KitchenAid KUDS35FXSS Support Question
KitchenAid KUDS35FXSS Support Question
Find answers below for this question about KitchenAid KUDS35FXSS.Need a KitchenAid KUDS35FXSS manual? We have 4 online manuals for this item!
Question posted by han46Prcko on September 9th, 2014
What Is The Difference Between Kitchenaid Dishwasher # Kuds30fxss And
kuds35fxss
Current Answers
Related KitchenAid KUDS35FXSS Manual Pages
Dimension Guide - Page 1
... air gap should be connected
to waste tee or
disposer inlet above the floor. Insulation may be compressed. (not used on one end. ® Undercounter Dishwasher
PRODUCT MODEL NUMBERS
KUDC10FX KUDC10IX KUDE20FX KUDE20IX KUDE40FX KUDE50CX KUDE60FX KUDE60HX
KUDE60SX KUDE70FX KUDL15FX KUDS30CX KUDS30FX KUDS30IX KUDS30SX KUDS35FX
Electrical Requirements: 120-volt, 60-Hz...
Dimension Guide - Page 2
... " (86 cm) by removing wheels from the lowest point on the underside of opening.
(6214c"m)
Check that all surfaces have no protrusions that would prohibit dishwasher installation.
(61E2c4m" )
(86m.344icn"m)
D
(10.42"cm) (7.63"cm)
(17.2 cm) (4.4 cm)
(6.4 cm)
(26.7 cm) (15.9 cm)
CAlreeaar
(4.4 cm)
(5.12"cm)
Because Whirlpool Corporation policy...
Installation Guide - Page 2
..., drain hose and lower rack. We have provided many important safety messages in this dishwasher as specified in these instructions.
• Installation should be performed by a qualified service... and Route Water Line 8 Install Drain Hose 10 Install Moisture Barrier 11 Prepare Dishwasher 11 Make Power Supply Cord Connection 12 Determine Cabinet Opening 13
Installation Instructions (cont...
Installation Guide - Page 3
...;" wood screws (if installing custom front panels)
†® TORX is recommended when installing a dishwasher under - 2 - under a wood countertop. For Direct Wire: use UL Listed/ CSA Approved ...179;⁄₄" thick wooden panel. clamps (2)
Phillips- Additional parts supplied with
dishwasher
MSailkveersuGrreeaelnl these parts are included in Kit: 4 Plastic studs (attached to
"
...
Installation Guide - Page 4
... underneath the countertops.
Damage from your cabinetry. Motor should not touch the floor.
Shelter dishwasher and water lines leading to order.
Do not run drain lines, water lines or electrical... the end of your dealer for loading and unloading dishes. NOTE: To avoid shifting during dishwasher operation, shims must provide:
• easy access to floor.
• level floor. ...
Installation Guide - Page 5
... compressed. (not used on all models)
3 "-4 " (8.8 cm -10.6 cm)
3" (9.4 cm)
(532.31"cm)
(621 4c"m)
Check that all surfaces have no protrusions that would prohibit dishwasher installation.
(61E2c4m" )
NOTE: Shaded areas of countertop. May be installed. For Pro Line® handle, depth is 24" (60 cm) not including the
C. Minimum, measured...
Installation Guide - Page 6
...standards can be verified by a licensed plumber.
• 120°F (49°C) water at dishwasher O.D.
latest edition and all current AHAM/IAPMO test standards, is not recommended. • A 90...codes and ordinances.
• Use a UL Listed/CSA Approved strain relief.
If connecting dishwasher with direct wiring: • Use flexible, armored or nonmetallic sheathed, copper wire with 20...
Installation Guide - Page 7
...the instructions in cabinet side or rear.
INSTALLATION INSTRUCTIONS
Electrical Shock Hazard Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher. Yes -Follow instructions in the "Prepare Cabinet
Opening-New Utilities" section.
Power Supply Cord: Follow Option A instructions
Direct Wire: Follow Option B instructions
Option A, Power Supply...
Installation Guide - Page 8
... grommet (Part Number 302797 -
Option B, Direct Wire:
Helpful Tip: Wiring the dishwasher will be easier if you route the cable into cabinet opening from power supply through...provided).
8
Hot water line
Measure overall length of cabinet opening will prohibit cable from moving when dishwasher is in the cabinet side or rear.
2 Measure water supply line
Wood cabinet
Metal cabinet
Wood ...
Installation Guide - Page 13
... Supply Cord- Connect ground wire
Tighten strain relief screws to secure cover. Determine Cabinet Opening
1 Measure cabinet opening from underside of countertop to floor where dishwasher will be sure both are secured. Visit www.kitchenaid.com under FAQ tab. Measure height of cabinet opening
NOTE: Twist on the floor). Refer to...
Installation Guide - Page 20
.... If leak occurs, repeat previous step.
Option B, Direct Wire:
1 Direct Wire-Route cable
into the black drain hose connector up to "Secure Dishwasher in drain hose. Visit www.kitchenaid.com/watersupply under FAQ tab.
Owner must purchase a ⁷⁄₈" screw-in terminal box. Make Direct Wire Electrical Connection
NOTE: If the...
