Whirlpool WET3300SQ Support Question
Whirlpool WET3300SQ Support Question
Find answers below for this question about Whirlpool WET3300SQ - 27" Stack Washer.Need a Whirlpool WET3300SQ manual? We have 2 online manuals for this item!
Question posted by daneyrich on January 12th, 2013
Washer Is Filling With Hot Instead Of Cold Water And Rinsing In Hot.
Unit is 3 years old
Current Answers
Related Whirlpool WET3300SQ Manual Pages
User Instructions - Page 1
...ndice / Table des matières
ASSISTANCE OR SERVICE 1 WASHER/DRYER SAFETY 2 WASHER USE 4 DRYER USE 5 WASHER/DRYER CARE 6 TROUBLESHOOTING WASHER 8 TROUBLESHOOTING DRYER 10 WARRANTY 12
AYUDA O SERVICIO TÉCNICO...by calling our Customer eXperience Center at www.whirlpool.com. ®
WASHER/DRYER USER INSTRUCTIONS
INSTRUCCIONES PARA EL USUARIO DE LA LAVADORA/SECADORA
INSTRUCTIONS D'...
User Instructions - Page 2
..., or to light any appliance. • Do not touch any phone in this or any other appliance.
-
Do not store or use any electrical switch; WASHER/DRYER SAFETY
Your safety and the safety of others . All safety messages will tell you what can be performed by a qualified installer, service agency, or...
User Instructions - Page 3
...exhaust hood.
3 HYDROGEN GAS IS EXPLOSIVE. Use the minimum recommended installation clearances found in a hot water system that you understand and have the skills to carry out.
■ Do not use fabric... shock, or injury to persons when using the washer/dryer, follow these instructions can result in death or fire. If the hot water system has not been used for grounding instructions. Failure...
User Instructions - Page 4
... so it can result in the rinse cycle.
Do not guess. Fire Hazard
Never place...and small items. Items should move easily through the wash water. When cleaning is complete, be removed in death, explosion...washer. Measure detergent and pour it into your dryer for safe use , but at least every 2 years, or when installing your dryer in the washer...washer fill and begin agitating the load.
User Instructions - Page 5
... foam, rubber, or plastic must be dried on it (even after the washer has started filling by turning the selector to start the washer.
See "Cleaning the Lint Screen."
2. Allow space for fabric. Use the...No washer can make some models)
■ In the final rinse ONLY, add fabric softener that has ever had any type of it stops. The signal will not agitate or spin with warm water....
User Instructions - Page 6
...Washer/Dryer Location
Keep washer/dryer area clear and free from items that contain unstable dyes, such as gasoline, away from dryer.
Remove dispenser by lint can stop before each load. Rinse dispenser under a warm water faucet, then replace it becomes clogged due to remove. 3. Water Inlet Hoses
Replace inlet hoses after 5 years...water deposits using hot water...Cleaning
Laundry ...
User Instructions - Page 7
... with 1 scoop or
capful of R.V.-type antifreeze in washer/dryer or reconnect power.
7 Cleaning should be removed every 2 years, or more often, depending on a spin setting for about 30 seconds to mix the antifreeze and water. 5.
To winterize washer/dryer 1. Run washer on both water faucets. 2. Unplug washer/dryer or disconnect power.
Disconnect the drain from the...
User Instructions - Page 8
... water splashing off the load. Do not remove ground prong.
Washer Operation
Washer won't run, fill, rinse ...laundry tubs, faucets, drainpipe, water pipes) for clothes to carry away 17 gal. (64 L) of basket holes.
■ Did you using an extension cord?
The fill or spray rinses can contribute to not fill completely? Check both the hot and cold water faucets turned on water...
User Instructions - Page 9
... enough detergent to relax wrinkles? Use cycles with the lid open ? Use cold rinse water.
■ Are the hot and cold water hoses reversed? Do not wrap items around the agitator? Do not drip fabric softener onto clothes.
■ Did you overload the washer? water remains in washer
■ Is the drain hose clogged, or the end of loads...
User Instructions - Page 10
...dry.
10 The wash load must be a thumping sound during washing.
■ Did you overload the washer? The drum may be turning, but you follow the manufacturer's care label instructions? If a problem ... caught between the drum and front or rear of the bleach dispenser when loading and unloading the washer (on top of the dryer? Do not place load items on some models). If the problem...
User Instructions - Page 11
... for the front of the dryer, and, for most installations, the rear of the dryer requires 5" (12.7 cm).
A minimum of 1" (2.5 cm) of airspace is too hot
■ Is the lint screen clogged with temperature below 45ºF (7ºC)?
Failure to follow these instructions can result in death, explosion, or fire.
■...
User Instructions - Page 12
....
8. WHIRLPOOL CORPORATION MAJOR APPLIANCE WARRANTY
ONE YEAR LIMITED WARRANTY
For one year from the date of purchase, when this... or replace appliance light bulbs, air filters or water filters.
Repairs when your appliance if it was ..."Troubleshooting" section of your major appliance is used for units operated outside the United States or Canada.
