Emerson Remote Won't Change Channels On Dish Dvr

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BusterDoogen on May 8th, 2014 1:42 PM

This answer was accepted by the poster of the original question.

BusterDoogen

Member since:
October 30th, 2011

Points: 28,565,397

1,100
points

1. Turn on the device that you want to set.
2. Aim the remote control at the device and press down and hold CODE SEARCH button for at least 3 seconds until the red LED lights up solid red.
3. Press the device button for the item you wish to program, e.g. TV, DVD, VCR, etc. and the LED light will blink once and then remain solid red.
4. Using the number keys, enter the 3-digit codes. You will notice that each number that you press, the LED will blink once. After you have entered the 3rd digit, the red LED will turn off indicating that the code was recognized for the device.
(NOTE: If the code entered was not compatible, the red LED will flash several times. You will then need to repeat Step 2.
5. After the red LED light has turned off. Press the ON/OFF key. If the device you are trying to program powers off, then you have found the correct code. If the device does not power off, then you will need to repeat the process again from Step 2, using another 3-digit code.

Code Search

1. Turn on the device that you want to set.
2. Aim the remote control at the device and press and hold down the CODE SEARCH button for at least 3 seconds until the red LED lights up solid red.
3. Press the device button for the item you wish to program, e.g. TV, DVD, VCR, etc. and the LED light will blink once and then remain solid red.
4. Press ON/OFF button on remote slowly and repeatedly until the device you are trying to program shuts off. (Note LED will blink once each time you press ON/OFF button)
5. Once this occurs, press ENTER button to store the code and the LED light will turn off.

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Install : Connector Color Code Chart
..., if you will not have to the channel. This is accomplished by simply changing the TV channel to 28, changing the mode of the remote to distribute audio and video from is amplified to this "new channel" button on the remote control and change channels on the TV. Channel 28) when channeling up or down on the television as...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... transmits IR signal to remote commands or changing channels on . Verify the remote is UHF only, the kit will not work in the same room as delayed or no obstructions and within 40 feet of an entertainment center. Wednesday April 22 2009 © Is this a DISH Network converter and remote? If the batteries are...
Tech Portal : Remotes : Troubleshooting
...the location where the remote is possible for the interference to cause symptoms such as delayed or no response to remote commands or changing channels on their ow Point the remote directly at the ... page, an IR-to the receiver? If the problem persists, please call 1-800-333-DISH (3474) for assistance. You have completed troubleshooting. IR interference can be causing IR interference...