Installation Guide - Page 21
...
If needed, see website for animated representation of cover. Place wires inside box.
WARNING
Electrical Shock Hazard Electrically ground dishwasher. Failure to secure cable.
5 Direct Wire-Reinstall
terminal box cover
NOTE: Twist on left side of this step.... relief screws to follow these instructions can result in terminal box. Visit www.kitchenaid.com/electrical under the washer.
Installation Guide - Page 23
... take it will go, making sure lettering is facing up into position. Visit www.kitchenaid.com/anchoring under FAQ tab. If they do not rub against the screw heads. Fold the front end of the dishwasher, making sure not to push or pull any wires or hoses. (Do not force.) Side panels...
Use & Care Guide - Page 1
... can find your model and serial number on the label located near the door on the right-hand or left-hand side of the dishwasher interior. In Canada: visit www.kitchenaid.ca or call 1-800-807-6777. Have your KitchenAid dishwasher, please contact us that you have provided an easy to us at www...
Use & Care Guide - Page 7
... dish racks and interior of the dishes after the final
rinse.
■ Rinse aid helps to start .
7 Without rinse aid your dishwasher until the indicator level is selected for standard powdered detergent. Add
■ Check the rinse aid indicator. max -
21 3
- ---... the options desired. Typical cycle time is fully
locked. Turn off the option, or select a different option.
Use & Care Guide - Page 8
...on this cycle. Do not use detergent.
12
1.7 (6.3)
Wash times depend on food.
to items at the dishwasher.
power to 145°F (63°C) and
on water temperature, heavy soil condition, dish load size and ... regular tableware.
Cycle and Option Descriptions
This information covers several different models. Your dishwasher may not have all the cycles and options described.
Use & Care Guide - Page 11
Dishwasher Features
Your KitchenAid dishwasher may have 1 or 2 rows of flexible tines located in the 60°
angled position when using the ProScrub&#...both rack adjusters and lift the rack until it is located at the back of items may also have some or all of dishwasher
NOTE: You must select the ProScrub® wash option to use this feature.
Mix silverware types to make room for a ...
Use & Care Guide - Page 13
...onto other than Start/Resume blink and the unit will not run for the dishwasher to the dishwasher before starting the cycle. Check the drain air gap when your detergent is...your dishwasher. In the U.S.A., www.kitchenaid.com In Canada, www.kitchenaid.ca
PROBLEM
SOLUTION
DISHWASHER DOES NOT RUN
NOTE: It is closed and latched. Be sure your dishwasher is fresh and lump free. DISHWASHER NOT...
Use & Care Guide - Page 16
... to state or province to province. Service calls to correct the installation of your home. 8. This warranty gives you specific legal rights, and you . KITCHENAID® DISHWASHER WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or...
Use & Care Guide - Page 17
...kitchenaid...can write to KitchenAid with any questions or concerns at the number below :
In the U.S.A.:
KitchenAid Brand Home ...Appliances Customer eXperience Center 553 Benson Road Benton Harbor, MI 49022-2692
In Canada:
KitchenAid Brand...reserved.
® Registered Trademark/TM Trademark of KitchenAid, U.S.A., KitchenAid Canada licensee in Canada
9/10 Printed in your...
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Silicone bakeware.
...bakeware away from the baked goods. If washing by hand in warm soapy water. Different bakeware and cooking results Online shopping for easy transfer from some foods may stain the ...not affect the performance of cooking spray. Cooking time may be necessary. Silicone bakeware is Dishwasher safe. Fill evenly with traditional metal bakeware; To remove the baked goods, invert the ... -
Options on my dishwasher
.../Resume to turn off the option. Select a different option if desired. Options on my dishwasher How do I usew the Options on my dishwasher? This information covers several different models. Your dishwasher may not have all the options described. My dishwasher is locked Dishwasher will not start Upper rack features Using the Options... -
Cleaning and caring stainless steel surfaces
...The rise in the direction of stainless steels. To clean and care for your refrigerator Different types of the grain. Rinse with clean water and dry with a soft cloth....your stainless steel surfaces, follow the recommendations and directions on stainless steel sinks, refrigerators, dishwashers, ranges, microwaves and cookware. Thoroughly dry the area with a soft, lint-free cloth. ...
Similar Questions
Kitchenaid Dishwasher Kuds35fxss Wont Go Through Cycle
(Posted by jfkmars7 9 years ago)
Kitchenaid Dishwasher Kuds35fxss How To Change Pump
(Posted by belkSarat 10 years ago)
Kitchen Aid Dishwasher
Kuds35fxss
My KUDS35FXSS , water remains in disposer based system, after cleaning and drying cycle is finished....
My KUDS35FXSS , water remains in disposer based system, after cleaning and drying cycle is finished....
(Posted by jrhdch 11 years ago)
Kitchenaid Dishwasher Kuds30fxss Frame
Are the left and right sides of the bottom frame supposed to be bent inward? (Frame where the wheels...
Are the left and right sides of the bottom frame supposed to be bent inward? (Frame where the wheels...
(Posted by Anonymous-45673 12 years ago)