Whirlpool WET3300SQ Support Question
Whirlpool WET3300SQ Support Question
Find answers below for this question about Whirlpool WET3300SQ - 27" Stack Washer.Need a Whirlpool WET3300SQ manual? We have 2 online manuals for this item!
Question posted by mjfolger on October 7th, 2011
Adding Detergent?
Does detergent go into the tank of the washer for WET3300SQ2 or into the cup on top of the central column?
Current Answers
Related Whirlpool WET3300SQ Manual Pages
User Instructions - Page 1
....
You will need assistance or service, first see the "Troubleshooting" section.
In Canada, for assistance, installation or service, call us at www.whirlpool.com. ®
WASHER/DRYER USER INSTRUCTIONS
INSTRUCCIONES PARA EL USUARIO DE LA LAVADORA/SECADORA
INSTRUCTIONS D'UTILISATION DE LA LAVEUSE/SÉCHEUSE
Table of purchase or installation date for...
User Instructions - Page 2
.... Always read and obey all occupants. • Immediately call the fire department.
-
Follow the gas supplier's
instructions.
• If you and others are not followed. WASHER/DRYER SAFETY
Your safety and the safety of others . All safety messages will tell you what the potential hazard is the safety alert symbol. do...
User Instructions - Page 3
... flow. Items contaminated with controls.
■ Clean dryer lint screen before using the washer/dryer, follow these instructions can result in the Installation Instructions. SAVE THESE INSTRUCTIONS
Checking Your... Vent
Your dryer must be properly installed and vented to persons when using the washer/dryer.
■ Do not place items exposed to play on all instructions before ...
User Instructions - Page 4
... shirts 2 pillowcases
COMPACT WASHERS
Heavy Work Clothes
2 pair of pants 3 shirts
Mixed Load
1 pair of clothes loosely into the washer. Use a cup with a fabric softener dispenser installed.
4
NOTE: Your washer/dryer does not come with... water. Do not use duct tape, screws or other flammable fluids. Measure detergent and pour it can result in the rinse cycle. 3. Use clamps to...
User Instructions - Page 5
...it (even after the washer has started filling by filling the dispenser with ¹⁄₂ to 1 cup (125 to 250 mL...7. Softener is added automatically during the rinse portion of the Start button and is set to start the washer. Dilute liquid ...the washer lid. Follow garment label instructions. NOTE: In wash water temperatures colder than 60ºF (15.6ºC), detergents do ...
User Instructions - Page 6
... with hot water. 3. Occasionally wipe the outside of your washer to OFF. Remove dispenser by mixing 1 cup (250 mL) of chlorine bleach and 2 scoops or caps...washer safe. Every Load Cleaning
Style 1: 1. Wet lint is hard to a residue buildup. 1. The lint screen is located inside the dryer on some models): 1.
Roll lint off the screen with your fingers. As Needed Cleaning
Laundry detergent...
User Instructions - Page 7
...
Electrical Shock Hazard
Plug into a grounded 3 prong outlet. Run the washer through a complete cycle with 1 scoop or
capful of detergent to clean the washer and remove the antifreeze, if used. Non-use an adapter. Run the washer through a complete cycle with 1 cup (250 mL) of detergent to clean out antifreeze. Shut off the water supply to...
User Instructions - Page 8
... and check for clothes to the drainpipe or laundry tub. The fill or spray rinses can contribute to noise and vibration of the washer.
Washer Operation
Washer won't run, fill, rinse or agitate;... circuit breaker. The drain hose should be able to follow the manufacturer's directions when adding fabric softener to start. Center the tub before spin, or is normal and necessary for...
User Instructions - Page 9
...washer? Use enough detergent to remove soil and hold the lint in water? water remains in the load if overloaded.
The water level should be correct for the load. If so, you follow the manufacturer's directions when adding detergent.... The lid must be under water.
■ Did you use less detergent. Washer will cause wrinkling. This is normal. The wash load must be balanced ...
User Instructions - Page 10
... paper clip caught between the drum and front or rear of the bleach dispenser when loading and unloading the washer (on the supply line? Do not use more than than the manufacturer's recommended amount for a while,...back and side to Timed or Air Dry? The dryer may be turning, but you overload the washer? When balled up ? Timer does not noticeably advance
■ Is the dryer set to avoid ...
User Instructions - Page 11
... cycles requires temperatures above the floor for 5-10 minutes. See the Installation Instructions.
■ Is the exhaust vent diameter the correct size? Fabric softener sheets added to do not feel air movement, clean exhaust system of the door. This will be cleaned before each load. Loads are gone from dryer. Proper...
User Instructions - Page 12
...WHIRLPOOL WILL NOT PAY FOR
1. Pickup and delivery. Outside the 50 United States and Canada, this document.
12
Service calls to correct the ...to parts or systems resulting from unauthorized modifications made with the same precision used for units operated outside the United States or Canada.
7.
After checking "Troubleshooting," additional help
can be repaired in...
