Home » Frigidaire » Ice Machines » Frigidaire IM115

Frigidaire IM115 Support Question

Find answers below for this question about Frigidaire IM115 - Ice Maker Kit.
Need a Frigidaire IM115 manual? We have 1 online manual for this item!

Frigidaire Overview Questions Manuals Reviews Videos Research

Question posted by Taurus176 on July 12th, 2011

Makes No Ice

originally it made ice and no water. now it makes water and no ice! I replaced filter. please help

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by OnlineOutreachSpecialist on July 13th, 2011 8:02 AM

This answer was accepted by the poster of the original question.

OnlineOutreachSpecialist

Member since:
March 30th, 2011

Points: 2,848,320

1,100
points

It is hard to diagnose the problem via internet or even phone. For something like this, you would need service technician to physically look at the unit and run the unit through tests. You may also want to contact the manufacturer for their suggestions as well.

Online Outreach Specialist

Related Frigidaire IM115 Manual Pages

User Manual - Page 1

... one. The following items will not be required to install the ice maker kit. • 1/4 inch copper supply line with shelf). Coil enough tubing at the back of 1/4" plastic is not recommended since it to a drinkable water source that is not tied into a water softening system. To Avoid Property Damage: • Copper tubing is used...

User Manual - Page 2

... Qty 1 8. Qty 2 10. Qty 1 9. Water Valve - Ice Container 3. Plastic Clamp - Qty 2 6. Qty 1 7. Steel Clamp - Leveling Bracket Screw - Water Inlet Tube - Qty 1 Tools Required: • Putty Knife • ¼ inch Socket Wrench or Nut Driver • Knife • Pliers • Needle Nose Pliers • Adjustable Wrench 2 Ice Maker 2. Qty 1 11. Use This...

User Manual - Page 3

...compressor sound baffle (A), if installed.Carefully bend condenser out away from back of refrigerator. Push water inlet tube into small hole on shelf to rear of refrigerator. 3 If refrigerator has ...freezer (some models) by pushing shelf to cabinet (B). 8. Remove ice tray rack from hole. 5. Peel off label covering ice maker hole. 7. Rotate while inserting tube until right side of shelf...

User Manual - Page 4

... fill cup. 11. DO NOT over tighten. 12. Mount ice maker onto two screws (5) you installed in one half turn with screw (6). Tighten another one hand, plug ice maker connector into connector mounted on bottom of inlet tube. Make sure connection is tight. 10. Push plastic water supply tubing (3) into freezer wall. Install adjustable leveling bracket...

User Manual - Page 5

.... Reinstall freezer shelf in lower position. Locate factory punched holes at bottom right corner of water valve. Make sure connection is tight. 20. On refrigerators with wrench. Set ice container (2) on shelf. 18. Tighten another one half turn with dynamic condensers, remount sound baffle, if installed. NOTE: Clean back of cabinet with a commercial...

User Manual - Page 6

.... 9. Then add approximately 7 feet (2.1 meters), so the refrigerator can cause death or severe personal injury, disconnect the refrigerator from electrical power before making a full tray of the refrigerator to begin producing ice. NOTE: Water line kit number 5303917950, available from the ice maker inlet valve at shutoff valve. 3. Slide brass compression nut, then ferrule (sleeve), onto...

User Manual - Page 7

...; or OFF position. Do not connect the ice maker to the water supply or whenever the water supply is turned off. • The following sounds are normal when the ice maker is operating. • Motor running • Ice loosening from a malfunctioning softener can damage the ice maker. The ice maker will then produce more ice. • Occasionally shake the container to the...