LiftMaster 8550 Support Question
LiftMaster 8550 Support Question
Find answers below for this question about LiftMaster 8550.Need a LiftMaster 8550 manual? We have 1 online manual for this item!
Question posted by neilgoldschmitt on May 5th, 2017
Does It Have Myq And If So Can Garage Door Be Opened/closed From A Remote Locati
does it have MyQ and if so can garage door be opened/closed from a remote location with smart phone
Current Answers
Answer #1: Posted by Odin on May 5th, 2017 9:21 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
Yes, it uses MyQ technology. The documentation does not address operation from a faraway location. However, it is compatible with up to 2 Smart Control Panels or4 of any other Security+ 2.0 door controls.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related LiftMaster 8550 Manual Pages
8550 Manual - Page 1
.... ■ The model number label is located on the left side panel of your garage door opener. ■ This garage door opener is to be used ONLY with MyQ™ and Security✚®2.0
accessories. ■ DO NOT enable the Timer-To-Close feature if you are installing the garage door opener on a one -piece door, visit www.liftmaster.com for installation instructions...
8550 Manual - Page 3
...
C. Rail I
3
MyQ™ AND SECURITY✚®2.0 ACCESSORIES
880LM Smart Control Panel®
895MAX Remote Control
829LM Garage Door Monitor
Hardware
Assembly H1 Hex...garage door opener model purchased. Sprocket cover and screws K. Belt L. Curved door arm
E. Door bracket
D. Door control
M. Straight door arm A
B
CF G
D E
F. Header bracket
B. Garage door opener...
8550 Manual - Page 6
... are installing the garage door opener on the floor. 13. ALL repairs to garage door control 11. Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing
opener to do so 8. Mount the emergency release within sight of the garage door. • out of reach of the door.
10. Install garage door opener only on .contact with vehicles to -Close functionality if...
8550 Manual - Page 7
... supports.
1.3 Open your garage, use the maximum height possible, or refer to -Close functionality if operating either one -piece door, visit www.liftmaster.com for the top edge of the door. This height will provide travel as shown.
Header Wall
2" (5 cm)
Track
Highest Point of Travel
Door
Unfinished Ceiling
Header Wall 2x4
Vertical Centerline of Garage Door
2x4...
8550 Manual - Page 10
... end of each hanging bracket to 5.5 Attach the garage door opener to the
5.6 Remove the 2x4 and manually close the
the support bracket with appropriate
hanging brackets with the header bracket.
If the door hits the rail, raise the
hardware (not provided). For ALL installations the garage door opener MUST be different.
The instructions illustrate one of the...
8550 Manual - Page 11
... fall.
7.1 Insert one end of the emergency release
rope through the hole in an open door falling rapidly and/or unexpectedly. • NEVER use emergency release handle unless garage doorway is clear of all vehicles to pull door open or closed. or
or
To prevent possible OVERHEATING of the light lens and
rotate the light lens...
8550 Manual - Page 13
...). trolley will re-engage automatically when the garage door opener is hanging down too far, you may cut 6 inches (15 cm) from the curved door arm. The
(H2), nuts (H8) and lock washers (H9).
CORRECT
Straight Door Arm
(Groove facing out)
Curved Door Arm
INCORRECT
Straight Door Arm
Curved Door Arm
9.1 Close the door. H11
H6
HARDWARE H2 (2)
Hex Bolt...
8550 Manual - Page 14
...the location of the bottom mounting 1.4 Install the bottom screw, allowing 1/8 inch
one end of
closing garage door:...garage door opener is compatible with up to 2 Smart Control Panels or 4 of the door.
• Activate door ONLY when it is NOT connected BEFORE installing door control. • Connect ONLY to 24 VOLT low voltage wires. Use the existing holes in sight until completely closed...
8550 Manual - Page 17
If an obstruction breaks the light beam while the door is closing garage door: • Correctly connect and align the safety
reversing sensor. as the light bulb turns off the sensor LEDs will turn off and whenever the garage door opener lights turn on either side of the door. • Sensors are no more than 6" (15 cm) above the...
8550 Manual - Page 24
... up and down cycle using the remote control or the UP and DOWN buttons. Adjustment Button. Adjustments
1 Program the
Travel
Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY INJURED or KILLED by a closing garage door. • Incorrect adjustment of garage door travel to flash.
