Garmin echoMAP 50s Support Question
Garmin echoMAP 50s Support Question
Find answers below for this question about Garmin echoMAP 50s.Need a Garmin echoMAP 50s manual? We have 10 online manuals for this item!
Question posted by christianiversen on May 29th, 2016
Gpsmap50-500, The Unit Will Not Start Up At All( Sudden Problem)
The unit will not go further than to ;reading card: or just shoving the softvare version 3.80furthermore it will not shut of by the start/shut contact.All connections and memory card has been checked ,without any results!!This problem is new,as the unit worked quite well the day before!!
Current Answers
Related Garmin echoMAP 50s Manual Pages
Flush Mount Kit Instructions (multilingual) - Page 1
...Check that all cables reach the unit mounting location. • Always wear safety goggles and a dust mask when drilling, cutting, or sanding. EN
Installing the Flush Mount Kit
Use this kit to flush mount a GPSMAP 500 series unit into the unit... correctly, it will snap into place within the unit housing.
• Connect the wiring harness, GPS antenna, and XM antenna (if applicable) to begin...
Quick Reference Guide - Page 2
...the map pointer ( ) to
make the last turn on the unit, the GPS receiver must collect satellite data and establish the current location. Select...Navigation Chart
Use the Rocker to start the new route. Select MENU to edit.
3. Turning the Unit On and Acquiring a Signal
See... > Tracks > On. The track memory is complete. 5. the current track continues to manually adjust the backlight. or its...
Important Safety and Product Information - Page 2
... video input capability. In some inaccurate or incomplete data. Cleaning the Screen The unit's lens is coated with Industry Canada Standard RSS-210. Category I radiocommunication devices ... notices to mariners contain all available navigation sources, including information from visual sightings, local waterway rules and restrictions, and maps. Battery Warnings Your GPS unit may damage ...
Installation Instructions - Page 8
Contact your GPSMAP 400/500 series chartplotter is NMEA 2000-compatible, you added to connect the chartplotter.
You will need to extend the NMEA 2000 backbone, connect an appropriate NMEA 2000 backbone extension cable (not included) to the NMEA 2000 backbone.
4. NMEA 2000-compatible
GPSMAP 400/500 series
chartplotter
NMEA 2000 device
(not included)
T-connector (not...
Installation Instructions - Page 10
... Approximately 1 second Cold**: Approximately 38 seconds
*Warm: your unit has moved by more than about 500 mi. (800 km) since it extends another 1/8 in ....channel WAAS-capable receiver. If the sonar signal suddenly is lost or the bottom return is severely ... the depth of the sonar. Temp. Update Rate: 1/second, continuous
GPS Accuracy: Position: diagonal (10.6 cm), QVGA display with a clear ...
Installation Instructions - Page 11
... National Marine Electronics Association (NMEA) format and sentences from: NMEA Seven Riggs Avenue Severna Park, MD 21146 USA www.nmea.org
GPSMAP 400/500 Series Installation Instructions
11 Dual Beam, 400 W (RMS), 3,200 W (peak to peak)
Frequency: 50/200 kHz (dual frequency and 1 kW), 80/200 kHz (dual beam)
Depth: 2,500 ft. (762 m) (1 kW), 1,500 ft...
Owner's Manual - Page 3
... screen using the Rocker, and press the SELECT key after each item. Introduction
Quick Links
• Turning the Unit On or Off: page 2. • Acquiring GPS Satellite Signals: page 5. • Inserting and Removing SD Cards: page 56. • Restoring the Original Factory Settings: page 56. • Using the Navigation Chart: page 7. • Changing...
Owner's Manual - Page 4
...Quick Links i Declaration of Conformity (DoC iv Product Registration iv Contact Garmin iv
Getting Started 1 Unit Overview 1 Turning the Unit On or Off 2 Initializing Unit Settings 2 Adjusting the Backlight 3 Using the Keypad 4 Acquiring GPS Satellite Signals 5 Using Simulator Mode 5 Inserting and Removing SD Cards 5 Understanding the Home Screen 6
Using Charts 7 Using the Navigation...
Owner's Manual - Page 7
Unit Overview
GPSMAP 526/556
Getting Started
NMEA 2000®
Power/Data
External GPS antenna
GPSMAP 421/451/ 521/551
Power/Data
NMEA 2000
GPSMAP 400/500 Series Owner's Manual
External GPS antenna
Getting Started
POWER/ BACKLIGHT RANGE (-/+) ROCKER MARK SELECT MENU HOME
SD card slot GPSMAP 526 shown
1
Owner's Manual - Page 8
... must configure the initial settings.
Home Screen
Initializing Unit Settings
The first time you turn on the unit, press and release the Power key. NMEA Devices-if you have NMEA 0183 devices connected to view the Home screen. Getting Started
Turning the Unit On or Off
To turn on your unit, you select None for location readings.
