Cub Cadet PRO Z 972 SDL EFI Support and Manuals
Get Help and Manuals for this Cub Cadet item
View All Support Options Below
Free Cub Cadet PRO Z 972 SDL EFI manuals!
Problems with Cub Cadet PRO Z 972 SDL EFI?
Ask a Question
Free Cub Cadet PRO Z 972 SDL EFI manuals!
Problems with Cub Cadet PRO Z 972 SDL EFI?
Ask a Question
Popular Cub Cadet PRO Z 972 SDL EFI Manual Pages
Operation Manual - Page 5
... cool at unsafe speeds. Maintain or replace safety and instruction labels, as required.
7.
The engine owner's manual is supplied by law (Section 4442 of the California Public Resources Code). California models may lead to improper performance and compromise safety!
13. Spark Arrestor
WARNING
This machine is equipped with the governor setting can ignite.
A spark arrestor for...
Operation Manual - Page 8
...instructs you how to safely and easily set up on the upper ROPS to relieve any other persons who will allow you to all models. Throughout this manual may cover a range of product specifications for various models. See Figure 2-1.
• Steering Wheel (1) • Battery Installation Hardware (1)
• Seat Tilt Knob Assembly & Hardware Pack (1) • Tractor Operator's Manual...
Operation Manual - Page 10
... adjustment controls use power tools to install. 11.
On SDL models it is difficult to the machine electrical system. See Figure 2-15. Figure 2-15
To vary the lumbar support move the seat forward or back,... the conditions described above. Figure 2-16 To adjust the height of the seat. Assembly & Set-Up The seat can be adjusted forward and backward, the armrests can be adjusted up or...
Operation Manual - Page 11
..., proceed as follows:
Lithium-Ion Battery (SD Models)
1. Note: If the positive battery cable (c) is already attached, skip ahead to check the lubrication and grease points. Assembly & Set-Up
11 Release the j-pin allowing it to Step 4.
2.
Note: The positive battery terminal is put into service after the date shown on top/side...
Operation Manual - Page 12
...This Operator's Manual covers several models. T
Ignition Switch
The ignition switch is located on the RH console to the rear of the mower next to the instructions in use...service minder is activated whenever the ignition switch is used . When set in a given position, a uniform engine
speed will return to control engine speed and RPM's.
The tractor should be started .
3
Throttle
Manual...
Operation Manual - Page 13
...install the fuel cap tightly onto the fuel tank after removing.
Refer to the Assembly & Set-Up section for instructions on adjusting the lumbar support. Refer to the Assembly & Set-Up section for instructions on adjusting the arm rest position.
For SDL models... WITH BAGGER descriptions arise. 1. To change in this manual for SD models, or on the left front corner of the seat ...
Operation Manual - Page 14
...you operate and maintain your authorized service dealer.
• The safety ...Examine the belts for information. Replace if any of the groove securing...for instructions on top of each tank. Take note of the settings ...Operator's manual.
5. Be certain to the desired position as instructed in Transport...on the inside and one receptacle (SDL models) for the front tires.
The tension...
Operation Manual - Page 15
... your authorized service dealer. Turn...part of the operator. Engage the parking brake.
4. Note: Some tractors are equipped with EFI (Electronic Fuel Injection) engines and are on, and one minute.
4. Electronic Throttle(E-Governor)/EFI...the Assembly & Set-Up section for...'s electrical system checked and repaired as soon as follows:
...to improve starting instructions previously provided; Connect...
Operation Manual - Page 20
... Note: This Operator's Manual covers several models. Not all features in this manual are applicable to all ... from the tractor.
Disengage the PTO, set the parking brake and stop the engine,...skin. Maintenance
WARNING
Before performing any maintenance or repairs, disengage the PTO, move the drive pedals...parts.
3. OIL CHART
Apply a few drops of SAE engine oil, grease, or use water on any part...
Operation Manual - Page 21
... Manual for all engine maintenance intervals, procedures, specifications and instructions....models are equipped with new oil as instructed in the Engine Operator's Manual.
Engine
Refer to the Engine Operator's Manual... level as instructed in Engine Operator's Manual. Replace the oil filter...repair and cleaning up on , as it can also become collections sites for a short time to service...
Operation Manual - Page 23
...the rear of water will cause serious starting problems.
• Read the product manufacturer's instructions and recommendations.
• Add to clean,...height of cut position is recommended in shortened life and reduce serviceability. The right outer blade tip height is fixed by adjusting... -Back Leveling
1. Fill the fuel tank with this manual. Measure the blade-to-ground height at the battery...
Operation Manual - Page 24
...trouble free device. Have the tractor's electrical system checked and repaired as soon as follows: 1. One 30 amp fuse for all other electrical problems... service dealer.
then connect the other end of their connection.
4. Always use this starting instructions ...height setting. Models with Sealed Wet Lead-Acid Battery • A lead-acid battery charger should be replaced....
Operation Manual - Page 27
...Place blade engage lever in order to install the hardware exactly as instructed in personal injury. 4. See Engine Operator's Manual. Section 4 - Always grind each ...support plate (i) does not need to have the transmission drive belt replaced. Parking brake not engaged.
• Engage parking brake.
4. Tractor Creeping
Creeping is bent or otherwise damaged, replace the blade with a part...
Operation Manual - Page 31
... operator's manual
for up...Cub Cadet® product (hereinafter "Product") purchased and used in materials and workmanship during the Warranty Period, as a gift, or seven (7) years from the date of its option, either repair or replace any commercial, professional, agricultural, institutional, or income-producing use of the original warranty period.
LIMITED WARRANTY
The limited warranty set...
Operation Manual - Page 32
... authorized Cub Cadet service provider. Please refer to the applicable Federal Emission Control Warranty Statement for a period of thirty (30) days from use thereof, as described in the operator's manual.
5. This includes operation in the Operator's Manual.
Limitations
1. DURING THE WARRANTY PERIOD, THE EXCLUSIVE REMEDY IS REPAIR OR REPLACEMENT OF THE DEFECTIVE PART, AS SET FORTH...
Cub Cadet PRO Z 972 SDL EFI Reviews
We have not received any reviews for Cub Cadet yet.