AL1716W Service Guide
Page 3
..., SELECT, + , - 35% typical 18 VESA DDC2B DPMS H ±1kHz, V ±1 Hz 2 ACER AL1716W Go to interface board and LCD panel. The function key block will house the flat panel control logic, brightness... Brightness level at max & contrast level at default full white pattern test mode following spec. The interface block will provides the OSD control signal, power ON/OFF and LED indicator... EEPROM 24C02 EEPROM 24CL16 Power & Inverter AC 110/220V Input D-SUB Analog Video Input The LCD monitor will contain an interface board, a Power/Inverter board, and a function key board. The block...
..., SELECT, + , - 35% typical 18 VESA DDC2B DPMS H ±1kHz, V ±1 Hz 2 ACER AL1716W Go to interface board and LCD panel. The function key block will house the flat panel control logic, brightness... Brightness level at max & contrast level at default full white pattern test mode following spec. The interface block will provides the OSD control signal, power ON/OFF and LED indicator... EEPROM 24C02 EEPROM 24CL16 Power & Inverter AC 110/220V Input D-SUB Analog Video Input The LCD monitor will contain an interface board, a Power/Inverter board, and a function key board. The block...
AL1716W Service Guide
Page 9
...LCD Inspection: Put LCD panel on inspection table and illuminate the panel with contrast and brightness in front of monitor after at 0 viewing angle. It shall be no defined by panel spec, therefore, we don't define the specification for black luminance non-uniformity. 2.6.2 Contrast ratio (CR): The...by using a photometer (CA-210) to measure the maximum and minimum luminance in front of monitor after at an approximate distance 20 cm from contaminants, fingerprints, or defects in Table 4. 8 ACER AL1716W Go to max. Defect limits are at least 30 minutes warm up . Table 4....
...LCD Inspection: Put LCD panel on inspection table and illuminate the panel with contrast and brightness in front of monitor after at 0 viewing angle. It shall be no defined by panel spec, therefore, we don't define the specification for black luminance non-uniformity. 2.6.2 Contrast ratio (CR): The...by using a photometer (CA-210) to measure the maximum and minimum luminance in front of monitor after at an approximate distance 20 cm from contaminants, fingerprints, or defects in Table 4. 8 ACER AL1716W Go to max. Defect limits are at least 30 minutes warm up . Table 4....