* If the garage door opener lights are made, the...
8550 Manual - Page 25
... a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY INJURED or KILLED by a closing garage door.
3.2 Press the remote control push button to the fact that the sensor is misaligned or obstructed). If the garage door opener closes the door when the safety reversing sensor is obstructed (and the sensors are made, the safety reversal system...
8550 Manual - Page 26
.... • Use ONLY LiftMaster part # 485LM for disposal instructions.
1 Install the battery
1.1 Unplug the garage door opener. 1.2 Open the light lens on battery power or will either glow solid orange indicating opener is unplugged.
2.2 Open and close the door using the
remote control or door control. Battery Backup
To reduce the risk of FIRE or INJURY to fully charge. The...
8550 Manual - Page 28
... are no obstructions to operate or play with garage door control push buttons or remote controls.
3. ALWAYS disconnect electric power to -Close functionality if operating either one-piece or swinging garage doors. DO NOT enable the Timer-to garage door opener BEFORE making ANY repairs or removing covers.
14. ONLY activate garage door when it can be seen clearly, it is...
8550 Manual - Page 29
...
Your garage door opener is activated the door will close. The garage door opener is compatible with up to the door closing , the door will stop .
Prior to 2 Smart Control Panels or 4 of the infrared beam. SECURITY+®2.0 REMOTE CONTROLS AND DOOR CONTROLS
Your garage door opener is compatible with up to operate with your garage door operation. Your garage door opener has...
8550 Manual - Page 30
... to the garage door opener by accessing the menu using the navigation buttons:
LEARN A DEVICE
Any compatible remote controls, wireless keyless entry, or MyQ™ accessories can be the primary method of the TTC. This feature is to on or off automatically if you experience a power outage, cycle the garage door opener open or close your garage door from the door control and...
8550 Manual - Page 31
... before door closes. PROGRAM: Add remote controls, MyQ™ devices, an extra remote button to view the Service menu. DISPLAY ERROR: Displays any errors that have occurred. SERVICE
Press and hold the second navigation button, then press the LIGHT button to control your garage door CONTRAST: Adjust the contrast of the screen.
TTC is to operate the garage door opener...
8550 Manual - Page 34
...;C) or incinerate. If rope knot becomes untied, you could result in an open the remote control housing. The door can then be sure door opens and closes fully. The trolley will operate during an electrical power outage. Adjust if necessary (refer to Adjustment section). The garage door opener does not require additional lubrication. EVERY TWO TO THREE YEARS •...
8550 Manual - Page 35
...to the receiving sensor (green LED). Close the garage door using the
remote control or the door control.
Make sure nothing is not lit, check the wire leading to and from that sensor. Close the garage door using the remote control or the door control. Close the garage door using
the remote control or the door control. The garage door opener will flash
installed, connected, or amber...
8550 Manual - Page 36
... locate the travel module.
6-8" and stops and/or
reverses
4-6
4 FLASHES 6 FLASHES The door reverses for a
traveling down
or misaligned
temporary obstruction such as necessary. My garage door opener light(s) will not turn off when the door is closing , secure rails or re-install the sensor brackets to the
wall or floor, refer to the door. My neighbor's remote control opens...
8550 Manual - Page 39
... open and close them from lightning and power surges. Includes visor clip.
880LM
SECURITY+®2.0 Smart Control Panel®:
Displays temperature, time and system diagnostics; Sensor can be easily deactivated when desired.
SECURITY+®2.0 3-Button Remote Control: Compatible with LiftMaster® garage door openers manufactured since 1993. Accessories
828LM 823LM 825LM
MyQ...
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 7 months ago)
Garage Door Opens After Shutting.
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
(Posted by BONNIECA92 2 years ago)
My Garage Door Doesn't Open Or Close And I Have A Code 15 On My Keypad
(Posted by Hass33 5 years ago)
Garage Door Wont Close
garage door starts to come down but then stops and lights flash
garage door starts to come down but then stops and lights flash
(Posted by djsyencer 6 years ago)
Remote Control For Liftmaster /chamberlain 3850 Garage Door Opener
what is the correct remote control for the chamberlain/liftmaster 3850 garage door opener
what is the correct remote control for the chamberlain/liftmaster 3850 garage door opener
(Posted by sendtoalice 9 years ago)