User Instructions - Page 1
...reduce the chance of Contents / Índice / Table des matières
WASHER/DRYER SAFETY 1
INSTALLATION INSTRUCTIONS 2 Tools and Parts 2 Alternate Parts 2 Location ...27" (69 CM) ELECTRIC WASHER/DRYER INSTALLATION INSTRUCTIONS
INSTRUCCIONES DE INSTALACIÓN DE LA LAVADORA/ SECADORA ELÉCTRICA DE 27" (69 CM)
INSTRUCTIONS D'INSTALLATION LAVEUSE/SÉCHEUSE ÉLECTRIQUE DE 27...
User Instructions - Page 2
...for new vent
installations)
Parts supplied:
Remove parts package from whom you purchased your washer/dryer. See "Remove Shipping Strap.")
E. Mobile home installations require metal exhaust system hardware..." and "Venting Requirements" before starting installation. If You Have
You Will Need to Buy
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system (if not already available)...
User Instructions - Page 3
... in low temperatures.
closet or confined area C. The installation must be exposed to open fully.
*32" (81.3 cm)
27" (68.6 cm)
*Most installations require a minimum 5" (12.7 cm) clearance behind the dryer for this washer/dryer. Installing on carpet is recommended to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part...
User Instructions - Page 4
... secured under the neutral terminal (center or white wire) of the washer.
39" (99 cm)
A
B
Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity. Only" ...A & B) The standpipe drain requires a minimum diameter standpipe of the line. It is your washer/dryer, you must be used , it is recommended that a qualified electrician determine that the electrical...
User Instructions - Page 13
... is seated on the water faucets and check for leaks ■ Turn on the washer. 6. Complete hookup of washer/dryer installation.
Attach hose to the washer 1.
Hot water inlet valve (bottom)
4.
A small amount
of hose failure. Insert a new flat washer into laundry tub or standpipe.
NOTE: Replace inlet hoses after 5 years of use old hoses...
User Instructions - Page 14
...or left side, it can be added:
692790 (white)
3977784 (biscuit)
Follow the instructions in the kit to the manufacturer's instructions provided with one of the Washer/Dryer User Instructions. ■ Over...to 29" (73.66 cm) mismatch
Part Number 4396014 - 29" (73.66 cm) to the laundry tub leg or standpipe with standard elbows B. Please reference the "Assistance or Service" section of the ...
User Instructions - Page 15
...best drying performance
■ Use the Vent system chart below to a noncombustible portion of the washer/dryer with a 4" (10.2 cm) clamp.
2. NOTE: It may be securely fastened... (11.3 m) 35 ft (10.7 m)
Flexible metal 25 ft (7.6 m) 20 ft (6.1 m)
1
Rigid metal
32 ft (9.7 m) 27 ft (8.2 m)
Flexible metal 21 ft (6.4 m) 16 ft (4.9 m)
2
Rigid metal
24 ft (7.3 m) 19 ft (5.8 m)
Flexible metal...
User Instructions - Page 16
.... This odor is common when the heating element is not crushed or kinked.
5. Read the Washer/Dryer User Instructions.
3. Be sure the vent is first used. In the U.S.A. ■ For... notice a burning odor when dryer is still no heat, contact a qualified technician.
7. Dispose of detergent and pour it into a grounded outlet.
■ Electrical supply is connected.
■ Household fuse ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How do I clean my microwave oven?
...tips Odors: Lemon juice or vinegar: Heat one cup (250 mL) of water with lemon juice or vinegar. Use only mild, nonabrasive soaps or a mild detergent. How do I clean the racks in the Order ...and the oven is cool. Wipe well with a mild detergent and a soft or nylon scrub brush. To get rid of odors inside the oven, boil a cup of grain to keep your stainless steel surface see, ... -
Detergent remains in the dispenser
... suds that kept it is left sitting in soft water, glassware will etch. Fresh automatic dishwasher detergent results in the dispenser after a cycle? The amount of detergent. Amounts may vary if you added detergent? Was the dispenser cup wet when you use too little, dishes won't be 120 o F (49 C) as it from opening How... -
Detergent is on the load - Top-load washer
... not allow it to completely dissolve. Older laundry detergent does not dissolve well in the washer to allow the detergent to use liquid detergent for the load. Keep detergent containers closed to clean well at temperatures above 60°F (15.5°C). Adding detergent directly on the load in my top-load washer. Washer is tightly packed in low-speed wash...
Similar Questions
Stackable Washer Dryer 27'
Does the dryer vent from the back or the top?
Does the dryer vent from the back or the top?
(Posted by ChrisMRadke 8 years ago)
How To Replace Lid Switch On Whirlpool Stacked Washer Dryer, Wet3300sq1
(Posted by highgary 9 years ago)
Age Of This Stack Washer Is???
(Posted by PHILJBRO 11 years ago)
Whirlpool Wet3300sq1 Washer/dryer Combo
I have the above model washer/Dryer combo and i just replaced the harness and the motor. The belt br...
I have the above model washer/Dryer combo and i just replaced the harness and the motor. The belt br...
(Posted by emmersonalleyne 12 years ago)
Washer Will Not Wash Or Rinse And Drain Water.
My washer will fill up with water and then once the load is full with water, the process stops. It d...
My washer will fill up with water and then once the load is full with water, the process stops. It d...
(Posted by irishk4 13 years ago)