How Do I Hook Up My Dvd Player To Either The Box Or The Tv?

I have is the three pronged colored cord, red, yellow white, I was given this link by dish

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by MaryBDish on June 29th, 2013 1:59 PM

This answer was accepted by the poster of the original question.

MaryBDish

Member since:
December 30th, 2010

Points: 627,730

1,090
points

Hi, the DVD player will need to be connected to the TV itself. Connect the RCA cables (Red/White/Yellow) from the DVD player to the TV. There should be a red/white/yellow connection on the TV itself. then you will need to cycle through the inputs to get the one for the DVD player and then back to the Satellite dish when you are done. If you have any additional questions or concerns, please email me directly. Thank you!

Mary Catherine Brady
DISH Internet Response Team
[email protected]
Tuesday-Saturday 2:45pm-11:15pm(MST)

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : HD Monitors : Install : Connectors
...DVD player. VID1 S-VIDEO Provides better picture quality than the video jacks (VID1 and 2 Video) because the color...yellow. VARIABLE AUDIO Provides variable-level audio output. Front Connectors The TV...white. VOL > Increases the volume. HD Monitor Connectors Rear Connectors DISH...Digital Visual Interface) is usually red. L/MONO (Audio) Provides ...antenna, cable, cable box, or a VCR. ...
Tech Portal : Remotes : Address to Receiver
... functions for the desired functions. ?Some combination (2-in-1) units like VCR/DVD players or TVs with built in VCRs or DVDs may be included in the owners' manual that came with a TV/DVD unit, the remote may need to program you DISH remote to Troubleshooting w/ TV/VCR/AUX How To? We have launched an interactive application specifically to...
Tech Portal : (choose receiver model) : Remotes : (choose remote) : Address to other equipment
... it does not operate a device. To verify the code works try programming code into the AUX Mode, the AUX Mode acts like VCR/DVD players or TVs with your DISH Network manufactured remote. When performing the Power Scan, periodically check that the mode light is not lit when the channel up Enter in the...