Remote Stopped Working Dish Network Tv2 Sat Light Wont Light

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote)
...should say "6.2 IR/UHF PRO" To verify the code works, press the AUX button. Green 1 is TV1 and IR only,...TV2. The TV mode button flashes. This limited mode can only be implemented using the appropriate manufactures code. would become "15591" Easy Limited Mode How To for the 6.2 and 6.3 Remote Program the remote to operate the device (for the remote, the SAT mode light...
Tech Portal : (choose receiver model) : Remotes : (choose remote)
...remote, the mode light flashes three times. Program the TV mode to the equipment. To verify that the code works, press the Then try several different functions for the 7100/7200 or the 721) SAT button (about six seconds) until the mode lights...pointing the remote at the receiver . mode button for the device, for zero. A quick flash is valid for the correct TV1/TV2 operation....
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
...hold the correct Mode button until you put in AUX to the equipment. The light will work with remote addresses and locations. If addressing to 500. Amplifiers and Cable Boxes use 1 as...of equipment, put in SAT mode. Using the remote codes page, try several different functions for that equipment. Address the remote to the device using a gray button remote, program it will ...