Frigidaire atf7000fe Support Question
Frigidaire atf7000fe Support Question
Find answers below for this question about Frigidaire atf7000fe - Affinity 3.5 Cu. Ft. Front Load Washer.Need a Frigidaire atf7000fe manual? We have 3 online manuals for this item!
Question posted by SCOTTDEMITRI26 on August 19th, 2014
Why Won't It Start?
The person who posted this question about this Frigidaire product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by OnlineOutreachSpecialist on August 21st, 2014 5:37 AM
OnlineOutreachSpecialist
Member since:
March 30th, 2011 Points: 2,848,320
Member since:
March 30th, 2011 Points: 2,848,320
Hello SCOTTDEMITRI26, that’s a great question!
Let’s try resetting your Frigidaire washer (ATF7000FE) by flipping the household circuit breaker to the off position or unplugging. It is necessary to wait roughly ten minutes and then turn on your washer. Confirm that the door is securely closed and select a cycle. If resetting the power does not correct the issue, it could potentially mean a number of things: a potential wiring failure, damaged cord, faulty door latch assembly or control board. Because it could be a number of any one of several underlying causes, I would personally contact a professional to accurately diagnose your washer to determine the root cause to reduce the risk of unnecessary parts.
Online Outreach Specialist
Related Frigidaire atf7000fe Manual Pages
Use and Care Guide - Page 2
... appearing in the Use and Care Guide, Operating Instructions, Installation Instructions and on your washer are not followed. We have every feature The model and serial numbers of your appliance...; Do not touch any phone in this manual must be used when elevating the washer for your washer.
You can be caused by the manufacturer could otherwise be killed or seriously injured ...
Use and Care Guide - Page 3
...not put oily or greasy rags or clothing on top of the washer. Do not store these warnings could result in 1 load unless specified on the label.
- This will release any other ... or death. These substances give off vapors that could result in U.S.A. Do not combine laundry products for detailed grounding procedures.
If the hot water system has not been used for ...
Use and Care Guide - Page 4
... which could result in this
Owner's Guide. See Stain Removal for details.
4. The door should not be washed together. Turning the controls to the washer: - Sort laundry into loads that can be tightly packed. Important Safety Instructions (continued)
• To prevent serious personal injury and damage to the OFF position does not disconnect...
Use and Care Guide - Page 5
...may be used. Fill to the maximum fill line (MAX.) for front-loading washers to time you may see water in stained clothes. • Do not ...AND CLOSING THE DISPENSER DRAWER • Slowly open the dispenser drawer. • After adding laundry products, slowly close the dispenser drawer. DETERGENT • Detergentisflushedfromthedispenseratthebeginning of liquid chlorine bleach (not to...
Use and Care Guide - Page 6
...door open when DOOR LOCK light is completed.
Do not store or place laundry products on an inside the washer.
Select the cycle, temperature, spin speed, options and features according to ...of each load. Dangerous fumes may develop in items left in automatic dryer, line dry, or dry flat as toilet cleaners, rust removers, acid or products containing ammonia. Start the washer. (See ...
Use and Care Guide - Page 7
... is dry, it may be impossible to remove. Scrape off excess. Use product containing enzymes to back of stain. Press with a paste of an entire load, use chlorine bleach because it cannot be permanently damaged. Scrape residue from fabric.
Place stain face down on paper towels. For discoloration of granular detergent...
Use and Care Guide - Page 8
..., harsh fabrics.
•Undissolved detergent. • Some granular detergents can
combine with hard water minerals to form a residue. •Overloading the washer.
• Rewash load.
•Use fabric softener in the washer to lubricate fibers.
•When ironing, use spray starch or fabric finish on fabric. •Check condition of
detergent, water and...
Use and Care Guide - Page 9
...left rear corner of the drawer cavity and press down firmly
on
the drum. Press START and let the washer drain for 1 minute
to prevent floor damage. Press Pause/Cancel twice, unplug electrical... will be expelled. 6. Add 1 gallon (3.8 L) nontoxic recreational vehicle (RV) antifreeze to future loads. Turn water faucets off to ensure a water tight seal. • When extremely soiled items have...
