Asus RS724QA-E6 RS12 Support and Manuals
Get Help and Manuals for this Asus item
This item is in your list!
View All Support Options Below
Free Asus RS724QA-E6 RS12 manuals!
Problems with Asus RS724QA-E6 RS12?
Ask a Question
Free Asus RS724QA-E6 RS12 manuals!
Problems with Asus RS724QA-E6 RS12?
Ask a Question
Popular Asus RS724QA-E6 RS12 Manual Pages
User Guide - Page 6
... a word or phrase is defined in this manual, it is italicized.
In all, a maximum of document. Revision History
Document Number Version/Date DB15-000357-01 Version 1.1
April 2007
DB15-000357-00 Version 1.0 January 2006
Remarks
Documented the following updated Integrated RAID support: • Support for manufacturing use only). Hexadecimal numbers are indicated...
User Guide - Page 7
...Features
1-2
1.3 Using this Manual
1-3
Chapter 2
Overview of Integrated Mirroring and Integrated Mirroring Enhanced
2.1 Introduction
2-1
2.2 IM and IME Features
2-2
2.3 IM/IME Description
2-3
2.4 Integrated RAID Firmware
2-5
2.4.1 Resynchronization with Concurrent Host I/O
Operation
2-5
2.4.2 Metadata Support
2-5
2.4.3 Hot Swapping
2-6
2.4.4 SMART Support
2-6
2.4.5 Hot Spare...
User Guide - Page 13
...8226; Section 1.3, "Using this Manual," page 1-3
You can use the LSI Integrated RAID solution with two to ten disks, plus hot spare disks.
• Integrated Striping (IS), which supports striped arrays with the following LSI ..., and/or redundancy of the LSI Integrated RAID solution for SAS User's Guide
1-1
Version 1.1
Copyright © 2006, 2007 by LSI Logic Corporation. Integrated RAID for ...
User Guide - Page 17
... Section 2.3, "IM/IME Description," page 2-3 • Section 2.4, "Integrated RAID Firmware," page 2-5 • Section 2.5, "Fusion-MPT Support," page 2-7
2.1 Introduction
As a result of the LSI Integrated Mirroring (IM) and... hot swap capability allows you to provide fault-tolerant protection for SAS User's Guide
2-1
Version 1.1
Copyright © 2006, 2007 by simply swapping disks. Chapter...
User Guide - Page 19
... shown in Figure 2.1. • Fusion-MPT architecture. • Easy-to-use BIOS-based configuration utility. • Error notification: the drivers update an OS-specific event log. • SES status LED support. • Write journaling, which allows automatic synchronization of
potentially inconsistent data after unexpected power-down situations. • Metadata...
User Guide - Page 21
...disk is queried to read the stored metadata in the volume.
2.4.2 Metadata Support
The firmware supports metadata, which describes the IM/IME logical drive configuration stored on ... IM and IME volumes during initial setup and to reconfigure them in response to hardware failures or changes in the environment.
2.4 Integrated RAID Firmware
This section describes features of the ...
User Guide - Page 26
...1.1
Copyright © 2006, 2007 by LSI Logic Corporation.
An IME volume can create one is part of the Fusion-MPT BIOS. All rights reserved. After you do this case, the SAS BIOS ...the IM/IME volume(s).
SAS and SATA disks cannot be either SATA (with extended command set support) or SAS (with SMART support). 3.2 Creating IM and IME Volumes
The SAS BIOS CU is available.
Note:
If ...
User Guide - Page 27
... in Figure 3.1. SAS1068
Adapter PCI Slot PCI Address(Bus/Dev/Func) MPT Firmware Revision SAS Address Status Boot Order Boot Support
SAS1068 03 03:00:00 00.03.23.00-IT 500605B0:0000C580 Enabled 1... an LSI SAS adapter.
2.
All rights reserved. Figure 3.1 Adapter Properties Screen
LSI Logic MPT Setup Utility vx.xx.xx.xx Adapter Properties -- On the Adapter Properties screen, use the arrow keys...
User Guide - Page 31
...the disk type must also be either SATA with extended command set support or SAS with SMART support.
Figure 3.3 Manage Array Screen
LSI Logic MPT Setup Utility Manage Array -- SAS1068
Identifier Type Scan Order Size(MB)...delete a global hot spare:
1. If SATA disks are used in the IM/IME volume(s). An error message appears if the selected disk is not at least as large as the disks used for ...
User Guide - Page 34
...:
The LEDs on the disk drives will flash as part of the volume, the LED on the disk drive is preserved...is correctly configured and the drives or the disk enclosure supports disk location.
3.5.6 Selecting a Boot Disk
You can locate individual ... recovered.
Note:
After a volume has been deleted, it easier to set to Yes as described above if the firmware is turned off ...
User Guide - Page 43
There must be either SATA (with extended command set support) or SAS (with SMART support).
-
SAS1068
Adapter PCI Slot PCI Address(Bus/Dev/Func) MPT Firmware Revision SAS Address Status Boot Order Boot Support
SAS1068 03 03:00:00 00.03.23.00-IT 500605B0:0000C580 Enabled 1 [Enabled BIOS & OS]
RAID Properties SAS Topology Advanced Adapter...
User Guide - Page 46
...pause, the firmware deletes the array. To do this , move the cursor to Yes as part of the volume, the LED on the Manage Array screen. 2. All rights reserved.
The LED is...are several ways to do this :
• When you want to keep. Select Delete Array on the disk drive is set to the name of all disks are creating an IS volume, and a disk drive is flashing. The LEDs ...
User Guide - Page 47
.... In the SAS BIOS CU, select an adapter from the Adapter List.
2. This makes it easier to set BIOS boot device options and to the current boot disk and press Alt+B.
The boot designator will show the ... "Boot."
3. Note: The firmware must be only one boot disk. The current topology is supported, the bottom of the screen lists the Alt+B option. If a device is the key for the Alt...
User Guide - Page 50
... You cannot run CFGGEN in any library version compatibility problems that is fully EFI compatible. CFGGEN runs in Windows Pre-Installation Environment (WinPE) and is a statically linked Linux ...driver must be able to locate the controller and its interface registers. Linux - WinPE -
CFGGEN must support 32-bit BIOS services, including the PCI BIOS services. They can be installed...
User Guide - Page 64
...for this option is specified, a quick synchronization of CFGGEN, disables Integrated RAID functionality on the supported SAS controller chips.
All rights reserved. 6. Size of warnings and prompts.
An IME volume can have ...if this number of the SAS controller targeted by setting the MPI_IOUNITPAGE1_DISABLE_IR bit in the EFI version of new volume will be created.
Asus RS724QA-E6 RS12 Reviews
Do you have an experience with the Asus RS724QA-E6 RS12 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Asus yet.
Earn 750 points for your review!