Uniden UDR744 Support Question
Uniden UDR744 Support Question
Find answers below for this question about Uniden UDR744.Need a Uniden UDR744 manual? We have 3 online manuals for this item!
Question posted by swinstrand on October 26th, 2019
My Monitor
My monitor flips black and beeps and then back on. When it goes black it says out of range but then turns back on and works for a while then turns black and beeps and then on again. What is causing that
Current Answers
Answer #1: Posted by Sana12 on October 26th, 2019 10:05 PM
Sana12
Member since:
October 26th, 2019 Points: 1,100
Member since:
October 26th, 2019 Points: 1,100
Common and Easily Fixed Beeping Computer Problems1.
Check the keyboard to ensure that there are no stuck keys and no keys are being held down. Sometimes a keyboard drawer can press a key against the underside of a desk. Run your fingers over the keyboard to free any keys that may be stuck. If a drink was spilled on the keyboard, replace the keyboard with a new one. Try to start the computer again after completing this and each of the following steps.
2.Check all cables connected to the computer and make sure they are fully plugged in. Inspect each cable and securely connect or tighten cables as required.
3.Remove any objects blocking the computer's air vents. If dust has accumulated in any vent, vacuum the exterior vents and carefully vacuum dust from the heat sinks and vents inside the computer.
Related Uniden UDR744 Manual Pages
English Owner's Manual - Page 3
... 5 USING THIS MANUAL 5 FEATURE LIST 5 WHAT'S INCLUDED 7
GETTING TO KNOW THE UDR744 SYSTEM 8 HARDWARE...8 UDR744 Monitor 8 UDR744 Camera 9 SET UP THE HARDWARE 10 Monitor...10 Camera...10 install Cameras 11 MONITOR SCREEN 11 UDR744 OPERATION 12 Live View Screen 13 UDR744 Live Screen Icons 13
UDR744 SCREEN DESCRIPTIONS 18 OVERVIEW...18 PLAYBACK...18 ALARM...20 BRIGHTNESS 20 GENERAL...
English Owner's Manual - Page 6
•• One LCD monitor can pair four cameras •• LCD : 5v DC 2A Power adaptor (+/-5%) •• Camera: 9v DC 600mA (+/-5%) •• RF range: 150 meter (Line of sight) •• New recording indicator/ Memory card full indicator •• Quad view •• PIR trigger and Video motion ...
English Owner's Manual - Page 7
...
You should have the following items:
(1) UDR744 Monitor
(2) Camera with stand
Not Shown: • (1) 5V 2A Power Adapter
(Monitor) • (1) Ethernet (RJ45) Cable • 8G SD Card • (1) 2000mA Battery
(Monitor) • Mounting Hardware (2
sets) • Quick Start Guide
(2) 9V 600mA Power Adapter (Camera)
(2) Antenna (may be attached to camera)
If any items are missing or damaged...
English Owner's Manual - Page 8
Microphone Wireless Antenna Power Button/ Scan Button: Press and hold to turn Scan mode on /off .
Receiver Stand. Battery Cover Speaker
Power ... using the included power adapter. GETTING TO KNOW THE UDR744 SYSTEM
HARDWARE
UDR744 MONITOR
1
4
3
2 5 6
7
8
9
10
11 12 13
14
15
No. 1 2 3 4
5 6 7
8
9 10 8
What it is powered on to turn the receiver on /off . Press and release while the...
English Owner's Manual - Page 9
... LED
On - Infrared IEDs provide viewing in low/ no light conditions. 3 Camera Lens: Catches the video in Scan mode. Monitor is low
UDR744 CAMERA
1
2 3 4 5
8
9 6
7
No. No. Battery power is in front of the camera. Press and hold to talk through the camera. What it is 1 Camera Antenna: Sends and receiveds signals to receiver. 6 Pair Button: The pair...
English Owner's Manual - Page 10
... emits detection signal to power it is recommended that will still work;
Water can reflect light from the receiver. 9 Adjustment screws: Adjusts the camera up .
Placement Considerations Consider the following when placing cameras:
10 CAMERA
General The UDR744 cameras included with a soft cloth. Although the cameras can create spots that , if they are powered up /down and...
English Owner's Manual - Page 11
... - MONITOR SCREEN
The UDR744 monitor's screen has 3 main parts:
•• Live View area. See
page 18 for the camera. Position the camera where you have the display handy. 1. The main screen area displays live video from the camera(s). •• Pop Out Menu Tab. it is securely in the view of -sight between the camera and monitor is...
English Owner's Manual - Page 12
...:
•• Quad mode splits the screen's image area into 4 quadrants and displays active camera video in its own section of screens that , the monitor screen turns off until there has been no motion for 15 seconds. UDR744 OPERATION
Your UDR744 monitor operates through a series of the screen (quadrant) or on and off .
to enter Single...
English Owner's Manual - Page 13
... example of what is removed to make it easier to the Live screen. UDR744 LIVE SCREEN ICONS Different icons display on the monitor screen depending on what could be on your screen (the video image is going on with your camera(s). LIVE VIEW SCREEN The Live View screen is ready to record video...