7. ITEMS WHIRLPOOL WILL NOT PAY FOR...
User Instructions - Page 1
... the Drain Hose 14 Plan Vent System 14 Install Vent System 15 Level Washer/Dryer 15 Connect Vent 15 Complete Installation 16
SEGURIDAD DE LA LAVADORA/SECADORA 17....
27" (69 CM) ELECTRIC WASHER/DRYER INSTALLATION INSTRUCTIONS
INSTRUCCIONES DE INSTALACIÓN DE LA LAVADORA/ SECADORA ELÉCTRICA DE 27" (69 CM)
INSTRUCTIONS D'INSTALLATION LAVEUSE/SÉCHEUSE ÉLECTRIQUE DE 27" ...
User Instructions - Page 2
...and "Venting Requirements" before starting installation. If You Have
You Will Need to Buy
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system (if not already ...water fill hoses: 6 ft (1.8 m) Part Number 76314, 10 ft (3.0 m) Part Number 350008
D
E
A. A
B
C
Alternate Parts
Your installation may require additional parts. For information on the front page of the Washer...
User Instructions - Page 3
... information. Contact your washer in .2 (155 cm2)
1" 27"
1"
1"* 32"
5"**
(2.5 cm) (68.6 cm) (2.5 cm) (2.5 cm) (81.3 cm) (12.7 cm)
A
B
C
3" (7.6 cm)
A.
See "Washer/Dryer Care" in ... location must conform to the washer.
■ Hot and cold water faucets located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of the washer/dryer in the top and...
User Instructions - Page 4
...The standpipe drain requires a minimum diameter standpipe of 2" (5 cm). The top of the laundry tub must determine the type of electrical connection you will be using and follow the instructions ...high and no less than 96" (2.4 m) from the bottom of the washer.
39" (99 cm)
A
B
Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity. See "Alternate Parts...
User Instructions - Page 12
... "CLAMP." You will use any object that may result in back or other than water. 3. Release clamp. Tilt the washer/dryer back and remove the wood block. This is required for the words "CUT HERE." Gently lower the washer/dryer to secure the drain hose.
12
5. Discard end with
a wood block or similar...
User Instructions - Page 13
... the washer. 6. Remove the access panel by hand until it is in the couplings.
Coupling B. Attach hose to the bottom inlet valve. thirds turn . Set panel, screw, and bumper aside.
To keep drain water from under "Tools and Parts." Cold water inlet valve (top) B. NOTE: Replace inlet hoses after 5 years of the laundry tub. For laundry tub...
User Instructions - Page 14
... and remove any cardboard used to the laundry tub leg or standpipe with one standard elbow C.
If your washer/dryer was previously exhausted from the right or...instructions in the standpipe. A
B
C
If the water faucets and the drain standpipe are shown.
Rear exhaust for your washer/dryer. Wrap the drain hose to move the washer/dryer.
2.
Wall
E. Shipping strap
3. Push ...
User Instructions - Page 16
...the dryer has been running or "On" position.
■ Start button has been firmly pushed.
■ Washer/dryer is plugged into a grounded outlet.
■ Electrical supply is connected.
■ Household fuse is intact...transported.
4. This odor is common when the heating element is first used. Check that the water faucets are intact and tight, or that you do so can result in a running for...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer is not cleaning laundry - Cabrio® washer with agitator
... liquid fabric softener into garments requiring cold water rinses. See max fill line arrows on dispenser. Use the fabric softener dispenser provided with most cycles. Check your fabric softener dispenser. Use only liquid fabric softener in this washer. Are the hot and cold water inlet hoses reversed? Detergent works by filling the dispenser with this dispenser... -
Washer is not cleaning laundry - Top-load HE washer with Dispensers in Corners
... your product model number in cold or hard water. Are the hot and cold water inlet hoses reversed? Did you may notice that the cold-water inlet hose is automatically added during the rinse portion of iron in Corners Washer is not cleaning laundry - Use your loads have a high level of the cycle. See Max-fill-line arrows on clothes... -
Washer is not cleaning laundry - Top-load HE washer with Dispenser Drawer - video
... the hot-water fill hose is connected to the hot faucet and the cold-water fill hose is on the lid lock. You will hear a click, the basket will make soil removal easier. Use more detergent for the load size. Reversed inlet hoses can select the Deep Clean option with Dispensers in high efficiency washers...
Similar Questions
Washer Ywet3300sq1 Stops Mid Cycle And Wont Fill Water To Rinse?
How do I repair it?
How do I repair it?
(Posted by Kfomai 8 years ago)
Whirlpool Wet3300sq1 Washer/dryer Combo
I have the above model washer/Dryer combo and i just replaced the harness and the motor. The belt br...
I have the above model washer/Dryer combo and i just replaced the harness and the motor. The belt br...
(Posted by emmersonalleyne 12 years ago)
Whirlpool Wet3300sq1 Washer/dryer
I have the above model washer/Dryer combo and i just replaced the harness and the motor. The belt br...
I have the above model washer/Dryer combo and i just replaced the harness and the motor. The belt br...
(Posted by emmersonalleyne 12 years ago)
Washer Will Not Wash Or Rinse And Drain Water.
My washer will fill up with water and then once the load is full with water, the process stops. It d...
My washer will fill up with water and then once the load is full with water, the process stops. It d...
(Posted by irishk4 13 years ago)