Vtech CS6228-3 Support Question
Vtech CS6228-3 Support Question
Find answers below for this question about Vtech CS6228-3.Need a Vtech CS6228-3 manual? We have 1 online manual for this item!
Question posted by sperry2811 on June 30th, 2011
Line In Use
I have a Dect 6.0 CS6228 with five phones. This morning all phones indicate "line in use". I upplugged all power cords, unplugged all batteries, unplugged main telephone line, etc. no good. Still get line in use. Did the same with all other devices, i.e. fax printer, other unused outlets, etc.
Current Answers
Related Vtech CS6228-3 Manual Pages
User Manual - Page 5
...
Charger and charger adapter
(1 for CS6229-2, 2 for CS6228-3 and CS6229-3, 3 for CS6229-4, 4 for CS6228-5 and CS6229-5, and 5 for CS6228-6)
Telephone line cord
Telephone base power adapter
Battery
(1 for CS6229, 2 for CS6229-2, 3 for CS6228-3 and CS6229-3, 4 for CS6229-4, 5 for CS6228-5 and CS6229-5, and 6 for CS6228-6)
Battery compartment cover
(1 for CS6229, 2 for CS6229-2, 3 for...
User Manual - Page 6
...800) 5959511. The filter prevents noise and caller ID problems caused by a wall switch
Telephone base
Charger
Use only the power adapters supplied with this product.
Telephone line cord
Telephone base power adapter
Charger adapter Electrical outlet not controlled by DSL interference. Contact your telephone line, you subscribe to be correctly oriented in place if it is plugged into...
User Manual - Page 8
... power cord out of the bottom of the telephone base (marked B). If you do not have this mounting plate, you are using a DSL filter, plug the line cord into place.
2. Plug the telephone line cord (or DSL filter) into a power outlet not controlled by a wall switch.
4. Push the telephone base down until it locks securely. Bundle the telephone line cord and power adapter cord...
User Manual - Page 9
See Telephone base and charger installation on page 2.
Unplug the power adapter from the wall.
If the telephone line cord and power adapter cord are bundled, untie
them first. 2. Unplug the telephone line cord (or DSL filter) from the power outlet. 3. Lift the telephone base up to table top installation 1. Getting started
Wall mount to detach it from the black plastic wall ...
User Manual - Page 11
...31). When the phone is not in use , press twice to adjust the telephone base ringer volume (page 30). X/DELETE Press to the next message (page 31).
When the phone is not in use , press to... is in use .
ANS ON/OFF Press to play previous message (page 31). IN USE light Flashes when there is an incoming call, or another telephone sharing the same line is in use . FIND HANDSET...
User Manual - Page 14
... entry.
4.
HOME AREA CODE 800
3. To manually turn on both the handset and telephone base turn off automatically. ANS.
Home area code
If you dial your local calls using your answering system.
Use the clear voicemail feature when the telephone indicates that when you have accessed your
voicemail while away from answering system messages recorded...
User Manual - Page 19
... MENU/SELECT and then press to select >DIRECTORY. 2. Chain dialing can be useful when accessing numbers other than phone numbers (such as bank account information or access codes). Press MENU/SELECT twice ...Press MENU/SELECT to dial the displayed number. Telephone operation
Chain dialing Use this feature while already dialing one phone number or while on a call to initiate a dialing ...
User Manual - Page 39
...LINE IN USE
A system handset or another handset.
Appendix
Handset display screen messages
ALREADY SAVED
The telephone number entered is already stored in use.
The other party cannot hear you but you can hear the other end can hear you.
The cordless.... CHARGING
The handset with low battery is full.
LOW BATTERY
The battery needs to be recharged. INTERCOM
The handset is an incoming...
User Manual - Page 40
... is very low. The battery is on an outside call.
The cordless handset locator is muted temporarily...use. You are unreviewed calls in the telephone base or charger for recharging.
Communication between handset and telephone base is no name or number.
Appendix
Handset display screen messages
NO LINE NO SIGNAL, CALL ENDED
NOT AVAILABLE AT THIS TIME OUTSIDE CALL
**PAGING** PHONE...
User Manual - Page 41
... base or charger.
Speakerphone is turned on .
New call or another telephone sharing the same line is in use .
(Battery indicator)
Cycles (low, medium, and full) when the handset battery is charging in use . New voicemail received from your telephone service provider.
Flashes when the battery is fully charged.
37
CHARGE
On when the handset is charging.
