Toshiba SD-V392 Support Question
Toshiba SD-V392 Support Question
Find answers below for this question about Toshiba SD-V392 - DVD/VCR Combo.Need a Toshiba SD-V392 manual? We have 1 online manual for this item!
Question posted by boricuabxny on August 8th, 2011
Cannot Get Set-up Instructions On My Tv For The Dvr670ku Dvd/vcr Unit
I have a brand new Toshiba VD Recorder/VCR model #DVR670KU unit which I proceeded to set up. Upon successful connection of the cables, I turned on my TV and the Toshiba unit to do the initial set up. However, the instructions for the set-up never appeared on my TV. I checked all the connections and tried pressing the DVD/TV button on the remote control unit without any luck. I replaced the Toshiba unit with the old DVD/VCR unit I was replacing and everything worked fine with that unit's set-up. Why can't I bring up the set-up instructions for the Toshiba DVD/VCR on my TV? I understand this is a common problem with this unit. Please advise. Thanks.
Current Answers
Related Toshiba SD-V392 Manual Pages
User Manual - Page 6
... use a chemical saturated cloth to contact the DVD/VCR for cleaning.
It's too warm!
If you use the DVD/VCR in a room where you use , be distorted. Do not leave rubber or plastic products to clean the unit, follow that product's instructions. Turn on the finish. To obtain a clear picture
The DVD/VCR is not a malfunction.
Do not use...
User Manual - Page 8
...DVD/VCR can play the following discs are printed on your DVD video disc and you do not find 1 or ALL , disc playback will not be allowed by the player. (In this case, the DVD/VCR... on the recording conditions. • This DVD/VCR uses the ...instructions of discs. Refer to all operating commands. Alternatively, the " " may not respond to instruction notes of this DVD/VCR. DVD-R/RW discs of DVD...
User Manual - Page 14
... using and follow these instructions.
Antenna to DVD/VCR connection
The DVD/VCR must be obtained by the DVD/VCR unless the antenna signal is good. Connections
Antenna connections
If you are using an antenna system, follow the connection diagram.
1
Combination VHF/UHF Antenna with 75 ohm Coaxial Cable
DVD/VCR
75 ohm Coaxial Cable
IN (ANT)
OUT (TV)
2
Combination VHF/UHF Antenna...
User Manual - Page 15
... supplied)
75 ohm Coaxial Cable (supplied)
Splitter 75 ohm Input 300 ohm outputs (not supplied)
TV
UHF VHF
Note:
If a VHF or UHF antenna is used , set the TV/CATV menu option to a TV. Below are 3 common methods of TV you must connect the DVD/VCR to a TV. Connections
DVD/VCR to TV connection
After you have connected the antenna to the DVD/VCR, you are using and...
User Manual - Page 16
... can be tuned to the converter output channel, usually channel 3 or 4.
3
Incoming Cable
DVD/VCR
IN (ANT) OUT (TV)
Converter/Descrambler
TV
VHF/UHF IN (ANT)
Allows: * Recording of nonscrambled channels. * Use of the DVD/VCR (either 3 or 4).
Connections
CATV (CABLE TV) connections
Many cable companies offer services permitting reception of the Converter/Descrambler box, usually channel...
User Manual - Page 17
...
IMPORTANT: Make sure the TV/CATV menu option is set to a cable system. Descrambler boxes are six common methods of connection.
4 Splitter
DVD/VCR
TV
IN (ANT)
Incoming Cable Converter/Descrambler
OUT
(TV)
A/B Switch
A B
VHF/UHF IN (ANT)
Allows: * Recording of one channel while watching another . * Using the programmable timer to receive scrambled programs, your existing descrambler...
User Manual - Page 18
... turn off the power and unplug both units from the wall outlet before
making any connections. • If your television set has one audio input, connect the left and right audio outputs of the DVD/VCR to a Y cable adapter (not
supplied) and then connect to your TV. • Connect the DVD/VCR directly to your TV. Note: This method transports VHS and DVD-video signals. Connections
Connecting...
User Manual - Page 19
... have component video inputs. In such a
case, adjust the TV or monitor for optimum performance. In this connection, set the S-VIDEO/ COMPONENT Video selector switch to the owner's manual of the connected equipment as well. • When you connect or disconnect the DVD/VCR's power cord. If you connect the DVD/VCR to other equipment, be distorted. Y, R-Y, B-Y or Y, CB, CR...
User Manual - Page 20
... realistic sound by connecting the DVD/VCR to a 6 channel amplifier equipped with a DTS decoder
"DTS" and "DTS Digital Surround" are trademarks of Dolby Laboratories.
• Use DVD video discs encoded via the DTS recording system.
20
To COAXIAL type digital audio input
To OPTICAL type digital audio input
Optical digital cable
75 Ω coaxial cable
Connect either . Amplifier...
User Manual - Page 22
... affect the player's operation. TV/VCR
The VCR indicator will light.
4 Turn ON the TV and set to select the VCR mode.
For a push-button TV tuner If CH 3 or 4 corresponding to the video channel cannot be set to CH 3 or 4 to correspond with the 75 ohm coaxial cable only. Disconnect the AC power cord once, then connect it again.
