Honeywell RTH2310B Support Question
Honeywell RTH2310B Support Question
Find answers below for this question about Honeywell RTH2310B.Need a Honeywell RTH2310B manual? We have 1 online manual for this item!
Question posted by krish11111 on November 11th, 2012
Can Not Shut Down The Unit, Even If My Room Temperature Is Pass The Set Point
room temp set at 23 c, room temp pass the set temp and goes to 30 c, still my furnace not shuting down.
Current Answers
Related Honeywell RTH2310B Manual Pages
Owner's Manual - Page 1
Quick Installation Guide
RTH2310
Programmable Thermostat 69-2214EF-04
Owner's Manual - Page 2
... wires. 4) Mount the new wallplate. 5) Connect the wires. 6) If the wire labels don't match. 7) Specify the furnace type. 8) Install the batteries. 9) Install the thermostat. 10) Set the system. Quick Installation Guide
Installation is Easy
Your new thermostat has been designed for fast and easy installation. Call 1-800-468-1502.
1
We are here to help...
Owner's Manual - Page 3
... your system type or if you have any other questions, call us toll-free at 1-800-468-1502. RTH2310 Programmable Thermostat
1 Identify System Type
1.
This thermostat is compatible with the following systems:
• Gas, oil or electric furnace • Central air conditioner • a hot water system with heat pumps or multi-stage systems.
2
Owner's Manual - Page 4
... power off at the heating/cooling system.
2) Remove old thermostat, but leave wallplate with wires attached. Do not remove wallplate yet. MERCURY NOTICE: Do not put your local waste management authority for instructions regarding recycling and proper disposal.
3
Contact your old thermostat in the trash if it contains mercury in a sealed tube...
Owner's Manual - Page 5
RTH2310 Programmable Thermostat
3 Identify Wires
3. Wrap the bare metal end of each wire. Do not use C or C1 wires
Identify and label each of these wires with electrical ... wires and remove the old wallplate only after all wires are attached to a terminal marked C or C1, they will not be connected to your new thermostat. If any wires are not attached to your old...
Owner's Manual - Page 6
Quick Installation Guide
4 Mount New Wallplate
4.
1) Remove coverplate.
2) Loosen screw (the screw remains captive on wallplate).
3) Remove thermostat.
4) Mark and drill appropriate mounting holes (or use existing holes). Pass wires through opening of wallplate and secure wallplate to the wall using provided screws.
5 Insert plastic anchors.
Owner's Manual - Page 7
... with the terminal having the same letter.
2) Loosen the terminal screws using a screwdriver, insert the wires, then tighten the screws.
3) Push any terminal on the thermostat, see next page.
6 Labels don't match?
RTH2310 Programmable...
Owner's Manual - Page 9
Set the Jumper J2, on the back of the thermostat, if you have connected a wire to this factory-set position if you have a gas or oil furnace.
HE Place the jumper to the G terminal. RTH2310 Programmable Thermostat
7 Specify Furnace Type
6. J2 jumper
HG Leave the jumper in this position if you have an electric furnace.
8
Owner's Manual - Page 10
Afterwards, the screen displays the actual temperature. It is normal that the displayed temperature be higher than the ambient temperature if you are installed, the thermostat performs a series of tests for approximately 5 seconds. The thermostat will hear a clicking
sound. Quick Installation Guide
8 Install Batteries
7.
1) Pull out the battery cover. 2) Install the batteries as shown. ...
Owner's Manual - Page 11
RTH2310 Programmable Thermostat
9 Install thermostat
8.
1) Mount the thermostat on the wallplate.
2) Tighten the screw and install the coverplate.
3) Turn power back on at the heating/cooling system.
10
Owner's Manual - Page 12
... advance to switch between the two parameters.
4 For optimal heating control, use the setting that matches your system as follows: 2=30 min (steam, gravity), 3=20 min (hot water, 90%+ high-efficiency furnace), 4=15 min (gas or oil), 5=12 min (alternate setting for gas or oil), 6=10 min (electric).
5 The corresponding cooling cycle lengths are...
Owner's Manual - Page 13
Guide d'installation rapide
RTH2310
Thermostat programmable 69-2214EF-04
Similar Questions
Can't Get The Temperature On A Honeywell Thermostat Rth5100b To Go Below 70
(Posted by cbgigio1 9 years ago)
Video Of How To Set A Honeywell Thermostat Rth2310b
(Posted by karaSnie 10 years ago)
How To Lower The Temperature On A Honeywell Thermostat Th8110u1003
(Posted by sofroxo 10 years ago)
The Temperature Is Set To A Fixed Temperature But Thermostart Keeps On Falling
(Posted by Anonymous-47443 12 years ago)