Message number...
User Manual - Page 45
... in the handset for recharging. • Remove and reinstall the battery and use . • Make sure the power adapter is securely plugged into the telephone base and the
telephone wall jack. • Unplug the electrical power to 16 hours. • If the handset is in the telephone base or charger but the CHARGE light on the
handset is...
User Manual - Page 46
....
42
Move it back in the wiring or local service. Contact your cordless telephone. If another telephone has the same problem, the problem is
in . Install a new telephone line cord. • Reinstall the battery and place the handset in correctly
and securely. • Unplug the power adapter. Allow up to one minute for 15 seconds before plugging it closer...
User Manual - Page 47
... protector) into a different working electrical outlet not controlled by unplugging the electrical power to the base. My calls fade out when I cannot dial out.
• First, try all the above suggestions. • Make sure there is plugged in your cordless telephone. Appendix
Troubleshooting
I am using the cordless handset.
• The handset may be out of range...
User Manual - Page 48
...problem is probably in the wiring or local service.
DSL)
through
your and the caller's telephone service providers must install a DSL filter between the telephone line cord and the telephone wall jack. Plug in a centralized location within your cordless phone. Call your telephone service provider (charges may apply). The filter prevents noise and caller ID problems caused by...
User Manual - Page 49
... system and voicemail indication. If
you need to the telephone base. • Make sure the power cord is separate from communicating with each alerts you to use the Home area code feature (page 10). Place the handset in answering
system.
The messages on the answering system are independent features and each other cordless telephones. Appendix
Troubleshooting
Caller...
User Manual - Page 50
...rings changes to two when there are deleted. • If you subscribe to the same telephone line, try disconnecting the fax machine.
Appendix
Troubleshooting
The answering system does not answer after the ... affected by the ringing system used by your telephone service provider. • If you subscribe to the same telephone line, try disconnecting the fax machine. The messages on .
User Manual - Page 51
... service provider for electronic equipment. • If the telephone is not responding normally, put the cordless handset in the order listed): • Disconnect the power to the telephone base. • Disconnect the battery on your computer may not have enough power. Do not plug into a dedicated USB port on the telephone line you are calling from a touch-tone...
User Manual - Page 52
...
Important safety instructions
When using a telephone (other than specified access doors may be walked on the product. 10. Read and understand all warnings and instructions marked on the power cord. Unplug this product near or over a radiator or heat register. Only put the handset of the telephone base or handset other than cordless) during an electrical storm...
User Manual - Page 53
... fall into the water, DO NOT RETRIEVE IT UNTIL YOU UNPLUG THE POWER CORD AND TELEPHONE LINE CORD FROM THE WALL. If there is out of your telephone if you ever need to answer the call while the handset is out of range during storms. Cleaning your telephone Your cordless telephone contains sophisticated electronic parts, so it with wet hands...
User Manual - Page 57
...telephone service provider. In most, but not all RENs should normally be used for connecting to a single line and an RJ14 jack for the amount of radio frequency energy that to which can only be unplugged... the requirements for help. A compliant telephone cord and modular plug is provided with this equipment to premises wiring and the telephone network must comply with the instructions, ...
Similar Questions
At And T Cordless Phone Out Of Range No Power At Base How To Reset
(Posted by kaytalexa 10 years ago)
Vtech Cordless Phone Question
I have a vtech cordless phone and everytime I press talk to answer the phone call it freezes my tv s...
I have a vtech cordless phone and everytime I press talk to answer the phone call it freezes my tv s...
(Posted by alicianadiamacdonald 10 years ago)
Replacement Wall Bracket For Vtech Ds6222-5 Cordless Phone
Need a replacement wall bracket for Vtech DS6222-5 base cordless phone.
Need a replacement wall bracket for Vtech DS6222-5 base cordless phone.
(Posted by yalefreiman 11 years ago)
Syncing Cordless Phones
Can u sync any vtech 6.0 cordless phone to another- as in the base? Or does it have to be the sa...
Can u sync any vtech 6.0 cordless phone to another- as in the base? Or does it have to be the sa...
(Posted by chloesmom2010 12 years ago)
V-tech Cs5111 Cordless Phone Question
I am about to purchase 10 V-tech CS5111 5.8 GHz cordless phones. If they are used in the same room ,...
I am about to purchase 10 V-tech CS5111 5.8 GHz cordless phones. If they are used in the same room ,...
(Posted by elwcdrd 14 years ago)