3 Press VCR DVD selector...
User Manual - Page 23
... you use the unit for more than 60 seconds, the VCR
MENU screen will return to normal TV-operation automatically.
á+/-/ENTER/MENU ñ
2 Press SET + or -
CH +
MENU
TIMER REC SET AUTO REPEAT ON OFF
SAP
ON OFF
CH SETUP
SYSTEM SETUP
Notes: • Both the VCR and the DVD have their own player menus 57 . •...
User Manual - Page 24
... connected to the normal screen. SET +
ENTER SET -
CALL POWER VCR DVD
1,5 2,4 2,3
AUTO CLOCK setting
To set AUTO CLOCK to off
Preparation: • Turn ON the TV and select the corresponding video input. • Press VCR DVD selector to select the VCR mode.
(The VCR indicator will be left on .
2 Plug the AC Power cord to the AC outlet. 3 Make sure the DVD/VCR is turned...
User Manual - Page 27
... Cable TV channels. Basic setup
Tuner setting
This DVD/VCR is equipped with an antenna, set the TV/CATV menu option to the TV mode. Before selecting channels, they must be programmed into memory, skipping over unwanted channels. When shipped from the factory, this menu option is cleared. VCR DVD
1,4 1,3 1,2
TV/CATV selection
Setting channels automatically
Preparation: • Turn...
User Manual - Page 31
... Snowy Picture
Notes:
• DO NOT ATTEMPT TO CLEAN THE VIDEO HEADS OR SERVICE THE UNIT BY REMOVING THE REAR COVER.
• Video heads may eventually wear out and should be ...
CM SKIP SET +/-
"AUTO TR." will search forward through approximately 30 seconds of CM SKIP (maximum six presses) and then resume normal playback. Slow motion
During playback press SLOW.
The DVD/VCR will appear ...
User Manual - Page 34
... 456 7890
CH - VCR DVD
4 2 5
4
Recording a TV program
Preparation: • Turn ON the TV and select to the corresponding
video input. • Press VCR DVD selector to select the desired tape speed SP or SLP. SP/SLP PLAY MODE
00 : 00 : 00 SP
3 Select "TV" or "CATV" to right. CABLE TV channels
4 Press Number button or CH +/- SET +
ENTER SET -
If you press...
User Manual - Page 40
... tab intact.
• Load a previously recorded tape into the playback VCR or Camcorder.
1 Press SP/SLP to select AUDIO/VIDEO input position.
The duplicating process begins.
VCR DVD
2 1 4
5
Duplicating a video tape
Preparation:
• Turn ON the TV and select the corresponding video input.
• Press VCR DVD selector to another VCR or Camcorder, you set the tape speed to the...
User Manual - Page 42
... the audio system and select the input
connected to end playback. • The unit records the stopped point, depending on the unit. On the TV-screen, " " changes to
OR
"Reading" and then playback
commences.
2 Press VCR/DVD SELECT to the DVD/VCR. Reading
3 Press OPEN/CLOSE.
This
may cause serious personal injury.
4 3, 5
DVD
VCD Basic playback
CD
1
Display window 2 STOP...
User Manual - Page 43
.... Also refer to the instructions supplied with this unit plays DVDs according
to open and close the disc tray after you play back a disc. About
The
icons on the TV screen
according to close the disc tray.
Follow steps 3 ~ 5 on your television set a single-faced disc label downwards (ie.
Since this DVD/VCR, you should generally reduce...
User Manual - Page 66
...
mode. • Set the S-VIDEO/COMPONENT video selector switch on the display window will light.)
1 Press PROGRESSIVE in the DVD mode. - The unit is played back in the stop mode. VCR DVD
1 2
DVD VCD
Selecting
PROGRESSIVE
scan
CD
Preparation:
• Connect to a TV equipped with the progressive
scanning mode correctly because of the disc characteristics or recording condition. •...
User Manual - Page 68
SYMPTOMS
POSSIBLE SOLUTIONS
DVD/VCR
DVD/VCR does not operate. No CATV reception.
• Check all CATV connections. • Station or CATV system problems, try another AC outlet. • Power is off, check fuse or circuit breaker. • Unplug unit, then plug it . • Check the Parental setup. VCR
TV recording does not work . Noise bars on -screen display. Stopping...
Similar Questions
How Do I Change From Sp To Slp With The Remote - Toshiba Sd-v392 Dvd/vcr Combo
(Posted by marydealmeida 10 years ago)
Como Desbloquear Mi Dvd Players Sd-kv260ku
como desbloquear mi DVD Players SD-KV260KU
como desbloquear mi DVD Players SD-KV260KU
(Posted by rbertot 10 years ago)
Looking For The Owner's Manual For Toshiba Dvd/vcr Combo Model # Sd-v392su2
(Posted by frankburns 11 years ago)
My Portable Dvd Player Wont Turn On When You Press The Power Button.
my portable dvd player wont turn on when you press the power button. when its plugged in the yellow ...
my portable dvd player wont turn on when you press the power button. when its plugged in the yellow ...
(Posted by Cgallitelli28 12 years ago)
Does Sd-v392su2 Dvd-vcr Have An Digital Tuner In Order To Store More Channels Fr
In order to store more channels from an cable box.
In order to store more channels from an cable box.
(Posted by ljm129 12 years ago)