Kenwood KDC-BT362U Support Question
Find answers below for this question about Kenwood KDC-BT362U.Need a Kenwood KDC-BT362U manual? We have 1 online manual for this item!
Question posted by Anonymous-166720 on August 17th, 2020
When I Power On It Says Protect Then Pauses
Current Answers
Answer #1: Posted by techyagent on August 18th, 2020 6:27 AM
Step
Reset the receiver by removing the face plate and pressing the "Reset" button with a paperclip. If this solution doesn't fix the problem, continue with troubleshooting and reset the receiver after each step.
Step
Turn off the receiver and disconnect all speaker wires.
Step
Turn on the receiver. If it quickly shuts off, the receiver has an internal short, according to Kenwood. Contact Kenwood customer service to have the unit repaired.
Step
Connect one speaker at a time. If the receiver shuts off after connecting a speaker, that speaker's wiring or the speaker itself has a problem.
Step
Replace any faulty wiring.
Step
Replace a speaker if you have replaced its wiring and your receiver is still going into protection mode
Thanks
Techygirl
Related Kenwood KDC-BT362U Manual Pages
Similar Questions
using the the same wires and it worked. I took the unit that was showing miswiring and tried it in t...
my kenwood deck powers on and immediately says "miswiring check wiring then power on" ive checked th...