Frigidaire IM115 Support Question
Frigidaire IM115 Support Question
Find answers below for this question about Frigidaire IM115 - Ice Maker Kit.Need a Frigidaire IM115 manual? We have 1 online manual for this item!
Question posted by dlbecker7 on October 6th, 2011
Ice Maker Im115
What does the adjustment screw on the front of the ice maker do? it is marked with a -/+ and under the white square cover.
Current Answers
Related Frigidaire IM115 Manual Pages
User Manual - Page 1
...for the supply line. • DO NOT install water supply tubing in a kit from the softener may damage the ice maker, causing it greatly increases the potential for cleaning. If your model does not... have one . Water supply tubing made of the unit to install the ice maker kit. • 1/4 inch copper supply line with shelf). The following items will not be required ...
User Manual - Page 2
... 1
Tools Required:
• Putty Knife • ¼ inch Socket Wrench
or Nut Driver • Knife
• Pliers • Needle Nose Pliers • Adjustable Wrench
2 Screws - Plastic Clamp - Water Inlet Tube - Qty 2
10. Use This Page to Identify Parts
1. Ice Maker
2. Ice Container
3. Screws - Qty 2
5. Leveling Bracket Screw - Leveling Bracket Qty 1
8. Qty 1
11.
User Manual - Page 3
1. Peel off label covering ice maker hole.
7. Remove and save screws. DO NOT remove compressor sound baffle (A), if installed.Carefully bend condenser out away from back of hole. With needle nose pliers, remove foam from inside compressor compartment (D), remove screws securing sound baffle to remove.
4. Remove freezer shelf (some models).
3. Remove plugs from hole.
5. ...
User Manual - Page 4
....
12. With ice maker in Step 12.Tighten screws. Install adjustable leveling bracket (7) on back freezer panel. Adjust leveling bracket (7) to level ice maker (1). DO NOT tighten bracket. (Bracket will go and finger tighten nylon compression nut onto threaded end of ice maker with a wrench. Make sure water inlet tube (11) is same at top and bottom. Ice maker is level...
User Manual - Page 5
Set ice container (2) on shelf.
18. Finger tighten nylon compression nut onto threaded end of rear panel. Use a power drill with a Phillips® head bit to drive the two self drilling screws .... Align water valve bracket with exterior condenser, reinstall condenser brackets and tighten down screws.
21. Secure plastic water tubing to water valve. Locate factory punched holes at...
User Manual - Page 6
...ice maker on, lower wire signal arm. (See ice maker front cover for on/off position of arm.)
IMPORTANT: It takes approximately 24 hours for installing a water supply line. Discard ice ...(2) ferrules/sleeves, and instructions for the ice maker to begin producing ice. Before Installing The Water Supply Line, You Will Need • Basic tools: adjustable wrench, flat blade screwdriver, and PhillipsTM ...
User Manual - Page 7
... your model has an adjustable freezer shelf, place the shelf so the wire signal arm will be sure the wire signal arm is in the “up ” or OFF position until the refrigerator is connected to water that water quality determines your ice quality. Do not connect the ice maker to the water...
Similar Questions
Frigidaire Ice Maker Im115 Will Not Shut Off
(Posted by dru1365 9 years ago)
What Is The Im115 Adjustment Screw For
(Posted by magazetl 10 years ago)
How Long For Ice Maker Im115 To Make Ice
(Posted by Anabeaye 10 years ago)
How To Manually Cycle Ice Maker Im115
(Posted by moeSeagu 10 years ago)
