Fender FWG 2020 UHF Support and Manuals
Get Help and Manuals for this Fender item
View All Support Options Below
Free Fender FWG 2020 UHF manuals!
Problems with Fender FWG 2020 UHF?
Ask a Question
Free Fender FWG 2020 UHF manuals!
Problems with Fender FWG 2020 UHF?
Ask a Question
Popular Fender FWG 2020 UHF Manual Pages
Owners Manual - Page 7
... and do not use cable ducts or conduits, be opened, serviced, and repaired by Fender service personnel. • Do not place the equipment near heat sources...instructions below carefully before cleaning the equipment! Symbols Used
The lightning flash with a capacity
of batteries take a few minutes to the User Manual.
Safety
• The equipment may damage the enamel and plastic parts...
Owners Manual - Page 8
... on l : selects SETUP mode. • In SETUP mode only:
2 GENERAL
Introduction
The FWG 2020 wireless system comprises a stationary diversity receiver and the bodypack transmitter. The bodypack transmitter is no protection from interference received from
that may not cause harmful interference, and (2) this system without a license is back-lit in a residential installation.
Owners Manual - Page 9
...setting the transmitter's carrier frequency.
18 LCD display: Indicates the selected frequency in MHz or as a Preset sub-channel, current mode, error...to the instrument you install one hour... for connecting the two supplied UHF antennas or optional remote antennas....code strip (optional) into a 19" rack, either mount the supplied antennas on the receiver front panel(s) or use remote antennas. SETTING...
Owners Manual - Page 10
...set up within a very short time. Make sure to the input gain of musicians and other receiver.
3. This is less than 10 ft (3 m). • Check that you install...included power supply is available and a wireless system has to -30 dB. Plug... Positioning the Receiver
Reflections off metal parts, walls, ceilings, etc. Plug ... display. • To enter SETUP mode, press and hold the ...
Owners Manual - Page 11
... bars on your instrument (the louder the better). 3. (6) Use the integrated screwdriver (6) on the battery compartment
cover (5) to set the gain control ...Setting Input Gain
i Refer to the supplied LR6 alkaline dry battery, you inserted: "LR6", "FR6", "HR6 (for some other RF device or wireless... a capacity of the signal received by the Fender warranty scheme. The audio bar-graph indicates the...
Owners Manual - Page 12
... from "OFF" to "MUTE/PRG": The transmitter audio and RF sections are fewer than absolutely necessary. Set the ON-MUTE/PRG-OFF switch to select a different GROUP.
3. i Refer to -86 dBm. Automatic setup - Manual Group/Channel setup - Automatic Setup (Multichannel Systems)
1. Switch all clean channels.
3. er scans all receiver parameters. If the clean CHANNELs found...
Owners Manual - Page 13
... 10 hours. The battery will change from the same Frequency Group.
• Do not operate two or more wireless channels on "Programming Transmitters". The display will only indicate a maximum of priority:
1.
The current setting starts flashing. 2. The display indicates this : "F 10h" (example). "AF CLIP": Audio overload. All selected warning functions are not...
Owners Manual - Page 14
...finds no clean frequency, check your antenna setup (cable lengths, booster, power splitter, ...To reset all parameters to their factory default settings, use the system to start the recording....noise of up information about your instrument (the louder the better).
...display indicates dropout no dropout has been detected. "V1.1": firmware version - "B 4--.50": frequency band - ferent positions...
Owners Manual - Page 15
...installation checked.
• Relocate receiver or antennas. If dead spots persist, mark and avoid them. If problem persists, contact your Fender Service Center. If problem occurs frequently, contact your Fender Service Center.
five seconds. Remove transmitter from receiver or squelch threshold setting is not connected to receiver and/or power outlet. 2. ENGLISH
Troubleshooting
PROBLEM...
Owners Manual - Page 16
ENGLISH
Specifications
SYSTEM RF CARRIER FREQUENCY RANGES
Band 1:
650.1 - 680 MHz
Band 7:
500.1 - 530.5 MHz
Band 9-U: 600 - 630.5 MHz
Band M:
826.3 - 831.9 MHz
RECEIVER Switching bandwidth: Modulation: ...
Fender FWG 2020 UHF Reviews
We have not received any reviews for Fender yet.