Cisco AIR-LAP1141N-A-K9 - Aironet 1141 - Wireless Access Point Support and Manuals
Get Help and Manuals for this Cisco item
View All Support Options Below
Free Cisco AIR-LAP1141N-A-K9 manuals!
Problems with Cisco AIR-LAP1141N-A-K9?
Ask a Question
Free Cisco AIR-LAP1141N-A-K9 manuals!
Problems with Cisco AIR-LAP1141N-A-K9?
Ask a Question
Cisco AIR-LAP1141N-A-K9 Videos
Cisco AIR-LAP1141N-A-K9 $465 Price Reduction
Duration: :34
Total Views: 25
Duration: :34
Total Views: 25
Cisco AIR-LAP1141N-A-K9 $465 Price Reduction
Duration: :34
Total Views: 27
Duration: :34
Total Views: 27
Popular Cisco AIR-LAP1141N-A-K9 Manual Pages
Getting Started Guide - Page 2
.... Statement 1071
SAVE THESE INSTRUCTIONS
Warning
Read the installation instructions before you work on any equipment, be aware of each warning to locate its power source. The translated warnings are in the translated safety warnings document that accompanied this Guide
This Guide provides instructions on how to install and configure your documentation CD and cisco.com. Revised December...
Getting Started Guide - Page 6
...configuration, firmware, control transactions, and data transactions. When the access point joins the controller, the controller manages its certificate may not be running release 5.2 or later.
This guide is set...
Because the configuration process takes place on cisco.com. Note CAPWAP support is a standard, interoperable protocol which CAPWAP does not support.
The controller ...
Getting Started Guide - Page 7
...install your access point. Configuring the CISCO-LWAPP-CONTROLLER provides backwards compatibility in response to CISCO-LWAPP-CONTROLLER.localdomain, where localdomain is supported by Layer 2 discovery.
• Over-the-air...discovery-The access point can become an active part of the primary, secondary, and tertiary controllers are installed. This feature is called priming the access ...
Getting Started Guide - Page 8
... purchase additional mounting hardware: See "Mounting the Access Point" section on page 12 for additional information.
• Access point power options: power supplied by a DC power supply, PoE from there. Note
Performing a pre-installation configuration is also known as expected. Cisco recommends that you make a site map showing access point locations so that your access point...
Getting Started Guide - Page 9
...Set the Cisco wireless LAN controller as described in the appropriate Cisco wireless LAN controller guide. c.
Make sure that new access points always join with it. See the Cisco Unified Wireless Network WLAN Controller Guide: Cisco 440x Series WLAN Controllers for additional information. b.
Pre-Installation Configuration Setup
Figure 3 shows the pre-installation configuration setup...
Getting Started Guide - Page 10
... and 3745 multiservice access routers - 3825 and 3845 integrated services routers The access point can take up to convey the ...power injector (AIR-PWRINJ4)
- 1100/1200 series access point DC power supply (AIR-PWR-SPLY) b. CAPWAP UDP ports must be powered by any of the controller. WS-C3550, WS-C3560, and WS-C3750 switches - Note
If the access point remains in the network. This guide...
Getting Started Guide - Page 11
... repeat the pre-installation configuration. e.
Also be sure that the access point and the Cisco wireless LAN controller have a static 1-to-1 NAT to customize the access-point-specific 802.11n network settings. Configure the access point if required. Ensure that the route back to download the new operating system code if the access point code version differs from...
Getting Started Guide - Page 12
... join process begins. a. Step 1 Step 2
Connect and power up sequence that you have mounted the access point, follow these steps to such surfaces, the integrated antennas produce the best antenna radiation pattern. During this URL to browse to complete access point mounting instructions:
http://www.cisco.com/en/US/docs/wireless/access_point/mounting...
Getting Started Guide - Page 13
... Support window and click Install and Upgrade.
Note A Master Cisco wireless LAN controller should have no trouble getting your problem in this guide or the troubleshooting chapter of this guide, you do experience difficulty, before contacting Cisco, look for a solution to your access point installed and running. These, and other documents, are using. Click Products & Services. Scroll...
Getting Started Guide - Page 14
...a controller. Guidelines for monitoring and debug purposes (all configuration commands are disabled when the access point is connected to the "Configuring DHCP Option 43 and DHCP Option 60" section on ... only communicate with Cisco controllers, such as the 2106 series wireless LAN controllers or 4400 series controllers.
• The access point does not support Wireless Domain Services (WDS) and ...
Getting Started Guide - Page 16
...Configuration recovery in progress (MODE button released) DRAM memory test failure FLASH file system failure Environment variable failure Bad MAC address Ethernet failure during image recovery Boot environment failure No Cisco... it can be difficult to troubleshoot such joining problems
16 You do not need to a syslog server. The state of the CAPWAP error messages can be viewed from the...
Getting Started Guide - Page 18
...Communication Commission Declaration of Conformity Statement
Tested To Comply With FCC Standards
FOR HOME OR OFFICE USE
Models AIR-(L)AP1141N-A-K9 AIR-(L)AP1142N-A-K9
Manufacturer: Cisco Systems, Inc. 170 West Tasman Drive San Jose, CA 95134-1706 USA
18
Certification Numbers...new IP address provided the access point can configure the syslog server for the Cisco Aironet 1140 Series Access Point.
Getting Started Guide - Page 22
... products designated by CISCO. Industry Canada
Canadian Compliance Statement
AIR-(L)AP1141N-A-K9 AIR-(L)AP1142N-A-K9
2461B-102069 2461B-102070
This Class B Digital apparatus meets all the requirements of Industry Canada. Statement 371-Power Cable and AC Adapter
English Translation
When installing the product, please use of UL-certified cables (that have "PSE" shown on the code) for any...
Getting Started Guide - Page 23
... the system according to the requirements of RSS-210. For further information, contact your local Industry Canada office.
European Community, Switzerland, Norway, Iceland, and Liechtenstein
Models: AIR-(L)AP1142N-E-K9 AIR-(L)AP1141N-E-K9
23 Cisco Aironet Access Points are certified to the Canadian regulations.
Getting Started Guide - Page 29
... operations to co-channel MSS operations.
Access Point Models
AIR-AP1142N-T-K9 AIR-AP1141N-A-K9 AIR-LAP1142N-T-K9 AIR-LAP1141N-A-K9
29
If interference is caused, the user must stop operating the device immediately and can't re-operate it until the harmful interference is maintained within the band of operation under all conditions of Cisco Aironet access points in the user manual.
Cisco AIR-LAP1141N-A-K9 Reviews
We have not received any reviews for Cisco yet.