The Remote Won't Change The Channel

My remote on TV 1 will turn on and off the TV and do volume but not change the channel.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by MarkHDISH on July 16th, 2013 3:54 PM

This answer was accepted by the poster of the original question.

MarkHDISH

Member since:
January 27th, 2011

Points: 71,460

1,100
points

Hello Alexiaconner, when you press a button on the remote is the SAT or TV button lighting up at the top. If not press the SAT button and then release this and see if the channels will change. You can also reprogram the remote to the recevier by following these steps in the link. http://www.mydish.com/support/program-non-922-to-receiver?WT.svl=contentArea

Thank You

Mark Haakenson

Social Media Representative

DISH LLC

[email protected]

3 pm – 11 pm Sunday through Thursday

Mark Haakenson DISH Social Media

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : Other Remotes : EZ Remote
... scan through 9 buttons on your off -air channel. for each digit of the device code, with the number buttons. for operating equipment other buttons below to change the TV volume. EZ Remote : How To Check TV/VCR Codes HOW TO CHECK THE TV CODES Hold the antenna button until the TV turns OFF You will flash three times. Release...
Tech Portal : (choose receiver model) : How To : Setting Timers
.... On-Demand Record (Record Now) Press the Back button on the remote to go back to the last satellite TV channel watched Resume to play back of the event. Note: if the channel was successful, select OK and then Save. If on the remote to extend the end time up the receiver to make sure...
Tech Portal : 3750 : Errors & Troubleshooting
... a phone line from a low volume or mute setting in the receiver,...TV mode on the DISH remote. (TV, ANT A, PIP1, S-Video, AUX, VIDEO 2, CHAN99, AUX, VIDEO 2, etc.) Change channels on the VCR's tuner. Since audio was ordered on the channel. If the outlet is controlled by DISH Network. The receiver must be replaced. If PPV channels are red in the "On" Try to be turned...