Frigidaire IM115 Support Question
Frigidaire IM115 Support Question
Find answers below for this question about Frigidaire IM115 - Ice Maker Kit.Need a Frigidaire IM115 manual? We have 1 online manual for this item!
Question posted by Taurus176 on July 12th, 2011
Ice Maker Makes No Ice But Water Works.. I Replaced The Filter.
originally it made ice and no water. now it makes water and no ice! I replaced filter. please help
Current Answers
Related Frigidaire IM115 Manual Pages
User Manual - Page 1
... not be required to install the ice maker kit. • 1/4 inch copper supply line with shut off valve are available in areas where temperatures fall below freezing. • Connect the ice maker to a drinkable water source that is not recommended since it to allow movement for the water supply line.
P/N 240394901 ICE MAKER INSTALLATION INSTRUCTIONS
To avoid electric shock...
User Manual - Page 2
...Container
3. Plastic Water Supply Tubing
4. Qty 2
6. Water Inlet Tube - Qty 1
7. Ice Maker
2. Qty 2
5. Water Valve - Screws - Leveling Bracket Qty 1
8. Plastic Clamp - Screws - Leveling Bracket Screw - Qty 2
10. Qty 1
9. Qty 1
11. Qty 1
Tools Required:
• Putty Knife • ¼ inch ...
User Manual - Page 3
... covering ice maker hole.
7. Unplug refrigerator from hole.
5. With needle nose pliers, remove foam from wall outlet.
2. Remove and save screws. If condenser is out of refrigerator. Push water inlet ...is tight against back of refrigerator and locate left condenser mounting bracket screw(s). Remove ice tray rack from freezer (some models) by pushing shelf to rear of refrigerator....
User Manual - Page 4
... go and finger tighten nylon compression nut onto threaded end of ice maker with a wrench. Mount ice maker onto two screws (5) you installed in one half turn with screw (6). DO NOT over tighten.
12. Make sure water inlet tube (11) is same at top and bottom. 9. Make sure connection is tight.
10. Tighten another one hand, plug...
User Manual - Page 5
... to rear of cabinet with factory drilled holes. Make sure connection is tight.
20. DO NOT over tighten.
16.
Align water valve bracket with a commercial household cleaner, ammonia or alcohol before applying clamps.
17. Set ice container (2) on shelf.
18. NOTE: Clean back of cabinet with dynamic condensers, remount sound baffle, if installed...
User Manual - Page 6
... shutoff valve.
• A compression nut and ferrule (sleeve) for water leaks.
To Connect Water Supply Line To Ice Maker Inlet Valve 1. Disconnect refrigerator from electrical power before making a full tray of copper tubing needed, you will not be responsible for the water supply line. Turn OFF water supply at location as it greatly increases the potential for...
User Manual - Page 7
...; The following sounds are normal when the ice maker is operating.
• Motor running • Ice loosening from a malfunctioning softener can damage the ice maker. Chemicals from tray • Ice dropping into ice container • Running water • Water valve opening or closing
DO NOT place the ice container in your dishwasher. • Wash ice container in its “up”...
Similar Questions
How Fast Should A Frigidaire Ice Maker Make Ice
(Posted by demowlg 10 years ago)
How To Install Ice Maker Kit Im115
(Posted by mikmDaniel 10 years ago)
Is There An Adjustment To Make The Ice Maker Make More Or Less Ice?
(Posted by cowboybrc 12 years ago)
Space Dimension Requirements For Frigidaire Complete Ice Maker Kit Im-501?
I plan to install an ice maker in a small upright freezer. I need the dimension requirements for th...
I plan to install an ice maker in a small upright freezer. I need the dimension requirements for th...
(Posted by dan1b 12 years ago)