Frigidaire FEX831FS Support Question
Frigidaire FEX831FS Support Question
Find answers below for this question about Frigidaire FEX831FS - 27" Electric Laundry Center.Need a Frigidaire FEX831FS manual? We have 4 online manuals for this item!
Question posted by ottorOTISM on November 18th, 2013
Manual How To Replace Dryer Belt On Laundry Center Fex831fs2
The person who posted this question about this Frigidaire product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Frigidaire FEX831FS Manual Pages
Installation Instructions (All Languages) - Page 2
... 4 in this manual and other appliance. PRE-INSTALLATION REQUIREMENTS
Tools and Materials Required for Installation: • Adjustable pliers. • Phillips, straight, & square bit screwdrivers. • Adjustible wrench. • Pipe wrench for gas supply (gas dryer). • LP-resistant thread tape (for future reference. • The electrical service to the Laundry Center must conform...
Installation Instructions (All Languages) - Page 3
... connectors and marked for use 4-conductor cord for washers and dryers, and DO NOT operate a washer and a dryer on dryer.)
WATER SUPPLY REQUIREMENTS
Hot and cold water faucets MUST... 14-30R
GAS Laundry Center
CIRCUIT -
For drain systems in the floor, install a siphon break kit, available from the neutral, (2) use with 30 amp. ELECTRICAL REQUIREMENTS
ELECTRIC Laundry Center
NOTE: Do not...
Installation Instructions (All Languages) - Page 4
...hood to prevent drafts and the entrance of a building. The dryer must be a minimum of plastic duct or metal foil duct, replace it with the flow of Fire - Flexible venting materials are ...that open when the dryer is shown in the chart below. Risk of air. Do not exhaust dryer into the laundry area. Do not install a clothes dryer with duct tape. When the dryer stops, the dampers ...
Installation Instructions (All Languages) - Page 5
...The laundry center may be exhausted four (4) ways with a maximum slope of 1/2 inch (1.27 cm...WASHER
60 SQ.
GAS SUPPLY REQUIREMENTS
1.Installation MUST conform with local codes, or in the same closet as the Gas laundry center.
3.Your laundry center needs the spacearound it will be installed immediately upstream of the gas supply connection to the dryer.
6.The dryer and its individual manual...
Installation Instructions (All Languages) - Page 7
... position.
4. NOTE: If the laundry center is to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24 CFR-Part 3280) or when such standard is to be exhausted outside make up air. MOBILE HOME INSTALLATION
1.Dryer MUST be not less than twice the area of the washer, remove the wire shipping...
Installation Instructions (All Languages) - Page 8
... relief is not attached, the cord can be pulled out of the laundry center and can result in the cord.
DANGER Improper connection of the equipment
grounding conductor can be purchased, allowing some slack in a risk of electrical current this manual for the length power cord to the pre-installation requirements in doubt, call...
Installation Instructions (All Languages) - Page 9
... the strain relief.
4. Attach the red and black wires from the power cord to the outer brass colored terminals on the terminal block. NON-CANADIAN ELECTRIC Laundry Center
1. Attach the green power cord ground wire to the rear panel and remove cover.
2. Tighten the screws securing the cord restraint firmly against the 4. approved...
Installation Instructions (All Languages) - Page 10
...dryer cabinet.
Place a level on a soapy water solution. Cable Tie
9. Remove the panel and set the laundry center back down to ensure the laundry center is the HOT water faucet and carefully connect the bottom inlet hose to the water valve (on the end of the washer...securing the dryer front access panel to ensure the rubber washers are off the ground. Connect a 1/2 inch (1.27 cm)...
Installation Instructions (All Languages) - Page 11
... carton, plastic bags, and metal band after servicing.
REPLACEMENT PARTS
If replacement parts are understood and practiced as boxes, clothing, etc.) obstructs the flow of air. If your laundry center does not operate, please review the "Avoid Service Checklist" located in a location near the laundry center for your laundry center, contact the source where you purchased your Owner...
Complete Owner's Guide (English) - Page 2
... a hot water system that could result in inefficient drying and possible fire. If your dryer has a drying rack, always replace the lint screen when finished using this laundry center. Your laundry center may occur. not have been previously cleaned in, soaked in your laundry center. Do not store these warnings could result in serious personal injuries. These substances...
Complete Owner's Guide (English) - Page 3
...laundry product labels.
Add a measured amount of detergent to the wash tub before operating this washer.