Use and Care Guide - Page 10
... objects such as necessary.
• Hot water is being used elsewhere in drum.
OPERATING Washer does not start.
• Washer is not adequate in the house. See INSTALLATION INSTRUCTIONS for removing shipping bolts and foam block.
• Wash load unevenly distributed in the house.
Water collects in drum or pump.
Warm or hot water...
Installation Instructions - Page 1
... any electrical switch; Contents
SUBJECT
Pre-Installation Requirements Electrical Requirements Grounding Requirements Water Supply Requirements Drain Requirements Rough-In Dimensions Location Of Your Washer Unpacking Installation Replacement Parts
PAGE
2 2 2 2 2 3 4 4-5 5-6 6
Installation and service must conform with local codes and ordinances and the latest edition of life.
- Installation...
Installation Instructions - Page 2
...
Drain hose attached to have a licensed electrician replace it is the owner's responsibility to the washer can be between 30 and 120 pounds per minute.
2. In situations where a two-slot ... SUPPLY - 2 wire, with 15 amp. Water pressure MUST be connected. Drain capable of this washer with power created by a path of local codes, with a licensed electrician if you of electrical ...
Installation Instructions - Page 4
...foot (1.27 cm per 30.5 cm).
In an area exposed to protect the floor, lay the washer on it will come in . IMPORTANT MINIMUM INSTALLATION CLEARANCES When installed in alcove or closet:
Sides...top and bottom of the floor may be below 60 ° F
(15.6 ° C) for proper washer (detergent breakdown) operation.
2. Remove the carton.
2. Base
Shipping Plug The ambient temperature should never be ...
Installation Instructions - Page 5
....
4.
For free standing installation and with pliers. Adjust the leveling legs so the washer is SOLID on the floor on alternate corners and sides and feel for leaks. Run..., See additional installation instructions included with pliers. POWER CORD
2 hose clips
INSTALLATION
Leveling the Washer Excessive noise and vibration can be reinstalled to the HOT and COLD water faucets tightly by ...
Installation Instructions - Page 6
... a circuit breaker/fuse box before calling for service.
12. Turn on the inside of the drain hose in washer tub) to the standpipe, inlet hose, laundry tub, etc.
Run the washer through a complete cycle. If your washer does not operate, please review the "Avoid Service Checklist" in personal injury, property damage or damage to...
Data Sheet - Page 1
...washer will deactivate and the loading door can be opened .
"Err" - cycle has been interrupted.
TO START THE TEST: • Turn the Program Knob to the start position, Spin Only. • Press Start/Pause to start.... an error has been detected. control lock is no error displayed and the washer momentarily starts then turns back off the LEDs. • Press Cancel again to enter a...
Data Sheet - Page 3
... an air leak in ?
4. Go to valve assembly for shorts. Go to enter the washer?
5. If problem still remains, replace the water inlet valve assembly. Replace the control board....continue to step (2) No. Have customer correct pressure problem. Replace water valve assembly.
Start the washer and check for blockage. Replace the pressure sensor. Test Test 1:
Check 1. Is the ...
Data Sheet - Page 4
... board. If the reading is not corrected, replace the speed control board. Yes.
If the readings are disconnected.
1. No, replace the heater assembly. Is the loading door closed?
2. Spin the tub pulley.
Yes. Shorted or open when the heater terminals are incorrect, replace the motor. Yes. Replace the water inlet valve...
Similar Questions
What Is The Cu Ft Size Of My Washer
i am tying o find out the cu ft size of my washer dryer
i am tying o find out the cu ft size of my washer dryer
(Posted by kookiaz2 9 years ago)
Frigidaire Affinity Front Load Washer Atf8000fs1 Does Not Start
(Posted by puzahhs 10 years ago)
How To Fix Error Code E68
(Posted by Meyerbillmiller 10 years ago)
What Fsthe Cu Ft Capacity For A Frig Model Atf6000fs Front Load Washing Machine?
(Posted by jeffbumgarner 11 years ago)