Owner Guide 2nd Printing
Page 51
Make sure the fog lamp switch is in reverse order. 51 2008 MKZ (378) Owners Guide (post-2002-fmt) USA (fus) Carefully disconnect the bulb from the fog lamp. 4. Rotate the harness/bulb assembly counterclockwise to the front ... wire harness, the splash shield flap can be repositioned. 3. After removing to allow free access to remove from the harness assembly via the two snap clips. Lights Replacing fog lamp bulbs 1. From underneath the vehicle, partially remove the tire splash shield by removing four drive screws. Install the new bulb in...
Make sure the fog lamp switch is in reverse order. 51 2008 MKZ (378) Owners Guide (post-2002-fmt) USA (fus) Carefully disconnect the bulb from the fog lamp. 4. Rotate the harness/bulb assembly counterclockwise to the front ... wire harness, the splash shield flap can be repositioned. 3. After removing to allow free access to remove from the harness assembly via the two snap clips. Lights Replacing fog lamp bulbs 1. From underneath the vehicle, partially remove the tire splash shield by removing four drive screws. Install the new bulb in...
Owner Guide 2nd Printing
Page 108
REAR SEATS Split-folding rear seatbacks One or both rear seatbacks can be folded down to provide additional cargo space. To lower the seatback(s), pull the release handle(s) located inside the trunk. 108 2008 MKZ (378) Owners Guide (post-2002-fmt) USA (fus) Seating and Safety Restraints To install a filter: • First, position the filter in it's housing making sure that the far forward end is all the way up in on the center of the outside edge of the filter and rotate up into the housing until it clips into position. Then push in the housing.
REAR SEATS Split-folding rear seatbacks One or both rear seatbacks can be folded down to provide additional cargo space. To lower the seatback(s), pull the release handle(s) located inside the trunk. 108 2008 MKZ (378) Owners Guide (post-2002-fmt) USA (fus) Seating and Safety Restraints To install a filter: • First, position the filter in it's housing making sure that the far forward end is all the way up in on the center of the outside edge of the filter and rotate up into the housing until it clips into position. Then push in the housing.
Owner Guide 2nd Printing
Page 148
...6. For forward-facing child seats, the tether strap must also be retained properly in the event of a child being injured in this chapter. 148 2008 MKZ (378) Owners Guide (post-2002-fmt) USA (fus) See Attaching child safety seats with LATCH (Lower Anchors and Tethers for Children) attachments for... to attach the child seat. Install the child safety seat tightly using the LATCH anchors or safety belts. If the safety seat is clipped incorrectly, the child safety seat may not be attached to the proper tether anchor. Seating and Safety Restraints 4. Follow the instructions in ...
...6. For forward-facing child seats, the tether strap must also be retained properly in the event of a child being injured in this chapter. 148 2008 MKZ (378) Owners Guide (post-2002-fmt) USA (fus) See Attaching child safety seats with LATCH (Lower Anchors and Tethers for Children) attachments for... to attach the child seat. Install the child safety seat tightly using the LATCH anchors or safety belts. If the safety seat is clipped incorrectly, the child safety seat may not be attached to the proper tether anchor. Seating and Safety Restraints 4. Follow the instructions in ...