1. Do not mix chlorine bleach with ammonia or acids such as bras, shoulder pads, hosiery, and belts... To prevent personal injury or damage to the laundry center, the electrical power cord of a gas laundry center must be plugged into loads that can produce poisonous gas--resulting in serious...
Complete Owner's Guide (English) - Page 4
...laundry load to washer.
• Dry load level should not be higher than half the total wash load. • When washing a single heavy item, add 1 or 2 towels to balance the load.
7. If desired, add liquid fabric softener to the dispenser, following fabric softener label directions. 2. Replace...-in automatic dryer, line dry, or dry flat as directed by lining up in the washer after the ...
Complete Owner's Guide (English) - Page 7
... the Dryer Operating Instructions for stains...in washing. The dryer will fill the drum... static electricity, which may permanently set dryer controls...dryer.
• When drying large items, dry only 2 or 3 at a time. Load the dryer...Dryer Operating Instructions card for 1-2 seconds and release.
• To add or remove items when the dryer...dryer fabric softener sheet.
4. Hold for your specific model....
Complete Owner's Guide (English) - Page 8
...;Remove items when they are dry, remove the rack and replace the lint screen.
Lint
• Overloading.
• Overdrying causes static
electricity.
•Lint screen not clean when
cycle began.
•Lint is clean and in washer or dryer to reduce abrasion.
•Irreversible condition.
•Reduce load size and tumble at the end...
Complete Owner's Guide (English) - Page 9
.... Outside
• When laundering is closed.
• Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock hazards.
• Do not use harsh, gritty or abrasive cleansers. Never use any type spray cleanser when cleaning dryer interior. Or, touch residue with a mixture of lint build-up may remain on the laundry center.
Complete Owner's Guide (English) - Page 10
... is not resting on . 10
Reset circuit breaker or replace fuse.
Thumping sound. Laundry center is overloaded. Move laundry center so it corrected by a qualified electrician. Additional floor bracing may not be loose. See INSTALLATION INSTRUCTIONS for service, review this laundry center. Close washer lid
Electrical power cord may be in freezing temperatures, follow these winterizing...
Complete Owner's Guide (English) - Page 11
...slowly. WASHER -
Rearrange load to 30 minutes (if washer has not been manually turned off).
Water is set at faucet or washer. Avoid running water elsewhere while washer is....
OCCURRENCE
POSSIBLE CAUSE
WASHER -
Move indicator clockwise slightly.
Lid is filling.
Residue left in the house.
Shake or brush excess dirt and sand from laundry center.
Wash load too...
Complete Owner's Guide (English) - Page 12
... hood or exhaust duct Clean out any obstruction. Dryer is clogged with lint. Reset circuit breaker or replace fuse. Use a dehumidifier near the dryer. Follow fabric care label instructions.
12 There are 2 house fuses in dryer too long.
Make sure electrical line is not overloaded and the dryer is not open .
Gas supply valve is on...
Operating Instructions (Operating Instructions) - Page 1
... automatically at the temperature selection of installation and electrical voltage or gas pressure can be used with a cool down , foam rubber, plastics, or similarly textured, rubber-like materials.
Set Temperature control. 6.
Room temperature and humidity, type of your laundry center Owner's Guide.
P/N 134808700 (0610) Close the dryer door. 5.
To avoid fire hazard, do not...
Operating Instructions (Operating Instructions) - Page 3
... the desired cycle. P/N 134808700 (0610)
Add laundry load loosely to bleach dispenser. To stop the washer, push in detail.
1. Sort laundry into loads that can be higher than top of fire, electric shock, or injury to the desired setting. Printed in your Laundry Center Owner's Guide before adding the laundry load. If desired, add liquid bleach to...
Similar Questions
Wont Spin Or Agitate Frigidaire Laundry Center Fex831fs2
(Posted by neviaca 9 years ago)
How To Change A Dryer Belt On A Electrolux Laundry Center
(Posted by gdaliKl 9 years ago)
How Do I Install The Dryer Belt On A Removing Cover On A Frigidaire Electrolux
glet1031cs0 dryer repair
glet1031cs0 dryer repair
(Posted by mohho 9 years ago)
What Is The Washer Dryer Capacity On This Fex831fs2
What is the washer dryer capacity on this FEX831FS2 Mom's broke in 3 yrs with lite use. Can't find ...
What is the washer dryer capacity on this FEX831FS2 Mom's broke in 3 yrs with lite use. Can't find ...
(Posted by finerty 11 years ago)
Why Is My Dryer Squealing When I Already Replaced The Dryer Belt?
Glet1031cso
(Posted by dahacktown 13 years ago)