Frigidaire FEX831FS Support Question
Frigidaire FEX831FS Support Question
Find answers below for this question about Frigidaire FEX831FS - 27" Electric Laundry Center.Need a Frigidaire FEX831FS manual? We have 4 online manuals for this item!
Question posted by gabrielalvarez229 on October 19th, 2019
Replaced Pump Drain
I've replaced my pump drain & it won't dria
Current Answers
Answer #1: Posted by Odin on October 19th, 2019 4:18 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
See https://isn.page.link/rYHJ. If the issue persists or if you require further advice, you'll have to consult the manufacturer: use the contact information at https://www.contacthelp.com/frigidaire/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Frigidaire FEX831FS Manual Pages
Installation Instructions (All Languages) - Page 2
... not followed. These conditions will be applied when installing, operating and maintaing any electrical switch; Always read these instructions near the Laundry Center after the Laundry Center is unpacked. do not use them for future reference. • The electrical service to the Laundry Center must conform with local codes and ordinances and the latest edition of the National...
Installation Instructions (All Languages) - Page 3
... 14-30R
GAS Laundry Center
CIRCUIT - NOTE: For installations requiring a longer drain hose, have a qualified technician install a longer hose, PIN 134049201, available from plug. ELECTRICAL REQUIREMENTS
ELECTRIC Laundry Center
NOTE: Do not...loop connectors and marked for use 4-conductor cord for washers and dryers, and DO NOT operate a washer and a dryer on dryer.)
WATER SUPPLY REQUIREMENTS
...
Installation Instructions (All Languages) - Page 4
... inches (30.5 cm) clearance between the vent hood and the ground or any concealed space of plastic duct or metal foil duct, replace it must be exhausted into the laundry area. Failure to come in contact with normal usage. Ensure the present duct is made up of a building which has a swing-out...
Installation Instructions (All Languages) - Page 5
... curtains or drapes. 3.On carpet.
C M)
WASHER
60 SQ. The unit will come in contact with...burning appliance shall be installed in the same closet as the Gas laundry center.
3.Your laundry center needs the spacearound it will be positioned about 4½ inches (.../CGA B149.
2.The gas supply line should be of 1/2 inch (1.27 cm) pipe.
3.If codes allow, flexible metal tubing may be done...
Installation Instructions (All Languages) - Page 6
6
ROUGH-IN DIMENSIONS
16 ¼ IN. (41.27 CM)
12 ½ IN.
(31.75 CM)
VENT
9 3/8 IN. (23.81 CM)
75 ½ IN. (191.77 CM)
ELECTRICAL CONNECTION
54 5/16 IN. (137.95 CM)
43 IN. (109.22 CM)
WATER INLETS (REAR)
DRAIN OUTLET (REAR)
GAS SUPPLY PIPE (REAR)
5 ¼ IN. (13.33 CM...
Installation Instructions (All Languages) - Page 7
... REMOVE THESE CLAMPS.
6. Carefully move Laundry Center.
2. CAUTION Excessive weight.
Return laundry center to begin the installation.
In Canada, the CSA Z240 is designed under ANSI Z 21.5.1for HOME USE only. Remove: (a) foam tub blocking pad. (b) tape from the center of the washer, remove the wire shipping clips securing the drain hose and power cord (if equipped...
Installation Instructions (All Languages) - Page 8
... receptacle OR aluminum wired power cord with the appliance.
WARNING A U.L. If in doubt, call a licensed electrician.
or an equipment grounding conductor MUST be purchased. Canadian ELECTRIC Laundry Center
WARNING Do not use an extension cord with a copper Wired power cord and plug (or vice versa). The proper wiring and receptacle is properly grounded...
Installation Instructions (All Languages) - Page 9
... screw.
6.
approved power
power cord. approved strain relief connector in the entry hole on the terminal block. Insert a NEMA 10-30 Type SRDT, U.L. NON-CANADIAN ELECTRIC Laundry Center
1. approved strain relief connector in the entry hole on the terminal block. Tighten the screws securing the cord restraint against the power cord.
9.
Attach the...
Installation Instructions (All Languages) - Page 10
...Carefully move the laundry center to prevent excessive vibration. Screw the front leveling legs up the water valve screens.
2. GAS CONNECTION (Gas laundry centers only)
a. An L.P.
Use a 1/2 inch (1.27 cm) to... laundry center should exist). To ensure the laundry center is resting solid on all four legs (no rocking of the washer. Cable Tie
9. Remove the panel and set the laundry center ...
Installation Instructions (All Languages) - Page 11
... and situation that nothing (such as a routine with your laundry center does not operate, please review the "Avoid Service Checklist" located in this manual and all joints.
