Frigidaire IM115 - Ice Maker Kit Support and Manuals
Get Help and Manuals for this Frigidaire item
View All Support Options Below
Free Frigidaire IM115 manuals!
Problems with Frigidaire IM115?
Ask a Question
Free Frigidaire IM115 manuals!
Problems with Frigidaire IM115?
Ask a Question
Most Recent Frigidaire IM115 Questions
How To Install Im-115 Kit
(Posted by shotec 9 years ago)
How To Adjust A Im501 Ice Maker
(Posted by mebsa 9 years ago)
How Long Does A New Refrigerator Take To Make 1 Batch Of Ice
(Posted by jupcha 9 years ago)
Im115 Will Not Harvest
(Posted by cassics 9 years ago)
Ice Maker Model Number Gd-21.where Is The Filter Located And How To Replace It.
(Posted by soryanth 9 years ago)
Popular Frigidaire IM115 Manual Pages
User Manual - Page 1
... to the refrigerator. The manufacturer will be responsible for any damage if plastic tubing is recommended for water leaks. If your model does not have one . To Avoid Property Damage: • Copper tubing is used for the supply line. • DO NOT install water supply tubing in a kit from your dealer to install the ice maker kit. • 1/4 inch...
User Manual - Page 2
...Use This Page to Identify Parts
1. Plastic Water Supply Tubing
4. Qty 2
6. Plastic Clamp - Water Valve - Leveling Bracket Screw - Qty 1
7. Steel Clamp - Ice Maker
2. Qty 2
10. Ice Container
3. Screws - Screws - Qty 1
9. Qty 1
11. Water Inlet Tube - Qty 1
Tools Required:
• Putty Knife • ¼ inch Socket Wrench
or Nut Driver • Knife
• Pliers...
User Manual - Page 3
... on back of refrigerator. Peel off label covering ice maker hole.
7. DO NOT remove compressor sound baffle (A), if installed.Carefully bend condenser out away from freezer (some models) by pushing shelf to rear of refrigerator and locate left until flat surface of inlet tube is tight against back of hole. 1. Unplug refrigerator from hole.
5. If refrigerator has exterior...
User Manual - Page 4
... go and finger tighten nylon compression nut onto threaded end of ice maker with a wrench. Make sure water inlet tube (11) is sitting inside fill cup.
11. Adjust leveling bracket (7) to level ice maker (1). Install adjustable leveling bracket (7) on back freezer panel. Tighten another one hand, plug ice maker connector into connector mounted on bottom of inlet tube. 9. Start...
User Manual - Page 5
Connect wiring harness to drive the two self drilling screws (4) through cabinet liner. On refrigerators with wrench. Push plastic water supply tubing into cabinet.
19. Tighten another one half turn with dynamic condensers, remount sound baffle, if installed. Use a power drill with a commercial household cleaner, ammonia or alcohol before applying clamps.
17. Secure plastic water...
User Manual - Page 6
... type shutoff valve (nonpiercing), (2) 1/4 inch brass compression nuts, (2) ferrules/sleeves, and instructions for the ice maker to malfunction. IMPORTANT: Ensure that is used for supply line. • DO NOT install water supply tubing in new plumbing lines may cause ice to the refrigerator.
Discard ice made of 1/4 inch (6.4 mm) OD, copper tubing. To Connect Water Supply Line...
User Manual - Page 7
...; Water valve opening or closing
DO NOT place the ice container in your ice quality.
To stop the ice maker, lift the wire signal arm until it clicks and locks in the “up ” or OFF position until the refrigerator is full. The ice maker will then produce more ice. • Occasionally shake the container to water that...
Frigidaire IM115 Reviews
We have not received any reviews for Frigidaire yet.