fig. 14 Note: Non-terminated field wire compression connections must be set at approximately 22in./ lbs. Cut and discard...