Kenwood KDC-152 Support Question
Find answers below for this question about Kenwood KDC-152.Need a Kenwood KDC-152 manual? We have 2 online manuals for this item!
Question posted by smitjkorn on July 2nd, 2014
How Do You Get The Clock To Display All The Time On A Kenwood Kdc-152
The person who posted this question about this Kenwood product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
There are currently no answers that have been posted for this question.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Related Kenwood KDC-152 Manual Pages
Instruction Manual - Page 1
...below. GET0740-001A (KW/K0) Model KDC-152 Serial number
US Residents Only
Register Online
Register your Kenwood product at www.Kenwoodusa.com
© 2011 Kenwood Corporation All Rights Reserved. Refer to read... product.
KDC-152
CD-RECEIVER
INSTRUCTION MANUAL
AMPLI-TUNER LECTEUR DE CD
MODE D'EMPLOI
REPRODUCTOR DE DISCOS COMPACTOS RECEPTOR DE FM/AM
MANUAL DE INSTRUCCIONES
Take the time to the...
Instruction Manual - Page 2
... site: www.kenwood.com/cs/ce/audiofile/
2 If you purchase external components, check with your Kenwood dealer. Detailed information and notes about the playable audio files are used...(RC-405)
Basic operations
4
Getting started
6
Canceling the display demonstration Setting the demonstration mode Adjusting the clock Initial settings before operating the unit.
To prevent a short circuit...
Instruction Manual - Page 3
... effectiveness of the remote controller decreases, replace the battery.
3 2
4
1
CALIFORNIA, USA ONLY This perchlorate WARNING applies only to use the remote controller for the first time, pull out the insulation sheet. Replace only with coloring on the dashboard. Keep battery out of reach of equipment and can cause malfunction. To prevent...
Instruction Manual - Page 4
... the monitor or unit. Do not stick tape etc. Clean the disc with tape stuck on the disc, or use any accessories for the disc. Display window
Ejects the disc
Volume knob
Detaches the faceplate
The following indicator lights up when... Do not use a disc with a dry silicon or soft cloth...
Instruction Manual - Page 5
...using a commercial telephone accessory. (page 13)
When a call comes in clock display screen.
-
SRC
Selects the available sources (TUNER, CD, AUX, STANDBY), if the
SRC...press the button again. Fast-forwards/reverses tracks if pressed and held .
"CALL" disappear and the audio system resumes.
ATT
Attenuates the sound. • To return to the auxiliary input jack.
4 /...
Instruction Manual - Page 6
...preset button in each preset button regardless of the selected band (FM1/ FM2/ FM3/ AM). Clock minutes flashes on the display.
5 Turn the volume knob to adjust the hour, then press to prevent noise when no... operation is selected as a music CD. Press 4 / ¢ to move between audio file disc ...
Instruction Manual - Page 8
...current file name appears on the display. 2 Turn the volume knob to select a folder/ track/file, then press to the root folder (or first track for audio CD), press BAND. Hold to ...Press to make a selection.
Selecting Scan Play Press number button 2 (SCAN) repeatedly to select track/file.
Audio CD : DISC RANDOM, RANDOM OFF MP3/WMA : FOLD (folder) RANDOM,
ALL RANDOM, RANDOM OFF Press and...
Instruction Manual - Page 10
... VIDEO/ TV: Selects the desired name for the connected component. (Selectable only if "AUX" is selected as the source.)
CLOCK
CLOCK ADJ: (For details, see page 6.)
DISPLAY DIMMER SET: ON: Dims the display ...then press to scroll the display information automatically, or scroll only once. ;
Press to return to the previous item. 4 Hold to finish the procedure.
[AUDIO CTRL] : While listening to...
Instruction Manual - Page 11
...is malfunctioning for recording). If the condition did not improve, turn on the display is playing an unsupported audio file. Check the cords and connections. Insert a playable disc into the ...reception is sometimes interrupted. Disc sound is poor. Noise is not correct. Elapsed playing time is generated. Check the cords and connections. Stop playback while driving on the unit....
Instruction Manual - Page 12
...'s negative terminal and make sure the wires aren't touching to any ) when closing and opening. Be sure to ground this unit during installation, consult your Kenwood dealer.
12 Install this product requires skills and experience. Connect the speaker wires correctly to the terminals to which they correspond.
Instruction Manual - Page 15
... (±3 dB): 30 Hz - 15 kHz Signal-to-Noise ratio (MONO): 63 dB Stereo separation (1 kHz): 40 dB
Audio section
Maximum output power: 50 W × 4 Full bandwidth power (at less than 1 % THD):
22 W ×...1 200 mV Input impedance: 10 kΩ
CD player section
Laser diode: GaAIAs Digital filter (D/A): 8 Times Over Sampling D/A converter: 24 Bit Spindle speed: 500 rpm - 200 rpm (CLV) Wow & Flutter...
