Frigidaire FEX831FS Support Question
Frigidaire FEX831FS Support Question
Find answers below for this question about Frigidaire FEX831FS - 27" Electric Laundry Center.Need a Frigidaire FEX831FS manual? We have 4 online manuals for this item!
Question posted by heffejeep03 on December 17th, 2011
Washer Doesn't Work. Dryer Does
i have a stackable washer and dryer. both run off one 220 plug. dryer works. washer doesn't. any ideas?
Current Answers
Related Frigidaire FEX831FS Manual Pages
Installation Instructions (All Languages) - Page 2
... adapters (x2) and
(10.2 cm) exhaust duct work. This will be easily crushed and trap lint. This Laundry Center is not recommended for future reference. • The electrical service to prevent property damage, personal injury or loss of the following instructions before installing and using this dryer are not followed. These conditions will identify the...
Installation Instructions (All Languages) - Page 3
...; See ELECTRICAL CONNECTIONS FOR A 4-WIRE SYSTEM. (Canada - 4-wire power supply cord is prohibited for washers and dryers, and DO NOT operate a washer and a dryer on dryer.)
WATER ...dryer is equipped with clothes dryers. Appliance grounded to be connected by means of 1¼ inches (3.18 cm) minimum.
3.
Grounding through a link.
ELECTRICAL REQUIREMENTS
ELECTRIC Laundry Center...
Installation Instructions (All Languages) - Page 4
...work and creating a fire hazard as well as increase drying times. Failure to the dryer.
These conditions will be exhausted outdoors. The dryer... in contact with a rigid or flexible metal duct. Plugging the system could create a fire hazard, as well as...Do not exhaust dryer into the laundry area.
The following are kept or stored.
Explosion hazard.
If your dryer. The more often...
Installation Instructions (All Languages) - Page 5
...).
7.The dryer MUST be isolated from the wall (flush to the side or down ) 3. Straight back 2.
LOCATION OF YOUR LAUNDRY CENTER
DO NOT INSTALL YOUR LAUNDRY CENTER: 1.In an area exposed to be unobstructed when a door is required. Air openings are required to dripping water or outside wall. A louvered door with rear flush installation: 1. C M)
WASHER
60...
Installation Instructions (All Languages) - Page 6
6
ROUGH-IN DIMENSIONS
16 ¼ IN. (41.27 CM)
12 ½ IN.
(31.75 CM)
VENT
9 3/8 IN. (23.81 CM)
75 ½ IN. (191.77 CM)
ELECTRICAL CONNECTION
54 5/16 IN. (137.95 CM)
43 IN. (109.22 CM)
WATER INLETS (REAR...¼ IN (104.77 CM) 29 7/16 IN (74.77 CM)
3 ¾ IN. (9.52 CM)
36 1/16IN. (91.60 CM)
27 IN. (68.58CM)
25 ¼ IN. (64.13 CM)
47"
2 ½ IN. (6.35 CM)
1 7/8 IN. (4.76 CM)
4...
Installation Instructions (All Languages) - Page 7
...
7 This provision is to be not less than twice the area of the dryer exhaust outlet.
5.Installation MUST conform to within 4 feet (1.22 m) of the washer backsheet. Using a ratchet with no obstructions. Use two or more
people to move the laundry center to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title...
Installation Instructions (All Languages) - Page 8
... and a grounding plug, the plug MUST be plugged into an appropriate outlet that is not attached, the cord can be pulled out of the laundry center and can be run with the circuit ...equipment grounding conductor MUST be cut or remove the grounding prong from the plug.
8 Canadian ELECTRIC Laundry Center
WARNING Do not use an extension cord with all codes and ordinances. A chemical reaction...
Installation Instructions (All Languages) - Page 9
... approved power
power cord. Reinstall the terminal block access cover.
9 Insert a NEMA 14-30 Type ST or SRDT, U.L.
ELECTRICAL CONNECTIONS FOR A 3-WIRE SYSTEM
ELECTRICAL CONNECTIONS FOR A 4-WIRE SYSTEM
NON-CANADIAN ELECTRIC Laundry Center
1. Install a U.L. Tighten the screw securely. Attach the remaining two power cord outer conductors to the rear panel and remove cover...
Installation Instructions (All Languages) - Page 10
... and cold faucets to the dryer cabinet.
WATER WILL SYPHON FROM THE WASHER IF THE ABOVE INSTRUCTIONS ARE NOT FOLLOWED. Turn the water on all pipe connections.
10
Access Panel Screws Connect a 1/2 inch (1.27 cm) I.D. NEVER TEST FOR GAS LEAKS WITH AN OPEN FLAME.
8.
NOTE: DO NOT connect the laundry center to prevent excessive vibration...
Installation Instructions (All Languages) - Page 11
... operation. Verify proper operation after the laundry center is located behind the dryer front access panel.
11 Maximum benefits ...can cause improper and dangerous operation. Run the washer and dryer though a cycle.
Plug the power cord into an outlet.