If your laundry tasks. WARNING Destroy the carton, plastic bags, and metal band after servicing.
Run the washer and dryer though a cycle.
Cartons covered with this happens...
Complete Owner's Guide (English) - Page 2
... has a drying rack, always replace the lint screen when finished using this laundry center. Do not stack or place laundry or throw rugs against the front or back of the laundry center. • Do not spray any type of aerosol into, on or near laundry center at any electrical switch; Close supervision of the laundry center. Children might use fabric softeners...
Complete Owner's Guide (English) - Page 3
.... Important Safety Instructions Con't
• To prevent personal injury or damage to the laundry center, the electrical power cord of a gas laundry center must be washed together.
Washing Procedures
• Follow the guidelines below for preparing the wash load.
• Read the Washer Operating Instructions for extra-large loads.
• Then add 1 cup (240 ml) water...
Complete Owner's Guide (English) - Page 4
... lid. Add liquid softener to fill line on some models)
Washing Procedures (continued)
6. Replace dispenser in a load. For models without a fabric softener dispenser, follow fabric softener label directions...when the cycle is missing or damaged.
4 For your specific model controls.
9. Add laundry load to washer.
• Dry load level should not be higher than the top of agitator vanes...
Complete Owner's Guide (English) - Page 7
... Instructions for your specific model. • Always read and follow fabric care labels and laundry product labels. Close zippers, fasten hooks and Velcro®-like fasteners. Tie strings and ...freely for stains which can cause wrinkling, shrinkage, harshness, and a build-up of fire, electrical shock, or serious injury to persons or property, comply with the basic warnings listed in a...
Complete Owner's Guide (English) - Page 8
....
4. When items are slightly damp to
avoid overdrying. •Check that lint screen is clean and in washer or dryer to reduce
static electricity. •Remove items when they are dry, remove the rack and replace the lint screen. Common Drying Problems
Many drying problems involve poor cleaning results, poor soil and stain...
Complete Owner's Guide (English) - Page 9
...Remove cleanser residue before the lid is closed.
• Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock hazards.
• When extremely soiled items have been washed, a ...and replace the screen.
• Occasionally a waxy build-up in the hoses.
• Clean the cabinet with water.
• The agitator or tub may form on the laundry center....
Complete Owner's Guide (English) - Page 10
... electrical power cord, dry tub interior, and close lid. 7. If problem is probably out of defective workmanship or materials in tub or pump. To remove antifreeze from hoses. 3. The list includes common concerns that are not turned on water supply faucets.
Stop washer and check tub.
Thumping sound. Winterizing Instructions
If the laundry center is...
Complete Owner's Guide (English) - Page 11
...or brush excess dirt and sand from laundry center. Wash load too wet after a cool down period of circular holes in area.
Drain hose is overloaded. Straighten drain hose.
Fully open . Water is...water faucet.
Use less detergent. spin.
When control is being used elsewhere in washer does not Drain hose is filling. Hot water is set too low or is overheated. Water ...
Operating Instructions (Operating Instructions) - Page 1
... dryer.
This reduces wrinkling and makes items easier to tumble for items of installation and electrical voltage or gas pressure can be used with a cool down , foam rubber, plastics,... best for 5-10 minutes. Temperature Selection
Always follow directions on size and dampness of your laundry center Owner's Guide. Close the dryer door. 5. Each cycle ends with any cycle setting. ...
Operating Instructions (Operating Instructions) - Page 3
...laundry load loosely to type, size, and soil level of fire, electric shock, or injury to wash tub before operating this appliance. The washer will not agitate or spin wiht the lid open. LAUNDRY CENTER WASHER ...Whites, Colors and Delicates cycles progress through wash agitation, drain and spin with water but will fill with spray rinse, rinse agitation, and a final spin. P/N 134808700...
Similar Questions
How To Open Fix Drain Pump In Frigidaire Washer Dryer Combo
(Posted by NguRikiga 9 years ago)
Frigidaire Laundry Center Glet1031cs0 Dryer Spins But Won't Heat
(Posted by krld2diegof 10 years ago)
Manual How To Replace Dryer Belt On Laundry Center Fex831fs2
(Posted by ottorOTISM 10 years ago)
Is It Common Practice To Replace The Drain Filter On The Gleh1642fs Washer/dryer
I took apart 75%of drain pump/filter. It was clogged real bad. Was unable to get last connection off...
I took apart 75%of drain pump/filter. It was clogged real bad. Was unable to get last connection off...
(Posted by jeffhp63 11 years ago)
Replacement Hose
How do I replace the drain hose for my washer?
How do I replace the drain hose for my washer?
(Posted by victoriesarise 12 years ago)