Current Answers

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

• Tech Portal : (choose receiver model) : Install : Connector Color Code Chart
  ...     © button on the remote control and change channels on the TV. Selection of the appropriate programming source and channel number selection is generally most cases you must install ...In this output: Uses a traditional RF or coaxial type connection Can be to use the TV2 composite audio/video output. When connecting to this tuner would be connected to RG6 or ...
• Tech Portal : 722 : Errors & Troubleshooting : Remote Changes Both TV1 and TV2
  ... TV button on the front of the receiver is in the Modulator Setup screen. Remote addresses are the same, receiver is lit under Dual. Press the Record button. Remote Changes Both TV1 and TV2 Both TV1 and TV2 change to a different channel. Maintain independent remote addresses, operate the receiver in the Modulator Setup to Dual: Press the Mode...
• Tech Portal : 222k : Errors & Troubleshooting : Video Distorted (Poor Quality)
  ...connected hand tight from the receiver VIDEO output to the TV ANT or RF input. TV2 Change the TV to channel 62 or 75 based on your satellite programming on high definition display, upconverted HD content... to cycle through remaining TV video input sources. (You may need to view your DISH remote control to the wall. How To? If available, press the TV/Video button on the modulator setting...

Similar Questions