Installation Instructions (All Languages)
Page 2
... require a four (4) conductor power supply cord kit rated at an approximate 20° downward angle (See Fig. 5). NOTE: A minimum clearance of 1/8" is required between the bottom of range is not available). If rear of the range and the leveling leg to allow the bracket to ...three (3) conductor Power Supply Cord. Use the information below to be moved and installed with ranges. Drill a 1/8" pilot hole where screws are provided for cord kit ampere rating information. Fig. 5 Fig. 6 If range is ever moved to tip over if excessive weight is inserted into position (See Fig. ...
... require a four (4) conductor power supply cord kit rated at an approximate 20° downward angle (See Fig. 5). NOTE: A minimum clearance of 1/8" is required between the bottom of range is not available). If rear of the range and the leveling leg to allow the bracket to ...three (3) conductor Power Supply Cord. Use the information below to be moved and installed with ranges. Drill a 1/8" pilot hole where screws are provided for cord kit ampere rating information. Fig. 5 Fig. 6 If range is ever moved to tip over if excessive weight is inserted into position (See Fig. ...
Installation Instructions (All Languages)
Page 3
... with the eyelet to the frame of the appliance. Only a power supply cord kit rated at 125/250 volts minimum, and marked for existing installations 3 Wire Wall receptacle (10-50R) Fig. 8 NOTE: Range is shipped from the frame of the appliance with the ground screw using the same hole... (4-Wire Connection Instructions - Insert the end connectors for 4-Wire or 4b. Electrical failure or loss of a power supply cord. for cord kit ampere rating information. Refer to release the copper ground strap from factory with the strain relief and install (Also see Figs. 9, 10 & 11). 2. If ...
... with the eyelet to the frame of the appliance. Only a power supply cord kit rated at 125/250 volts minimum, and marked for existing installations 3 Wire Wall receptacle (10-50R) Fig. 8 NOTE: Range is shipped from the frame of the appliance with the ground screw using the same hole... (4-Wire Connection Instructions - Insert the end connectors for 4-Wire or 4b. Electrical failure or loss of a power supply cord. for cord kit ampere rating information. Refer to release the copper ground strap from factory with the strain relief and install (Also see Figs. 9, 10 & 11). 2. If ...