Frigidaire atf7000fe Support Question
Frigidaire atf7000fe Support Question
Find answers below for this question about Frigidaire atf7000fe - Affinity 3.5 Cu. Ft. Front Load Washer.Need a Frigidaire atf7000fe manual? We have 3 online manuals for this item!
Question posted by mmletch on January 4th, 2021
Washer Is Stopping Several Times During A Normal Wash And Does Not Always Spin O
The person who posted this question about this Frigidaire product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by Odin on January 4th, 2021 2:13 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,680
Member since:
April 10th, 2010 Points: 41,236,680
Your question was truncated, perhaps on account of your attempting to squeeze it all into the title--so I can't offer you the quality of help that I'd like. However, a good resource for issues of this kind is https://www.repairclinic.com/RepairHelp/Washing-Machine-Repair/11-2--/Frigidaire-Washing-Machine-Troubleshooting. Or use the contact information at https://www.contacthelp.com/frigidaire/customer-service..
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Frigidaire atf7000fe Manual Pages
Use and Care Guide - Page 2
...Operating Instructions included with your washer. We have every feature ...Washing Problems ...8 Care and Cleaning ...9 Avoid Service Checklist ...10 Warranty...11 Français...12-22
Assistance or Service
The symbol on the product or on its packaging indicates that this product may not be performed by a qualified installer, service agency or the gas supplier.
2
For your washer...
Use and Care Guide - Page 3
...washer is flammable; Installation instructions are packed in 1 load unless specified on the label.
- The third grounding prong must be produced in the washer... use in the washer for installer's
reference. Do not combine laundry products for use... appliance. • Failure to the wash water. These mixtures can produce dangerous ...or clothing on top of this time. • Do not store or...
Use and Care Guide - Page 4
... the drum may be more than half the total wash load. • Washing single items such as bras, shoulder pads, hosiery, and belts in this time. Permanent press, synthetic, knit and corduroy items will automatically restart after a cool down period of fiberglass left in a load. Add laundry load to washer. Load large items first. It may stick to 30...
Use and Care Guide - Page 5
... usage may be used. D. 5. Note: From time to the detergent dispenser. Note: Liquid detergent will drain into the washer drum as it into the compartment labeled "Fabric Softener" and marked with this symbol on the wash load. • Use of a fabric softener dispensing ball is part of the normal operation of the cycle. This is...
Use and Care Guide - Page 6
... odor build up and to avoid on . Do not store or place laundry products on top of washer at any utensil used. • Do not combine stain removal products, ...'s reach. • Thoroughly wash any time. Safety Door Lock
Washing Procedures Con't
6. Start the washer. (See Operating Instructions for energy efficiency. General Precautions • Do not slam the washer door closed or try to ...
Use and Care Guide - Page 7
... rub with a paste of an entire load, use on acetate fabrics. For spots, use chlorine bleach because it cannot be impossible to back of stain. LIQUID: Pretreat with bar soap. Wash using hottest water safe for fabric.
7 Soak for fabric. Wash using bleach safe for fabric. Wash using cold water and bleach safe for...
Use and Care Guide - Page 8
... a few
minutes to reduce abrasion.
•Increase water temperature using hottest water safe for sorting and preparing the wash load.
•Do not overload washer. •Use correct temperature and amount of
detergent, water and wash time. and hottest water safe for directions on fabric.
•Treat with bar soap. water and bleach safe for...
Use and Care Guide - Page 9
...Spin cycle. Do not add wash load.
9
ENGLISH Outside • When washing is visible only after storage, run WITHOUT a clothes load using detergent. Store washer in the washer when cleaning the inside of the washer...Turn water faucets off to the Max Fill level and run empty washer through a
complete cycle using the Normal Cycle setting. If door or console becomes stained, clean with ...
Use and Care Guide - Page 10
.... Stop washer and rearrange wash load.
• Electrical power cord may not be plugged in or connection may be in folds of the bellows at least 30 psi (260 kPa). If problem is a power outage, call local electric company.
• Water supply faucets are connected to allow proper spinning.
• Drain hose is normal during the spin...
Installation Instructions - Page 1
...this or any electrical switch;
P/N 134965600 (0708) This will simplify the installation and ensure the washer is installed correctly and safely.
do not use gasoline or other flammable vapors and liquid in ... ANSI/NFPA 70. WHAT TO DO IF YOU SMELL GAS · Do not try to the washer must conform with local codes and ordinances and the latest edition of life.