Owner's Manual - Page 9
...for time readings.
Press left or right on the GPSMAP 526 and 556).
3 To allow the unit to automatically... adjust the backlight based on ambient light, select Auto Backlight (automatic backlight is automatically set the time zone you want to calibrate it now. Refer to your boat. Refer to your boat (page 56).
GPSMAP 400/500 Series Owner's Manual
Getting Started...
Owner's Manual - Page 10
... menus, highlight fields, and enter data. GPSMAP 400/500 Series Owner's Manual Getting Started To switch between modes.
4
Using the Keypad
POWER/... BACKLIGHT
RANGE (-/+) ROCKER MARK SELECT MENU HOME
POWER/BACKLIGHT-Press and hold to page up , down on a chart. Press left , or right to mark a waypoint. Press to turn the unit...
Owner's Manual - Page 11
...When the unit loses satellite signals, the green bars disappear and the position icon displays a flashing question mark. Getting Started
To turn on Simulator mode: 1. Use SD cards to transfer...g2 Vision® SD cards to another compatible Garmin unit or a computer (page 40). GPSMAP 400/500 Series Owner's Manual
5
Using Simulator Mode
Simulator mode turns the GPS receiver off . Any ...
Owner's Manual - Page 12
...unit and system settings (page 48).
6
GPSMAP 400/500 Series Owner's Manual Fishing charts are available only if you use a BlueChart g2 Vision SD card. Note: Mariner..., and information about other screens.
Getting Started
Note: If you use an SD card to transfer waypoints from any screen to ...version by clicking Help > Check for Software Updates, or check the Garmin Web site at www.garmin.com.
Owner's Manual - Page 18
... detail shown on the Rocker to the current track heading.
12
GPSMAP 400/500 Series Owner's Manual
Changing the Chart Appearance
From the Home screen, select Charts...marine wind sensor.
• Course Up-sets the map so the direction of navigation is always up. Press right on the map at different zoom levels.
True wind direction or apparent wind direction displays if the unit is connected...
Owner's Manual - Page 21
... exit routes in unfamiliar harbors or anchorages. Using Mariner's Eye 3D
A BlueChart g2 Vision SD card offers Mariner's Eye 3D that have been saved.
Press the Range (-) key to move the view closer to your unit must be connected to your course), and provides a visual navigation
GPSMAP 400/500 Series Owner's Manual
Using Charts
aid. This...
Owner's Manual - Page 36
...Vision data cards are connected to ...to the information on BlueChart g2 Vision-compatible Garmin GPS units. This chart works well for offshore deep-sea fishing...Mariner's Eye 3D-provides a view from the SD card to the card. You can only use the SD card on the chart.
• Fishing Charts-provides a view of the chart with a Garmin Autopilot
When you start any type of your destination (page 50...
Owner's Manual - Page 75
... Product Support if the problem persists.
Contact your dealer or Garmin Product Support. Can't Write User Card, Card May Be Full-error reading card;
Decrease the input voltage to acknowledge the message. Card Needed-Your unit needs to have an SD card inserted into the SD card slot in the Battery Alarm setup. Can't Read User Card-error reading card;
AIS: Dangerous Target-shows...
Owner's Manual - Page 77
... Exists [Track Name]-you are connected to needs a software update.
If the transducer cable is removed while the unit is full and track recording has been turned off. User Card Not Found, Please Insert Card-attempted to transfer user data without deleting old data to create memory space.
GPSMAP 400/500 Series Owner's Manual
71 This...
Technical Reference for Garmin NMEA 2000 Products - Page 28
..., and full tank) will provide a more -accurate reading than entering two calibration points (empty tank and full tank... a Garmin Chartplotter or Marine Instrument
Caution: The Garmin chartplotter or marine instrument must specify the ...GPS Speed or Water Speed to specify which speed sensor is connected to the fuel tank you want to calculate fuel economy. You should not rely solely on the unit...
Similar Questions
There Is No Map On My Echomap 50s. Everything Else Works Including Speedometer.
(Posted by dave66232 3 years ago)
How Do I Go Into Simulation Mode On A Garmin Marine Gps Modle741xs
how do I use simulation mode on a garmin 741xs marine ver
how do I use simulation mode on a garmin 741xs marine ver
(Posted by Curthupp 7 years ago)
How to get the measures in meters with echomap 50
How to set the units of measurement in meters with echomap and 50s, audible fish presence
How to set the units of measurement in meters with echomap and 50s, audible fish presence
(Posted by masillo 9 years ago)
541s Marine Gps. Depth Not Reading Out.
Depth has been working since installed. Now blank. Is there an on off control for this that may have...
Depth has been working since installed. Now blank. Is there an on off control for this that may have...
(Posted by therad50 11 years ago)