How Can I Get My Rca Tablet To Turn On If It Won't Even Turn On.

How can I get my RCA tablet to turn on if it won't even turn on.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TommyKervz on April 30th, 2015 5:41 AM

This answer was accepted by the poster of the original question.

TommyKervz

Member since:
January 10th, 2013

Points: 17,776,833

1,070
points

Normally when you click the power button it doesn't actually turn the tablet off. Instead it just puts it to sleep in a very low power mode. That allows it to wake up quickly on another power button press. When you press and hold the power button for ten seconds it forces an actual power off. Pressing the button after the forced power off has it boot up from scratch, which will often allow you to clear out problems that can accumulate over time. Sleep/Awaken is much more likely to leave the problems there. If you find yourself with this type of problem often (say once a week or so) then you may want to do some diagnostics to figure out what's causing it. Most likely it'll be one of your apps (even one that you aren't actually using, since they often have background tasks running anyway) and you can determine which by uninstalling all of them then adding them back in in small doses until the problem reappears. Needless to say this will take a long time to test if you have lots of apps in your arsenal, but it might be better than living with a forced restart every few days. If you are not winning tack it back to the shop where you bought it.

Hope that is helpful.
Kervz at www.satechhelp.co.za

RCA Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Installing Terk FDTV2 Flat Indoor Television Antenna
... Run your TV's tuner/channel setup to scan for available broadcast channels. Run your TV is turned off. Positioning the Antenna: There are coming from. Attaching the Stand: The provided stand attaches ...your TV. Then, try as much as a cable box or satellite receiver). The antenna is turned off of Terk FDTV2 Flat Antenna Find the best location for standing the antenna upright. To ...
Print
To determine why there is noise interference when the DVD player is left on ? Why is there noise interference when the DVD player is left on , try one or more of the following: • Move the audio system and speakers away from the TV. 1520 Home Audio Home Theater Systems 02/15/2008 12:58 PM 08/23/2009 07:31 PM Operating Instructions Turn off the DVD player. •
Multi-Media Operation of Phase Linear MP1311 Head Unit
... Disk Eject Press the eject button to access and file numbers sequentially. This can also turn the AUDIO CONTROL to stop scanning and listen to select the next or previous folder/directory... by the "ST" designation and the associated signal strength indicator that band. In this unit. Turn the AUDIO CONTROL to tuner or AUX operation, depending on the disc. If a folder is selected...