-
NOTE: The electrical...
Installation Instructions - Page 2
... installed within 42 inches (107 cm) of least resistance for Installation: 1. ELECTRICAL REQUIREMENTS
CIRCUIT - time delay fuse or circuit breaker. DRAIN REQUIREMENTS
1. NOTE: GFI (Ground Fault Interrupter) receptacle is properly grounded.
1. For higher standpipe, use of this washer with the National Electrical Codes, ANSI/NFPA 70 (latest edition). DO NOT cut off...
Installation Instructions - Page 4
In an area exposed to protect the floor, lay the washer on it will come in . Remove and save the styrofoam base and shipping ...or piece of the floor may be below 60 ° F
(15.6 ° C) for proper washer (detergent breakdown) operation.
2. LOCATION OF YOUR WASHER
DO NOT INSTALL YOUR WASHER: 1. In an area (garage or garage-type building) where gasoline of door. Cut the shipping ...
Installation Instructions - Page 5
... that might clog up the water valve screens.
2.
Carefully connect the other inlet hose to within 4 feet (122cm) of the water valve. Carefully move the washer to the inside "C" outlet of the final location.
6.
For free standing installation and with the pedestal. Keep the leveling leg extension at a later date, the...
Installation Instructions - Page 6
...make materials inaccessible to the standpipe, inlet hose, laundry tub, etc. Secure the drain hose with your washer, call 1-800-944-9044, or visit our ...time and
money.
APWD15W (White), APWD15GB (Glacier Blue), APWD15P (Platinum) and APWD15E (Black), specifically designed for this manual and all the Safety and Operating instructions are not meant to the washer.
Run the washer...
Data Sheet - Page 1
... time to normal ...wash water solenoids will deactivate and the loading door can be opened , the drum light should enter through the softener compartment. 5. Disconnect power to reset the control to return washer to its Envelope in high spin. CAUTION: DISCONNECT ELECTRICAL CURRENT BEFORE SERVICING Please Return This Sheet to normal...stop the cycle and turn on . 6. Wake the washer...
Data Sheet - Page 2
... test (9). E24 Drain pump relay on heater or fuse opened. E71 Wash NTC failure. (Tub heater) E74 Wash temperature does not increase. Refer to test (4). Replace the control board....time too long. E5A High temperature on inverter. E67 Input voltage on heat sink. EF5 NTC temperature for 3 seconds. Refer to test (6). E41 Control board thinks the door switch is open in spin...
Data Sheet - Page 3
...the washer and... board. Did the water fill stop coming in the air bell system... pump. Test 5:
1. Does the water stop ?
6. Correction
Yes. If problem still ...washer leaking water?
2. Test 4:
Inspect the wiring between the pressure sensor and the control board. Remove power from the washer...washer?
5.
Yes.
Yes. Good models, check the pressure switch.
Does water enter the washer...
Data Sheet - Page 4
...4 and 6 Ohms.
1. In the J2 plug on .
1. Remove the belt from the motor and spin the motor pulley. Check the wiring between ground and both heater terminals. Check the resistance of the PTC... 9:
Test 10:
Test 11: Test 12: Test 13: Test 14: Test 15:
1. Is the loading door closed?
2. Remove the door lock assembly and measuere the resistance of the heating element. Disconnect the ...
Similar Questions
Atf7000fs0 Fills, Washes, Agitates, And Drains, But Will Not Spin.
ATF7000FS0 fills, washes, agitates, and drains, but will not spin. Replaced door lock switch assembl...
ATF7000FS0 fills, washes, agitates, and drains, but will not spin. Replaced door lock switch assembl...
(Posted by flyingtiger1972 4 years ago)
Why Won't It Start?
(Posted by SCOTTDEMITRI26 9 years ago)
Affinity Washer Top Load Does Not Wash Or Spin But Does Fill And Drain
I select the cycle and it fills up, then suddenly the clock says there are 11 minutes left, it beeps...
I select the cycle and it fills up, then suddenly the clock says there are 11 minutes left, it beeps...
(Posted by fitzgerald729 9 years ago)
Normal Wash Cycle......
what is the normal time for the normal wash cycle...mine is 53 min...is that normal
what is the normal time for the normal wash cycle...mine is 53 min...is that normal
(Posted by kyref45 11 years ago)