Frigidaire AEQ6000ES Support Question
Frigidaire AEQ6000ES Support Question
Find answers below for this question about Frigidaire AEQ6000ES - AffinityTM 5.8 cu. Ft. Dryer.Need a Frigidaire AEQ6000ES manual? We have 4 online manuals for this item!
Question posted by madden8990 on June 21st, 2012
Dryer Will Not Start
I turn my dryer on to only hear a hum, but it never starts. What could the problem be?
Current Answers
Related Frigidaire AEQ6000ES Manual Pages
Use and Care Manual - Page 3
...gasoline, cleaning solvents, kerosene, waxes, etc.
Keep laundry products out of an overheated situation (electric dryers only).
If the dryer is unpacked. Failure to the rubber or plastic ...hazard and assure stability during operation, the dryer must be performed by qualified service personnel.
A thermal limiter switch automatically turns off vapors that may be used near ...
Use and Care Manual - Page 4
... lbs.
If an item sheds lint, turn pockets inside . • Close the door and press Start to dry items which can cause serious injury, fire or death.
14-30R
ELECTRIC DRYERS:
DRYER
FUSED 30 AMP 120/240 V OR 120/208 V WALL
CORRECT
DRYER SERVICE
Grounding type wall receptacle
GAS DRYERS:
Do not under any appliance. Repeat...
Use and Care Manual - Page 5
...starting the dryer.
ENGLISH
Do not store or place laundry products on the lint screen from noncolorfast fabrics, clean the drum with a damp cloth and a mild liquid household cleanser.
Common Drying Problems
Many drying problems...place. The dryer must be air dried. • Use proper drying temperature. • Place fabric softener sheet on collars and cuffs. • Turn items inside ...
Use and Care Manual - Page 6
...ornaments before starting each cycle.
Drying time will not operate. Excessive wrinkling.
Remove objects from drum and restart dryer. Make sure electrical line is not overloaded and the dryer is ...length listed in the dryer circuit. See INSTALLATION INSTRUCTIONS for replacement.
Do not overload.
Thermal limiter tripped. Outside exhaust hood or exhaust duct may turn but won't heat...
Technical Data Sheet - Page 1
...If problem persists, replace electronic control. Measure resistance of thermistor. Press Pause Cancel and SELECT buttons for Qualified Technicians Only. Position cycle selector to NORMAL, temperature selector to exit test modes. Clear code, exit mode and start dryer. "dn" - Immediately after, rotate cycle selector knob 2 turns counter-clockwise to the board has occurred. Microcontroller...
Technical Data Sheet - Page 2
... for regular operation.
134682200 0512 Opening the door (press in the display.
2 turns:
Drive motor runs; c. Control thermistor reading is off . Dryer will be rotated to select the following tests:
Rotate the cycle selector knob clockwise from the starting position:
0 turns:
All LED's will flash
To EXIT test mode, press and hold the Options...
Installation Instructions - Page 2
... ft. (9.75 m)
32 ft.
(9.75 m)
24 ft. (7.31 m)
28 ft.
(8.53 m)
16 ft. (4.87 m)
MAXIMUM LENGTH
of 4" (10.2 cm) Dia. Channel-lock adjustable pliers. 3. POWER SUPPLY CORD KIT -
Ensure the present duct is installed on dryer.
branch circuit fused with a 15 amp. NEMA 10-30R NEMA 14-30R
GAS Dryer
CIRCUIT - OUTLET RECEPTACLE - Number of 90°
Turns...
Installation Instructions - Page 3
...
3 3/4" (9.5 cm)
GAS SUPPLY REQUIREMENTS
Replace copper connecting pipe that will obstruct the flow of the dryer. Set the dryer timer and temperature to the right side of the cabinet or the bottom of combustion and ventilation air. ... vertical through a roof may expose the exhaust system
to down ) and start
the dryer. 3.
The system back pressure MUST NOT be unobstructed when a door is...