Instruction Manual - Page 44
... expressly approved in the instruction manual. These limits are designed to correct the interference by turning the equipment off and on a circuit different from that Kenwood manufactured this equipment does cause harmful interference to radio or television reception, which the receiver is encouraged to try to provide reasonable protection against harmful...
Owners Manual - Page 1
Model KDC-152 Serial number KDC-152
CD-RECEIVER
INSTRUCTION MANUAL
AMPLI-TUNER LECTEUR DE CD
MODE D'EMPLOI
REPRODUCTOR DE DISCOS COMPACTOS RECEPTOR DE FM/AM
MANUAL DE INSTRUCCIONES
Take the time to the model and serial numbers whenever you obtain the best performance from your Kenwood dealer for information or service on the warranty card, and...
Owners Manual - Page 2
...
Basic operations
4
Getting started
6
Canceling the display demonstration Setting the demonstration mode Adjusting the clock Initial settings before operations
Listening to the radio
...volume so that they work with :
The illustrations in your Kenwood dealer. This unit can hear sounds outside the car. CONTENTS...audio files are used. In this manual are examples used to know...
Owners Manual - Page 5
... telephone using a commercial telephone accessory. (page 13)
When a call comes in clock display screen.
-
Main unit
Remote controller
General operation
- Scrolls the display information if pressed and held .
BAND
*AM- /
#FM+
Selects the FM bands (FM1/ FM2/ FM3) or AM. The audio system pauses. Turns off if pressed and held .
Selects the next/previous...
Owners Manual - Page 6
... regardless of the selected band (FM1/ FM2/ FM3/ AM).
Press 4 / ¢ to move between audio file disc and music CD. ; 2: Forces to finish the procedure.
SP SELECT OFF*/ 5/4/ 6 ×...ON*/ OFF: Activates/deactivates the keypress tone. OFF: Disables "AUX" in source selection. Clock hour flashes on the display.
5 Turn the volume knob to adjust the hour, then press to select [ON] or...
Owners Manual - Page 8
.../file 1 Press to confirm. "SEARCH" appears, then the current file name appears on the display. 2 Turn the volume knob to select a folder/ track/file, then press to enter Music...Audio CD : TRAC (track) REPEAT, REPEAT OFF
MP3/WMA : FILE REPEAT, FOLD (folder) REPEAT, REPEAT OFF
Selecting Random Play Press number button 3 (ALL RDM) repeatedly to make a selection. To return to turn on the display...
Owners Manual - Page 10
... VIDEO/ TV: Selects the desired name for selection. Press to return to the previous item. 4 Hold to finish the procedure.
[AUDIO CTRL] : While listening to scroll the display ...CLOCK
CLOCK ADJ: (For details, see page 6.)
DISPLAY DIMMER SET: ON: Dims the display illumination. ;
Function settings
1 Press the volume knob to enter [FUNCTION] mode. 2 Turn the volume knob to select [AUDIO...
Owners Manual - Page 11
...or change the disc. A copy-protected file is playing an unsupported audio file.
This unit can be skipped. "TOC ERROR" appears. ...CD player is generated. "PROTECT" appears and no operations can only display letters (upper case), numbers, and a limited number of the ...connectors. (page 4)
Reset the unit.
Longer readout time is scratched a lot. This is malfunctioning for recording...
Owners Manual - Page 15
KENWOOD STEREOS
...177;3 dB): 30 Hz - 15 kHz Signal-to-Noise ratio (MONO): 63 dB Stereo separation (1 kHz): 40 dB
Audio section
Maximum output power: 50 W × 4 Full bandwidth power (at less than 1 % THD):
22 W ...200 mV Input impedance: 10 kΩ
CD player section
Laser diode: GaAIAs Digital filter (D/A): 8 Times Over Sampling D/A converter: 24 Bit Spindle speed: 500 rpm - 200 rpm (CLV) Wow &...
Similar Questions
How Do I Setup My Clock For My Kdc-bt742u
Value is How do I setup my clock for my kdc-bt742u
Value is How do I setup my clock for my kdc-bt742u
(Posted by lorigriff4 8 years ago)
Display Time When Radio Is On
for some reason the radio stopped displaying the clock. I have read the instructions but I can't see...
for some reason the radio stopped displaying the clock. I have read the instructions but I can't see...
(Posted by iiisunz 9 years ago)
I Set The Clock On The Kenwood Kdc-348u But I'm Not Seeing How To Display Time
(Posted by bradberton 9 years ago)