Adaptec 1863700 Support and Manuals
Get Help and Manuals for this Adaptec item
View All Support Options Below
Free Adaptec 1863700 manuals!
Problems with Adaptec 1863700?
Ask a Question
Free Adaptec 1863700 manuals!
Problems with Adaptec 1863700?
Ask a Question
Popular Adaptec 1863700 Manual Pages
Installation Guide - Page 3
... installation guide explains how to
• Install the Adaptec SCSI Card 29160 • Set up to 15 SCSI devices-such as hard disk drives, scanners, and CD-ROM drives-to any Intel-based computer with 32-bit or 64-bit PCI expansion slots. When installed in a 32-bit PCI slot, the card automatically runs in a 32-bit PCI slot. Adaptec SCSI Card 29160
INTRODUCTION
The Adaptec SCSI Card 29160...
Installation Guide - Page 4
... Adaptec SCSI Card 29160 to support LVD SCSI devices at speeds up to 160 MBytes/sec on the primary LVD/SE segment while at the same time supporting Ultra (legacy) devices at the maximum possible rate (80 MBytes/sec for Ultra2 devices and 160 MBytes/sec for all attached LVD SCSI devices will drop to Ultra SCSI performance levels. Installation Guide...
Installation Guide - Page 6
... is a tower model, lay it on its side to make it easier to locate the PCI slots. press down firmly until the card clicks into the slot. STEP 4
Insert the Adaptec SCSI Card 29160 into the PCI expansion slot; If your computer manual to install the Adaptec SCSI Card 29160. Installation Guide
Computers may break if you force it into place, then replace the slot...
Installation Guide - Page 7
... for specific instructions. Terminators must be removed, or termination must have a terminator installed (or enabled). If you are usually set to 0. (Most SCSI hard disks are preset to the Adaptec SCSI Card 29160:
• Check the SCSI IDs • Terminate the Ends • Mount the Devices
Since setup can have a unique SCSI ID number ranging from a SCSI hard disk, make sure the SCSI ID...
Installation Guide - Page 9
... wires as shown below . This allows LVD SCSI devices to transfer data at the same time. Adaptec SCSI Card 29160
CONNECTING SCSI DEVICES
You can be sure to review Setting Up SCSI Devices on the Adaptec SCSI Card 29160 at their maximum speed. (See Bus Segments on the Adaptec SCSI Card 29160 on connecting devices, refer to the Adaptec SCSI Card 29160 User's Reference. To do this, use a 68...
Installation Guide - Page 11
... on the Back of the Device
STEP 1
Connecting Internal Ultra/Wide SCSI Devices
Connect internal Ultra/Wide SCSI devices to connect the devices:
Locate a 68-pin internal Wide SCSI cable.
11 Follow these steps to the 68-pin internal SE Wide SCSI connector. Adaptec SCSI Card 29160
STEP 4
Connect a power cable from your computer's internal power supply to...
Installation Guide - Page 13
Adaptec SCSI Card 29160
STEP 5
Connect a power cable from your computer's internal power supply to connect the devices:
Locate a 50-pin internal Ultra Narrow SCSI cable.
13 Follow these steps to each internal device. Power Cable...
Connecting Internal Ultra/Fast Narrow Devices
Connect internal Ultra/Fast Narrow SCSI devices that have standard 50-pin connectors to the 50-pin internal SE Narrow...
Installation Guide - Page 15
... Back of the Device
Connecting External SCSI Devices
Connect external LVD SCSI devices to the 68-pin external LVD/SE SCSI connector.
Power Cable (From the Power Supply Inside the Computer)
Power Input Connector on the Adaptec SCSI Card 29160.
68-pin External LVD/SE SCSI Connector
68-pin External LVD SCSI Cable
15 Adaptec SCSI Card 29160
STEP 5
Connect a power cable from...
Installation Guide - Page 17
... Set User's Guide and Adaptec SCSI Card 29160 User's Reference for instructions on either installing driver software when installing your operating system (for your operating system, or installing driver software when the operating system is supported by the operating system you are using, read the operating system manual or contact the operating system vendor for the Adaptec SCSI Card 29160...
Installation Guide - Page 18
Installation Guide
TROUBLESHOOTING
If you are still unable to resolve a problem, refer to the Adaptec SCSI Card 29160 User's Reference, or the Adaptec Web site at http:\\www.adaptec.com for more information.)
• Is the SCSI bus properly terminated? able length? (See the Adaptec SCSI Card 29160 User's Reference for additional troubleshooting information.
18 If you have any problems while ...
Installation Guide - Page 21
... standard AS/NZS 3548 set out by one or ... accordance with part 15 of the... Regulations. Adaptec, Inc. Adaptec SCSI Card 29160
Tested to...installed and used in a residential installation. However, if this device must accept any interference received, including interference that interference will not occur in a particular installation.
This device complies with the instruction manual...
User Reference - Page 7
... pathway that expands SCSI performance. A SCSI bus is an industry standard computer interface for use the built-in a
1 Note: Read the Adaptec SCSI Card 29160LP Installation Guide if you need instructions on the Adaptec SCSI Card 29160LP
The Adaptec SCSI Card 29160LP supports Ultra160 SCSI devices. This User's Reference provides information about troubleshooting, SCSI termination, and...
User Reference - Page 12
... on the My Computer icon on the Windows desktop.
2 Select Properties from the menu. 3 Click the Device Manager tab. 4 Double-click the SCSI Controller icon. Adaptec SCSI Card 29160LP User's Reference
How can I If the driver is listed as 29160, 29160N, and Ultra160 PCI SCSI Controller. To enable the driver 1 Double-click the Adaptec SCSI Card 29160LP software driver in Device Manager.
User Reference - Page 13
... Next to install. 4 Select SCSI controllers from the menu. 3 Click the Device Manager tab. 4 Double-click the Computer icon.
7 Note: .The 29160LP will not appear on the Models list when Adaptec is no SCSI Controller icon under Device Manager, or the software driver for the Adaptec SCSI Card 29160LP. 4 Follow the on-screen instructions.
and follow the instructions that appear on...
User Reference - Page 26
... you want it to scan the SCSI devices on , install the removable-media software driver and set to Enabled to allow the SCSI card BIOS to remove the media while the drive is on the SCSI bus (for example, CD-ROM drives) are treated as a hard disk drive. Options are supported by default.)
I Support Removable Disks Under BIOS as...
Adaptec 1863700 Reviews
We have not received any reviews for Adaptec yet.