13...the dryer is necessary for your laundry center, contact the source where you purchased your laundry tasks. Reinstall the dryer ...
Complete Owner's Guide (English) - Page 2
... the lint screen is removed from service or discarded, remove the washer lid and dryer door to prevent accidental
entrapment. • Failure to comply with these warnings could result in accordance with these items on product labels. • Before the laundry center is blocked, damaged or missing. Fire hazard, overheating and damage to comply...
Complete Owner's Guide (English) - Page 3
...preparing the wash load.
• Read the Washer Operating Instructions for washing.
• Empty pockets...laundry load. Important Safety Instructions Con't
• To prevent personal injury or damage to the laundry center, the electrical power cord of a gas laundry center...extension cord or an adaptor plug.
• Follow package directions when using laundry products.
The amount required...
Complete Owner's Guide (English) - Page 4
...cup, put items on the wash load.
8. The washer will remain locked for 23 minutes after each load . Place washed items in automatic dryer, line dry, or dry flat as directed by lining ...the tub stops spinning. • To open the lid during a spin, push in items left ).
Add laundry load to the
desired setting. Load items evenly. • Combine large and small items in the agitator....
Complete Owner's Guide (English) - Page 6
...8226;Use nonprecipitating water softener. •Before washing, run hot water for fabric. amount of detergent.
•Do not overload washer.
•Not enough detergent.
•Add nonprecipitating ...broken threads. •Overloading the washer. •Degradation of detergent and hottest water safe for a few
minutes to 1
gallon (3.8 L) warm water in dryer.
•Load washed too long
...
Complete Owner's Guide (English) - Page 7
... removed in place.
3. See Dryer Operating Instructions card for your specific model. • Always read and follow fabric care labels and laundry product labels. Hold for better ... can cause wrinkling, shrinkage, harshness, and a build-up of static electricity, which may permanently set dryer controls (some stains. Turn cycle selector clockwise to tumble freely for operating...
Complete Owner's Guide (English) - Page 8
...overload dryer. •Use fabric softener in washer or dryer to illuminate the dryer drum during the Press Saver setting (some models.
Pilling
•Pilling is opened to reduce
static electricity....by The Soap and Detergent Association.
Lint
• Overloading.
• Overdrying causes static
electricity.
•Lint screen not clean when
cycle began.
•Lint is due to
to...
Complete Owner's Guide (English) - Page 9
... 2, and those listed below.
• Before cleaning the washer or dryer interior, unplug the electrical power cord to avoid electrical shock hazards.
• Do not use harsh, gritty or abrasive cleansers. Or, touch residue with the sticky side of the tape or label.
• Before moving the laundry center, place a strip of the door opening , and...
Complete Owner's Guide (English) - Page 10
.... If problem is probably out of balance. Plug electrical cord into a properly grounded electrical outlet. 4.
Pull out knob and let washer spin for service, review this laundry center. To remove antifreeze from hoses. 3.
If noise continues after storage, run empty washer through a
complete cycle using detergent. Move laundry center so it corrected by a qualified electrician...
Complete Owner's Guide (English) - Page 12
... more than drying on a separate circuit. Lint screen is not securely Make sure the plug fits tightly in diameter and made of the dryer feels too hot or smells hot. Electric dryer is open (gas models).
Use a dehumidifier near the dryer. See Drying Procedures .
When in place, the duct must have enough air supply to...
Operating Instructions (Operating Instructions) - Page 1
... for items of your choice. P/N 134808700 (0610) To reduce the risk of installation and electrical voltage or gas pressure can be used with a cool down , foam rubber, plastics, or...
This cycle provides up to persons, read the IMPORTANT SAFETY INSTRUCTIONS in place.
3. LAUNDRY CENTER DRYER OPERATING INSTRUCTIONS
AUTOMATIC
COOL DOWN
LESS DRY
MORE DRY
COOL DOWN
10
20
100
TIMED DRY...
Similar Questions
Washer Won't Run, Dryer Is Fine.
This started after I replaced the dryer belt.washer won't work. When turning on beeps correctly, lid...
This started after I replaced the dryer belt.washer won't work. When turning on beeps correctly, lid...
(Posted by chanton 3 years ago)
Final Spin In Front Load Washer Does Not Work
(Posted by mantearbo 9 years ago)
Washer Dryer Combo, Washer Won't Agitate, Dryer Wont Heat Up
(Posted by sakparr25 10 years ago)
Every Thing With Washer And Dryer Works But It Will Not Get Hot
(Posted by Bob4Fives 11 years ago)
Frigidaire Washer Doesn't Work On Any Cycle On Stackable Washer And Dryer. Dryer
stackable frigidaire washer stop working door lock light comes on ,no water comes out any cycle does...
stackable frigidaire washer stop working door lock light comes on ,no water comes out any cycle does...
(Posted by sadeydog 11 years ago)