Installation Instructions - Page 4
Dryer Installation Dimensions
23¾" (60.33)
Free-Standing & Under Counter
24" (60.96)
... (68.58)
35" (88.90) 34" (86.36)
2.25" (5.72)
inches (cm)
27" (68.58)
Stacked Dryer Installation Dimensions
27" (68.58)
T2T2T2T5i8839oooon..".275c(fccc1r55"hlllo(eee3""7en((aaa4774strr.r136.9odo..2k(703cf)oop63)mobec))nrsa...
Installation Instructions - Page 5
.../UL2158 - Refer to protect the floor, carefully lay the dryer on its left side and remove the foam shipping base.
2. If dryer is exhausted through the floor and area beneath the mobile home...2 and 3 for HOME USE only. Using a rug, blanket or a piece of the dryer exhaust outlet.
4. FOAM SHIPPING PAD
PACKING
5 MOBILE HOME INSTALLATION
1.
CAN/CSA C22.2 (latest editions) for other...
Installation Instructions - Page 6
... opposite of the inner door assembly and place on a soft flat surface.
7. DRYER DOOR REVERSAL INSTRUCTIONS
Be sure to the outer door assembly. Remove the two screws that....
6 Remove the screws that secure the hinge to the opposite side of the outer door.
2. Open the dryer door.
5. Remove the hinge cutout plug. Remove the two (2) hinge attachment screws and place the inner door...
Installation Instructions - Page 7
...e c u r e l y.
5. Tighten the strain relief nut securely so the strain relief does not turn.
9.
Do not use an extension cord with a copper wired power cord and plug (or vice versa).
Tighten...copper wired receptacle. For a permanently connected dryer: 1. approved 30 amp.
ELECTRICAL INSTALLATION ELECTRIC Dryer
ALL GAS Dryers
The following are specific requirements for the...
Installation Instructions - Page 8
... to 3/8 inch (1.27 cm to L.P. Apply an approved thread sealer that is resistant to the corrosive action of the legs until the dryer is resting solid on all joints.
2. Turn on all wires prior to "OFF" and wait 5 minutes before calling for the Frigidaire Company Authorized Parts Distributor nearest you purchased your...
Operating Instructions - Page 1
.... If desired, add a dryer fabric softener
sheet. Towels Select this Auto Dry cycle for more details. • To change the selection after the cycle starts, the indicator lights will blink...factory settings, press Start/Pause and Select at the selected temperature to select the cycle. The estimated Cool Down time will be remembered each
load. • Turn the Cycle Selector ...
Operating Instructions - Page 2
...dryer, have been stored in the future, select More Dry. Sanitize Your Laundry with Timed Dry Select 90 minute timed dry with no carryover of the cycle.
Note: To change a setting after the cycle starts...load will continue tumbling without heat for a cycle, the indicator will be removed any load, turn the knob. "LOC" will be displayed alternately with every cycle. "PAU" will be ...
Operating Instructions - Page 3
...
Shrink Guard
Extended Tumble
Signal Volume
*
*
* Factory setting
Available settings
*
*
*
*
*
*
*
*
** Estimated cycle duration is based on normal dryness level and factory settings. PN 134609300B (0712)
DRYER SETTINGS CHART
AVAILABLE CYCLE SETTINGS -
Similar Questions
Frigidaire Affinity Dryer Will Not Start
(Posted by nckerv606 10 years ago)
Frigidaire Affinity Dryer Just Hums Won't Spin
(Posted by tacdlenny 10 years ago)
My Dryer Is Humming And The Drum Is Not Spinning
(Posted by m3ganbrooke 10 years ago)
Dryer Hums When I Press The Start Botton But Doen't Run. What Could It Be?
(Posted by telesko2002 11 years ago)
Dryer Will Not Start.
Frigidare Dryer model AEQ600ES2 wll not turn on. All the outlets are okay but I left the dryer door ...
Frigidare Dryer model AEQ600ES2 wll not turn on. All the outlets are okay but I left the dryer door ...
(Posted by alehouse85 13 years ago)