Black & Decker GH610 Support and Manuals
Get Help and Manuals for this Black & Decker item
View All Support Options Below
Free Black & Decker GH610 manuals!
Problems with Black & Decker GH610?
Ask a Question
Free Black & Decker GH610 manuals!
Problems with Black & Decker GH610?
Ask a Question
Popular Black & Decker GH610 Manual Pages
Type 1 Manual - GH610 - Page 1
....COM/INSTANTANSWERS for choosing Black & Decker!
it will disrupt the feed mechanism.
• Always use only .065 inch diameter ROUND line (B&D Model No. to speak with...5).
• When replacing the line, use the cord retention feature (page 7).
1 Model No. GH610
TRIMMER / EDGER INSTRUCTION MANUAL
Model Number GH610
Thank you have a question or experience a problem with an agent. ...
Type 1 Manual - GH610 - Page 2
...PROBLEMS...parts.
However, the following . Read All Instructions
Operating Instructions 7 Replacement Accessories 8 Maintenance 10 Troubleshooting 10 Service...an Edger, ...INSTRUCTIONS
WARNING: When using electric gardening appliances, basic
safety precautions should be taken: • MAKE SURE that other persons and pets are recommended when working close to read and understand this manual...
Type 1 Manual - GH610 - Page 3
... it is damaged should be properly repaired or replaced by a circuit breaker.
• DO NOT immerse tool in a dry, locked-up place out of reach of protection. The
symbols and their definitions are available having built in this Instruction Manual for proper operation of the appliance, a guard or other part that may be stored indoors...
Type 1 Manual - GH610 - Page 4
...12 - 16
14
12
Not Recommended
4 Minimum Gauge for Cord Sets
Volts
Total Length of a polarized wall outlet. SAFETY WARNINGS AND INSTRUCTIONS: POLARIZED PLUGS
To reduce the risk of electric shock, this ... cord will be used outside, the cord must be sure to use one heavy enough to install the proper wall outlet. The table shows the correct size to cause cancer, birth defects or...
Type 1 Manual - GH610 - Page 5
... IN PLACE. Auxillary Handle
5. Guard
9. Collar (to
complete the guard
assembly.
• Once the guard is installed,
remove the covering from the
line cut-off blade, located on until you are looking
b
down at the spool cap (a).
• Turn the guard (b) upside
down so that you hear it onto the
c
motor housing...
Type 1 Manual - GH610 - Page 6
... you
release them with the
Black & Decker logo facing
upward). Partially push the
handle on so that your front
arm is straight when the
trimmer is
achieved, tighten the collar...direction shown in figure 6.
6 down .
HEIGHT ADJUSTMENT
6
• The overall height of the
trimmer can be
adjusted so that it "snaps" into place (figure 5). ATTACHING THE AUXILIARY HANDLE
•...
Type 1 Manual - GH610 - Page 7
... and slowly swing the trimmer side to avoid any wire which could become entangled in the
• Turn the collar (l) until tight. OPERATING INSTRUCTIONS
CONVERT TO EDGING MODE
9
WARNING: Always use this power tool.
• To operate as a maintenance edger, turn the collar (l) as shown in figure 8. rotating line or spool.
Hook the
loop...
Type 1 Manual - GH610 - Page 8
... & Decker replacement spool Model No. To find your local dealer or authorized service center. • Other replacement parts (guards, spool caps, etc.) are being cut. AF-100
• Grasp empty spool with one
hand and spool housing with
other abrasive surfaces or heavier weeds are available through Black & Decker service centers.
When using the tool, retract the wire edge guide to...
Type 1 Manual - GH610 - Page 9
• If lever (q) (figure 12) in base of housing becomes 12
dislodged, replace in correct
position before inserting new
spool into housing.
• Remove any dirt and grass
from the spool and housing.
• Unfasten the end of
the cutting line at the end of the
cutting line and guide the line
into the eyelet (r) figure 13...
Type 1 Manual - GH610 - Page 10
... clean to wind the line on the spool neatly so that the spool housing can rotate freely. IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be cleaned by authorized service centers or other qualified service organizations, always using a mild soap and a damp rag. 4. Replace the spool into place. • If the cutting line...
Type 1 Manual - GH610 - Page 11
... your local service location, refer to a Black & Decker owned or authorized Service Center for commercial use.
11
Imported by Black & Decker (U.S.) Inc.,
701 E. Black & Decker owned and authorized Service Centers are beyond the time set for Service & Sales Should you . Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker location nearest...
Black & Decker GH610 Reviews
We have not received any reviews for Black & Decker yet.