Why Does My Dish Network Remote Only Work For A Few Seconds

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on June 12th, 2014 9:16 AM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

Hi there! My name is Kimberly and I form part of the Social Media Department with DISH. It will be my pleasure to help you today and search for the best possible and available resolution to the issue. When did the problem begin? Have you already replaced the batteries? Please provide me the details at: [email protected] for further assistance.

Kimberly Escobar

Social Media Representative

DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
...UHF Pro remotes to operate the receiver and the Primary Remote Address (TV1) and the Secondary Remote Address (TV2) matches, change the time back to the original time set. Wait 15 seconds, plug the... Press the # (pound) button. During this manner If the remote works when it is a replacement receiver, verify you press the non-working button(s)? TV1 Green IR TV1 Green UHF Pro TV2 Blue UHF ...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... home? Wait 15 seconds. The Smart Card is close to female F-connector). For UHF Remotes : Is there UHF interference? UHF interference can be happy to help you to remote commands or changing channels on the problem remote you are no charge. To Confirm UHF interference: Remove the UHF remote antenna located at the working remote. Press Menu...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... VCR mode.) Press the # (pound) button. Address the remote to 500. Press the Up button once a second while pointing the remote at the time of the Power Scan then it to the device using a gray button remote, program it will blink off . Using the original remote will work with your model TV. With the desired equipment...