English Owner's Manual - Page 14
... Menu Tab
Date and Time
SD Card Camera Overwrite Number
Power Level
Network Connection
Status
Firmware Upload Available
Zoom
Microphone
Motion Recording Indicator
Change Channels
Volume
SEQ display mode
NOTE: Icons on the monitor actually display in blue. Tap this icon to 0 bars (out of range). If blue, recording space is inserted into...
English Owner's Manual - Page 15
... viewing multiple cameras at once, the camera indicator will appear above each video display. BATTERY INDICATOR
Indicates the LCD monitor's battery life: • Flashing Red -
Charging
15
Current date/time in progress.
System is connected to overwrite files when it does New recordings are currently viewing. Full battery • Flashing Green - UDR744 Icon
NEW...
English Owner's Manual - Page 16
...firmware is pressed.
Tap the area you tap this icon to talk back through the camera. Tap the icon again to raise or lower the volume. TALK BACK INDICATOR
Displays.... • Blue -
SEQUENCE INDICATOR
Displays when the monitor is off (mute). it does
When you want to wait for a reply.
UDR744 Icon
ZOOM INDICATOR
What it will change channels automatically. ...
English Owner's Manual - Page 22
... record. Choices are 15 seconds, 30 seconds, or 1 minute (Default - 15 seconds)
Schedule Recording Set up a schedule for the monitor and each camera. Set the time zone for your UDR744 system.
(see page 30)
• Enable/Disable Daylight Savings Time
Language (see page 32)
Displays firmware information for pre-determined recording times
(see...
English Owner's Manual - Page 36
... the ability to your selection and fill in the fields requested. Tap on your selection and fill in the fields requested. Tap on your UDR744 system. Reboot the monitor when prompted.
36 Your router will automatically assign an IP address to specify an IP address for their system.
4. Static IP is the...
English Owner's Manual - Page 40
...REQUIREMENTS
•• iOS or AndroidTM smartphone or tablet •• UDR744 monitor connected to the app. tap Click here to add device to add ...from an iPhone®, iPad®, or AndroidTM smartphone or tablet. Turn on the monitor.
2. Tap the icon to the Apple App Store or Google Play. Connect the UDR744 monitor to your system. Search for iOS and Android operations if needed;...
English Owner's Manual - Page 41
...manually enter this : ●● If your UDR744 monitor in the same network as the monitor, tap SCAN from the label on the back of the monitor. ●● Scan the QR code on ... ways to do not have a camera assigned to display the Network Information screen. The U Guard Camera List screen displays a listing for your monitor. Tap OK. The monitor screen shot is the last item on...
English Owner's Manual - Page 45
..., tap the red turns blue while recording.
There is also a table of other actions you can tap the Playback pop-up menu ( ). You can record from all cameras at the same time. Tap it again to perform the most commonly used actions for the camera to access recorded video files.
UDR744 OPERATION BASICS
This...
English Owner's Manual - Page 46
... view or on any area again to close it to the monitor (that does not have to "introduce" the camera and monitor to your UDR744 comes with the new one.
46 On the playback progress bar... If you tap on the recording you want to assign the new camera to, the monitor
overwrites the existing camera link with two cameras already paired to each other so they can fast forward/rewind by dragging...
English Owner's Manual - Page 48
UDR744 BASIC OPERATION
To do this ...
From ...turns
red and flashes, indicating
that recording has started.
2. Enter the schedule (or part of a schedule) you want to stop recording video
Set up automatic recording schedule
Delete recording schedule
From monitor, do this...
1. Manually start/stop recording.
Tap the icon again to delete and tap DELETE.
48 Select the camera...
English Owner's Manual - Page 52
... infrared light reflects off of the dust and grime, limiting the camera's "vision." Compare it into your SD card every 4 to the monitor.
1. Copy the current firmware to www.unidenvideo.com. 4. If there are files you need to update your UDR744 firmware, download the most current firmware version to your system firmware version...
Similar Questions
Why Does My Udr744 Monitor Keep Going Off And On?
Why does my Uniden UDR744 monitor keep going off and on?
Why does my Uniden UDR744 monitor keep going off and on?
(Posted by ccsewell04 6 years ago)
Will Not Record To The Monitor Or The App.
I have a uniden UDR744HD video system. About 2 months after i set it up, i began having problems wit...
I have a uniden UDR744HD video system. About 2 months after i set it up, i began having problems wit...
(Posted by krahlings 7 years ago)
Can I View It On My Pc Monitor Also Like My Phone?
can i view it on my PC monitor also like my phone?
can i view it on my PC monitor also like my phone?
(Posted by jmmorin 8 years ago)
I Returned My Security Camera And Monitor On 6/26 And Have Not Heard Anything On
alma Rhodes
alma Rhodes
(Posted by almarhodes 8 years ago)
Where Can I Get A User Manual For My Security Camera Udr744?
(Posted by Sdbuckroe 9 years ago)