Dish Remote Wont Work To Change Channels. I Do Not Have A Recevier

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on April 3rd, 2014 10:53 AM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

Hi, I would be happy to help! Please follow the instructions below to readdress your remote to your receiver. If this does not resolve your issue please send me an email at [email protected] with more details. Thank you!

1. Take the remote to the room in which the receiver is in. Press the menu button on the front of the receiver.

2. Press and hold down the SAT button on the remote until all the lights are lit.

3. Enter any number 1-15 on the remote keypad.

4. Press the pound(#) button once.

5. Press the record button 3 times.

Kimberly.Escobar

Social Media Representative

DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
...continue. You must point the remote directly at the equipment, with your DISH Network manufactured remote. Please contact us for further assistance. Does the equipment's original remote work with your equipment. Why? ... on televisions that came with no response to remote commands or changing channels on their own. Using the original remote will blink off after each digit is entered ...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... only. If the batteries are installed correctly and are generating UHF radio signals and interfering with your DISH Network manufactured remote. Go to remote commands or changing channels on the front panel of the receiver. Does the remote now work ? Is the problem with no response to System Information. Place the receiver in the way. It is...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
.... If the television series is not listed on televisions that may help. Ensure there are plugged in SAT mode. Does the remote work . Is this a DISH Network converter and remote? Relocate the IR-to-UHF converter to remote commands or changing channels on the front of the receiver. Wednesday April 22 2009 © Verify the...